686844
7
Zoom out
Zoom in
Previous page
1/68
Next page
7
303021190788_58482_21x28.5cm_
Troubleshooting
Problem Possible Cause Solution
Robot does not capture debris.
Battery is low. Charge the robot again.
Impeller is jammed.
Power off the robot and visually check the hole under the debris.
If necessary, contact your dealer for further instructions.
WARNING!
Make sure the robot is powered off before
servicing the device.
Impeller is broken. Contact your dealer for replacement.
Debris compartment is full. Clean the debris compartment and lter cover.
Robot stopped moving in the middle of
pool(swivel head still turning).
Robot stopped by obstacle.
Check to see that if there is object obstructing the cleaner.
Remove the obstacle.
Robot is stopped by suction force
from main pool oor drain.
Turn off the ltration system(See instructions in manual).
Robot does not cover the entire pool /
move along the pool wall.
Debris compartment is full. Clean the debris compartment
Operation time is shorter than
expected.
Clean the lter compartment and recharge the robot again for
4.5- 5 hrs
Moving direction is interrupted by
water circulation generated
by ltration system.
Turn off the ltration system(See instructions in manual).
Wheel is jammed. Check and clean out debris from the wheel.
Locking pin position is not correct /
bumper is required.
Follow manual instructions to set up the locking pin position
properly and apply bumper.
Robot moves along the pool wall of
round pool.
Make sure the bumpers have been installed(See instructions in
manual).
Robot trapped in the narrow place of the
in-ground pool.
Not enough space for robot to change
directions.
Follow manual instructions to put bumper on both ends of robot.
Robot moves slowly. Debris compartment is full. Clean the debris compartment and lter cover.
Swivel head does not turn or turns
noticeably slowly.
Swivel head bottom is jammed.
Check and remove any debris that may be trapped under the
swivel head.
Side ap is jammed.
Check and remove any debris that hinders the movement of the
ap.
Swivel smoothing- ring is broken.
Replace with a new swivel smoothing-ring. Contact your dealer
for replacement parts.
Debris escapes from the robot.
Suction mouth’s ap (on cleaner
bottom) is broken.
Suction mouth’s ap works like a door to prevent the debris
from escaping from the debris compartment. Contact dealer for
replacement parts and instruction.
Draining lter plate is broken or not in
place.
Make sure the draining lter plate is in place and replace a new
one if necessary before next use.
Debris goes outside the lter cover. Filter cover net is damaged.
Replace with a new lter cover. Contact your dealer for
replacement parts.
Float sinks. Float is broken and water goes in.
Replace with a new oat. Contact your dealer for replacement
parts.
Robot cannot be charged / recharged.
Battery is damaged.
Contact dealer for battery replacement.
WARNING!
DO NOT open the robot and replace the battery by yourself. This
could result in severe or fatal injuries and the warranty will be
voided as a result.
Charging cable is not completely
connected with external adaptor and
robot.
Make sure that the charger cable is connected with external
adaptor and robot properly and completely.
Refer to instruction manual.
External adaptor is out of order.
Contact dealer for replacement.
WARNING!
Using the wrong external adaptor will result
in damaging the robot / battery and voiding the warranty as a
result.
7


Need help? Post your question in this forum.

Forumrules
1

Forum

bestway-58482--flowclear-aquatronix

Reset search

  • When I charge my aquaglide it is switched to the off position after a few minutes it switches it’s self on?what to do Submitted on 26-7-2022 at 12:14

    Reply Report abuse
  • L'aletta che permette al robot di girarsi si è rotta volevo sostituirla ma non trovo in internet nessuna indicazione, dove posso ordinarla?
    grazie
    trinca.eugenio@gmail.com Submitted on 2-8-2021 at 22:56

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bestway 58482 Flowclear Aquatronix at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bestway 58482 Flowclear Aquatronix in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 49,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info