Manual Bestway 61064 Hydro-Force (page 3 of 32) (All languages)

753207

Zoom out

Zoom in

1/32

Assembling of the boat

• Spread the boat on a level and even ground.

• Inflate the air chambers with a fitting-boat-pump.

• Never use compressed air!

• Inflate only as far that after inflating one can see some folding at the welding-seams. After inflation compare the

height of the printed scale on the product with the attached scale to make sure reach the height shown in the right list.

Inflate bottom chamber and other accessories such as seat until it is stiff to the touch but NOT hard. DO NOT OVER

INFLATE.

• Take care that the boat has got the correct pressure. Pay attention to the both pressure scales on the type-plate and

on the inside of the boat. Check after inflating of the boat with the enclosed scale, if the both printed scales on the

boat are identically with the enclosed scale. As soon as both scales are identically, the boat is inflated in a correct

way. If they are not identically, regulate the air by inflating or deflating. After you have inflated all air-chambers, check

the pressure of all air chambers finally once again due to safety reason, because while inflating the other air

chambers, the pressure of the first could change again. Check the pressure from time to time, because in the sun the

pressure can grow and it must be balanced then to correct one. Use the enclosed rope and slip it through the

available grommets. Then make a strong knot (as shown on the enclosed drawing).

Note: Extended exposure to sun can shorten the lifespan of your boat. We suggest not leaving boats in direct sunlight

for more than 1 hour after use.

How to install safety rope:

Please put safety rope through rope grommets and all round holes on tow handle in turn,

to make safety rope surround each side of inflatable boat, then fasten safety rope.

Caution:

1. Safety rope must go through rope grommets and all round holes of tow handle in a

correct way.

2. Please carefully check whether safety rope is in perfect condition and fastened tightly

prior to each use.

Repairs

1. If there is a leak, spray water onto the boat surface and look for air bubbles. Soapy water works well.

2. Clean and dry the damaged area. Apply a repair patch and smooth out any air bubbles.

3. If there are bigger defects at the boat, give the boat to a special repair-shop. Changes in the technical progress are

reserved.

Storage

1. Remove the Oars from the oarlocks.

Note: Keep all accessories for future use.

2. Carefully clean the boat using a mild soap with clean water.

Note: Do not use acetone, acid, and/or alkaline solutions.

3. Use a cloth to gently dry all surfaces. Do not dry the product in direct sunlight.

Note: Also, never dry with equipment such as electric blowers. Doing so will cause damage and shorten the boat’s

life span.

4. To deflate, open the valves pushing the control stem in and rotating until the valves stay open. Deflate all the

hull chambers at the same time so the air-pressure drops together. This will prevent damage from occurring to the

boat inner structures.

5. Next deflate the floor.

6. Fold the boat from front to back to remove additional air. You can also use a pump to drain any remaining air.

7. Store in a cool, dry place and out of children’s reach.

Technical Specifications

Registration ( For US/Canada customers only )

If you need to register your boat, please have the boat Hull Identification Number and model name ready and then

visit www.bestwaycorp.com/support to obtain your Certificate of Origin, or you can send e-mail to

service@bestwaycorp.us for the Certificate of Origin.

PLEASE KEEP THIS MANUAL IN A SECURE PLACE, AND HAND IT OVER TO THE NEW OWNER WHEN YOU

SELL THE CRAFT.

Deflation

Inflation

Item

61064; 61083

61068

61110

Product Inflated Size

2.28m x 1.21m (7’6’’ x 48’’)

2.55m x 1.27m (8’4’’ x 50’’)

3.07m x 1.26m (10’1’’ x 50’’)

Deflated Size

10cm

Inflated Size

Chamber 3

11.1cm

11.3cm

Inflated Size

Chamber 2

5.4cm

Item

Inflated Size

Maximum Weight

Passenger Capacity

Inflation Pressure

61064 / 61083 61068 61110

170 kg (374 pounds)

2 adults

0.03 bar

(0.5 psi)

225 kg (495 pounds)

2 adults + 1 child

0.03 bar

(0.5 psi)

270 kg (594 pounds)

3 adults + 1 child

0.03 bar

(0.5 psi)

2.28m x 1.21m

(7'6" x 48") 2.55m x 1.27m

(8'4" x 50") 3.07m x 1.26m

(10'1" x 50")

NOTE: Drawings for illustration purpose only. Not to scale.

Inflatable seats are not included with the following boat size: 1.94m x 1.1m (76’’ x 43’’); 2.28m x 1.21m (90’’ x 48’’).

Construction of the boat

WARNING

Follow all the Safety and Operating Instructions. If you don’t follow this instructions, it may cause overturn, explode the

boat and causes to drowning.

1. Do not exceed the maximum recommended number of persons. Regardless of the number of persons on board,

the total weight of persons and equipment must never exceed the maximum recommended load. Always use the

seats / seating spaces provided.

2. When loading the craft, never exceed the maximum recommended load: Always load the craft carefully and

distribute loads appropriately to maintain design trim (approximately level). Avoid placing heavy weights high up.

NOTE: The maximum recommended load includes the weight of all persons onboard, all provisions and personal

effects, any equipment not included in the light craft mass, cargo (if any) and all consumable liquids (water, fuel,

etc.).

3. When using the boat, life saving devices such as life jackets and buoys should be pre-inspected and used at all

times.

4. Before every use, carefully inspect all boat components including air-chambers, grab ropes, oars, and air valves, to

ensure everything is in good condition and tightly secured. Please stop to repair if you find any damage.

5. Buckets, water scoops and air pumps should always be available in case of air leakage or if the boat takes on

water.

6. Passenger numbers and load weights shall by no means exceed specified capacities. Refer to the Technical

Specifications section of this manual to determine passenger numbers and load weights for your boat. Overweight

will cause overturn and drowning.

7. Inflate according the numbered air chamber and rated pressure on the boat, or it will cause overinflation and boat

explosion. Exceeding the data given on the capacity plate may cause the craft to damage, overturn and lead to

drowning.

8. Keep the boat balanced. Uneven distribution of persons or load in the boat may cause overturn the boat and

drowning.

9. When the boat is in motion, all passengers must remain seated at all times to avoid going overboard.

10. Use the boat in protected shore-zones, up to 300m (984 feet). Be careful with natural factors such as wind,

tidewaters and tidal waves. BE AWARE OF OFFSHORE WINDS AND CURRENTS.

11. Be careful when landing on the shore. Sharp and rough objects such as rocks, cement, shells, glass, etc. may

puncture the boat.

12. If one chamber is punctured when the boat is in the water, it may be necessary to fully inflate the other air chamber

to prevent the boat from sinking.

13. To avoid damage do not drag the boat on rough surfaces.

14. Don’t leave the boat exposed to sun for long periods of time, as high temperatures shall give rise to air expansion,

which can cause irreparable damage.

15. Always wear a lifejacket!

16. It is the responsibility of the owner/operator to have at least on bucket/bailer on board, secured against accidental

loss.

17. Never transport the boat in inflated condition on the car. Be aware of the potential harmful effects of liquids such as

battery acid, oil, petrol. The liquids may damage your boat.

18. Be responsible, do not neglect the safety rules, this could jeopardize your life and the lives of others.

19. Follow these instructions to avoid drowning, paralysis or other serious injuries.

20. Know how to operate a boat. Check in your local area for information and/or training as needed. Inform yourself

about local regulations and dangers related to boating and/or other water activities.

Rope Grommet

Pressure-scale

Inflatable Floor

Grab Rope

Inflatable Seat Cushion

Oar Clasp

Oarlock

Valve

Heavy Duty Handle

(Only for 61068, 61110)

Inflatable Seat Cushion

(Only for 61068,61110)

Foot Pump

(Only for

61068,61110,61083)

Oar

(Only for

61068,61110,61083)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Bestway 61064 Hydro-Force in the language / languages: All languages as an attachment in your email.

The manual is 4,87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Bestway 61064 Hydro-Force Manual

Product: