716412
10
Zoom out
Zoom in
Previous page
1/11
Next page
EN
10
www.BISSELL.com
D-4 Pump belt removal &
replacement
Occasional replacement of the pump belt
may become necessary. If needed, please
follow instructions below.
1. Follow instructions 1-6 in section D-3.
2. Remove brush belt from end of brush and
set aside. If worn or damaged, replace with
new brush belt.
3. Remove pump belt and replace it with
a new belt by pinching belt at one end to
make a large loop. Attach belt to silver
motor shaft first and then pull towards larger,
red pulley. Attach belt to red pulley.
NOTE: Spinning the red pulley a few times
will help center belt and ensure correct
assembly.
4. Reattach brush belt by installing onto
toothed pump pulley and then onto toothed
end of brush.
5. Reattach belt access door assembly
to end of brush and rotate back into place.
Replace screws.
6. Replace screw on guard wire.
NOTE: Do not over tighten screws.
If you have any questions or are having
trouble removing, replacing or reinstalling
your brush belt, please call BISSELL
Consumer Care.
To reduce the risk of electric shock, turn power
switch off and disconnect plug from electrical
outlet before performing maintenance or
troubleshooting checks.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bissel 2009 - StainPro 6 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bissel 2009 - StainPro 6 in the language / languages: English as an attachment in your email.

The manual is 3,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info