753191
7
Zoom out
Zoom in
Previous page
1/92
Next page
7
3. Remove the battery pack to expose the PCBA. To detach the battery connection wire,
press the clip on the connector and then pull it out. NOTE: Wrap the connector immediately
with insulating tape in order to avoid short circuit caused by contact of both wire terminals.
DISPOSAL
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
TROUBLESHOOTING
Problem
Robot does not capture the debris
Swivel head rotates repeatedly
Robot does not cover the entire pool
Robot moves along the pool wall
Robot stopped moving in the middle
of pool but swivel head is still turning
Robot moves slowly or does not
move at all.
Robot is stopped by suction from the
main drain of pool floor
Robot stopped by obstacle or large
creases in the pool liner.
Check to see that if there is anything obstructing the cleaner.
Remove the obstacle.
For assistance, please visit the support section on our website,
www.bestwaycorp.com.
Turn off the filtration system (as instructed in filtration manual) at
least 15 minutes before robot operation.
Follow instruction to adjust locking pin setting. Make sure that
robot’s front/back faces the pool wall at beginning.
Algae renders the pool floor slippery
which results in the robot going in circles.
Debris compartment is full or filter
cover is clogged.
Position of locking pin-is not set
properly / robot facing direction
is wrong at beginning.
Moving direction is interrupted by
water circulation generated by
filtration system
Power off the robot and inspect the hole under the swivel head to
see if the impeller is jammed by large debris. For assistance, please
visit the support section on our website, www.bestwaycorp.com.
WARNING! Make sure the robot is off before the unit is serviced.
Power off the robot and inspect the hole under the swivel head to
see if the impeller is jammed by large debris. For assistance, please
visit the support section on our website, www.bestwaycorp.com.
WARNING! Make sure the robot is off before the unit is serviced.
Possible Cause
Battery is running out Charge the robot again.
Turn off the filtration system as instructed in manual.
Clean the debris compartment
Clean the filter compartment and recharge the robot for 6 hrs
Check and remove debris from the wheel.
Follow instruction to adjust the locking pin position.
Scrub the pool bottom and robot wheels to remove the algae
Impeller is jammed
Suction mouth is clogged
Debris compartment is full
Air trapped inside the robot
Remove clogged objects from the suction mouth.
Clean both debris compartment and filter cover.
Impeller is broken
Debris compartment is full
Operation time is shorter as expected
Wheel is jammed
Position of locking pin is not set properly.
Remove clogged objects from the suction mouthSuction mouth is clogged
Impeller is jammed
Solution
The swivel head may rotate repeatedly for a few minutes once
the robot sinks to the pool bottom.
This phenomenon will stop once the air trapped inside the robot
is gradually discharged and the robot will begin to move regularly.
Clean the debris compartment. Flush the screen with water to
remove small particles. If brush is deem necessary, use a soft
brush to clean the screen gently.
Note: make sure that the filter cover is In place before next operation
1
2
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bestway 58620 Robot at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bestway 58620 Robot in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 7,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info