496778

Binatone X-Speaker Manual

1
Zoom out
Zoom in
Previous page
1/2
Next page
Unpacking your phone
Corded Telephone
1. Where to find it
2. Installation
1. Locating the Base unit
The Base unit should be placed on a level surface, in a position where:
the telephone line cable will reach your telephone line socket or
extension socket.
it is not close to a sink, bath or shower, or anywhere else where
it is not close to other electrical equipment - fridges, washing
machines, microwave ovens, TVs, fluorescent lights, etc.
2.
4. Plug one end of the telephone line cord into the socket in the back
5.
Lift the Handset and check for Dial tone
in the earpiece.
Always use the
telephone line
cord supplied
with your
Other telephone
line cords may
not work.
2. Installation
it might get wet.
Making a
1
Press the SPEAKERPHONE button,
2 Dial the telephone number you wish to call.
3
To end the call,press the SPEAKERPHONE
call
To answer a
call
4. Telephone Operation
In the box you will find:
x Base Unit
x Handset
x Coiled Handset cord
x Telephone li ne cord
for Base unit
x User manual
Keep the packing
materials in a safe
place in case you later
need to transport
Keep your sales (till)
receipt, which is your
guarantee.
the unit.
3. Desk/W
2. Installation
3. Wall mount installation
BE CAREFUL to check that there are no wires or pipes hidden in the wall.
Hang the base unit on the screws using the wall mount slots.
You may need to remove the telephone from the wall and tighten the screws so
cradle with the
parking hook on the cradle
arranged to fit in the
parking recess
that the cradle is securely fixed and does not wobble
. Place the Handset on the
When the phone rings;
Press the
button to
SPEAKERPHONE
answer call.
PB10
PB10 phone.
1. Number / photo memory button
2. VOL-(volume-)/STORE button
3. Speakerphone( ) button
- This flashes
when the phone is ringing
To Modular
Wall Jack
6. Ringer ON/OFF( )button
Wall mount
To place the PB10 phone on a wall,
on the wall that are
mm
centers as
.
mark two
apart to lay the fixing
points
shown below
speakerphone
volume
During a call;
Adjust the volume of the speakerphone to the
SPEAKERPHONE
volume button located at the
left and right side of the speakerphone button.
Press the SPEAKERPHONE button on the
Base unit.
Ö
The IN USE light indicator will
To end a call
turn OFF.
To adjust the
4. IN USE/RINGER( )-in Use /ringer light
the phone is on a call.
of the base unit, and plug the other end into a modular wall jack.
under the earpiece on the Handset.
high or low volume level using the
Fix two screws (7mm head screws required, not supplied)
approximately 7mm
at the marked locations,
between the wall and the screw head.
leaving
VOL-
VOL+
Listen for a dial tone.
button.
93mm
93
If you have a
Broadband line
If you connect your telephone to
insert a micro-filter between the
otherwise you may get
interference between the telephone and the broadband,
which could cause problems.
a line with a broadband
connection, you will need to
In a home with broadband, every telephone must have a micro-filter connected,
not just the one at the telephone point that your modem is connected to.
If you need more broadband micro-filters, contact your broadband supplier.
telephone and the telephone line,
TELEPHONE
1
- This is on when
for an incoming call.
5. VOL+(volume+)/PAUSE button
6
2
3
4
5
Or Visit Our Website:
WWW.binatonetelecom .com
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Binatone X-Speaker at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Binatone X-Speaker in the language / languages: English as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info