758142
5
Zoom out
Zoom in
Previous page
1/32
Next page
3
ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the
frequency shown in the rating plate inside the appliance corresponds to your
electricity supply.
Rating label is on the left hand side of fridge inner liner.
We recommend that this appliance is connected to the mains supply via a
suitable switched and fused socket in a readily accessible position.
WARNING: When positioning the appliance ensure the supply cord is not trapped
or damaged.
Should the mains lead of the appliance become damaged or should it need
replacing at any time, it must be replaced by a special purpose made mains lead
which can only be obtained from a BEKO
Authorised Service
Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the tted moulded plug is not suitable for your socket, then the plug should be cut
off and an appropriate plug tted. Destroy the old plug which is cut off as a plug with
bared cord could cause a shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse
need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must
be used. Do not forget to ret the fuse cover. In the event of losing the fuse cover
the plug must not be used until a replacement fuse cover has been tted. Colour of
the replacement fuse cover must be the same colour as that visible on the pin face
of the plug. Fuse covers can be obtained from a authorised service agent.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in themains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug
proceed as follows: (See diagram).
1. Connect the green-yellow or green (Earth) wire
to the terminal in the plug marked 'E' or with the
symbol or coloured green and yellow or green.
2. Connect the blue (Neutral) wire to the terminal
in the plug marked 'N' or coloured black.
3. Connect the brown (Live) wire to the terminal in
the plug marked 'L' or coloured red.
With alternative plugs a 13A fuse must be
tted either in the plug or adaptor or in the main fuse box.
If in doubt contact a qualied electrician.
WARNING: Do not locate extension sockets or charging transformers/power supplies
or Lithium-Iron battery operated products adjacent to the compressor as
they could overheat.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO BCB5050F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO BCB5050F in the language / languages: English as an attachment in your email.

The manual is 3,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info