556788

BEKO WMI71441 Manual

7
Zoom out
Zoom in
Previous page
1/48
Next page
EN
7
an earthed outlet protected by a fuse
of suitable capacity.
• Thesupplyanddraininghosesmust
always be securely fastened and
remain in an undamaged state.
• Fitthedraininghosetoawashbasinor
waste system securely before starting
up your machine. There may be a risk
of being scalded due to high washing
temperatures!
• Neveropenthedoororremovethe
filter while there is still water in the
drum.Otherwise,theremaybethe
risk of flooding and possible injury due
to the hot water.
• Neverforceopenthelockeddoor!
The door will be ready to open just a
few minutes after the washing cycle
comes to an end.
• Unplugthemachinewhenitisnotin
use.
• Neverwashdowntheappliancewitha
water hose! There is the risk of electric
shock! Always disconnect from the
mains by unplugging before cleaning.
• Nevertouchtheplugwithwethands.
Never unplug by pulling on the cable,
always pull out from the plug only. Do
not operate the machine if the power
cord or plug is damaged.
• Neverattempttorepairthemachine
yourself.Otherwise,youmaybe
putting yours and other’s lives in
danger.
• Formalfunctionsthatcannotbe
solved by information in the operating
manual:
Turn off the machine, unplug it, turn
off the water tap and contact an
Authorised service agent.
If there are children in your
house...
• Electricalappliancesmaybe
dangerousforthechildren.Keep
children away from the machine when
it is operating. Do not let them tamper
with the machine.
• Closethedoorwhenyouleavethe
area where the machine is located.
• Storealldetergentsinasafeplaceout
of reach of the children.
• UseChild/Keylocktopreventchildren
altering the settings
Electrical connection
Makesurethatyouhaveanearthedpower
outletsocketratedat13amps(minimum).
Attention!
If you place your machine under a
worktop, the socket must be reachable
after installation, or a separate switch
(whichcandisconnectthetwopoles)must
be used in the installation.
Connect the power cord to the appropriate
electrical socket with an equivalent current
rating indicated on the rating plate at the
front of the machine behind the kick plate.
After removing the plug from its transit
position, please insert the plug seal
to prevent water spillage entering the
machine.
Electrical requirements
Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket in a
readily accessible position.
Should the mains lead of the appliance
become damaged or need replacing at
any time, it must be replaced by a special
purpose made mains lead which can only
be obtained from a Authorised Service
Agent.
B
This appliance must be earthed
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut
off and an appropriate plug fitted.
Destroy the old plug, which is cut off as a
plug with a bare cord could cause a shock
hazard if inserted into a socket elsewhere
in the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the fuse
need to be replaced an ASTA approved
BS1362 fuse of the same rating must be
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO WMI71441 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMI71441 in the language / languages: English as an attachment in your email.

The manual is 5,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info