53645

Black Decker BDPC10USB Manual

4
Zoom out
Zoom in
Previous page
1/8
Next page
4
Connecting to a power source using the 12 Vdc
accessory plug (fig. A - C)
The tip of the plug is positive (+) and the side contact is
negative (-).
X Unfold the 12 Vdc accessory plug (4) from the body of
the stick to one of the 5 preset positions.
X Connect the power converter to the power source by
inserting the 12 Vdc accessory plug (4) firmly into the
accessory outlet of a vehicle or other dc power source.
X The green LED (3) will light when a good connection is
made.
X Lift the USB cover (2) to allow access to one or both of
the USB ports (1).
X Plug the USB connector from the equipment you wish to
operate into the USB port (1) and run the appliance as
normal.
Note: You can operate two USB devices simultaneously.
Warning! Do not use with positive ground electrical
systems, (i.e older vehicles).
Warning! A reverse polarity connection will result in a blown
fuse and may cause permanent damage to the power
converter.
The power converter may be used whether or not the
vehicles engine is running. However, the power converter
may not operate while the engine is starting because the
battery voltage can drop substantially during cranking.
Warning! Loose connectors may cause overheated wires
and melted insulation. Check to make sure you have not
reversed the polarity. Damage due to reversed polarity is not
covered by our guarantee.
Protective features of the power converter
Your appliance monitors the following potentially hazardous
conditions:
X Low voltage protection. This condition is not harmful
to the appliance but could damage the power source.
X The appliance will automatically shut down when the
input voltage drops to 10.5 +/- 0.5 Vdc. When the
conditions are corrected, reset the appliance by
removing and re-inserting the 12 Vdc accessory plug.
X Short circuit protection. A reverse polarity or short
circuit condition may cause external or internal fuses to
open and may cause irreversible damage to the
appliance. Take extra care to insure a correct polarity
connection.
X Overload protection. The power inverter will
automatically shut down when the continuous load
exceeds the rated wattage. When the overload is
removed, reset the appliance by removing the 12 Vdc
accessory plug and re-insert the 12 vdc accessory plug.
Hints for optimum use
For best results, the appliance should be placed on a flat
and/or solid surface. The appliance should only be used in
locations that meet the following criteria:
X DRY - Do not allow water or other liquids to come into
contact with the appliance.
X COOL - The surrounding air temperature should be
between 4°C and 40°C (39°F and 105°F). Ideally
between 15°C and 25°C (60°F and 80°F). Keep the
appliance away from direct sunlight, when possible.
X WELL VENTILATED - Keep the area surrounding the
appliance clear to ensure free air circulation.
X Do not place items on or over the appliance during
operation. The appliance will shut down if the internal
temperature gets too hot.
X SAFE - Do not use the appliance near flammable
materials or in any locations that may accumulate
flammable fumes or gases. This is an electrical
appliance that can briefly spark when electrical
connections are made or broken.
Troubleshooting
If the green LED indicator (3) is not lit:
X Check that all the dc connections are connected
correctly.
X Check the tightness of the dc connections.
Note: Make sure that your accessory outlet is live. You may
need to turn the ignition key to the accessory position.
If the red LED indicator (3) is lit, one of the following
conditions has occurred:
X Low voltage protection.
X Short circuit protection.
X Overload protection.
X Disconnect the appliance (if applicable).
Remove the 12 Vdc accessory plug, correct the fault and re-
insert the 12 vdc accessory plug.
Maintenance
Your Black & Decker tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
care and regular cleaning.
Warning! Before performing any maintenance or cleaning
on the appliance, unplug the appliance.
X From time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do
not immerse the appliance in water.
Replacing the fuse in the vehicle dc accessory plug
X Remove the cap by turning it counter clockwise.
X Remove the cap and centre pin.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Black Decker BDPC10USB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Black Decker BDPC10USB in the language / languages: English as an attachment in your email.

The manual is 0,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info