Power consumption in off-mode 0.11 W / in left-on mode 0.11 W
Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with
respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.Water and energy consumption refer
to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data.
The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also
“Troubleshooting Guide” in your Instructions for Use).
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
** Standard Cotton programme and basis for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature.
“Spin” button (incl. “Rinse hold”)
•Every programme has a predefined spin speed.
•Press the button to set another spin speed.
•If you select spin speed “0”, the final spinning is cancelled and
the water is drained out only. However, intermediate spin
phases remain during the rinse.
•If you select “Rinse hold”, the laundry remains in the last rinse
water without progressing to the final spin cycle, to avoid
creasing and prevent colours from changing. To activate the
“Rinse hold”, press the “Spin” button repeatedly until the
“Rinse hold” symbol on the display lights up.
-The wash programme stops to “Rinse hold” when the “Rinse
hold” symbol on the display blinks; the light of “Start” button
also blinks.
-To terminate the “Rinse hold” by spinning the laundry, press
“Start” - the laundry will be spun with the default spin speed.
You can also select another spin speed with the “Spin” button
before you start the spin cycle by pressing “Start”.
-To terminate the “Rinse hold” by draining the water without
spinning, press the “Spin” button until spin speed “0” appears
on the display; then press “Start” to start the draining. Do
not leave the laundry to soak for too long in the “Rinse hodl”
(especially silk).
“Colours 15° ” button
•Saves energy used for water heating while maintaining a good
wash result.
•Supports colour maintenance when washing coloured laundry.
•Recommendable for lightly soiled laundry without stains.
•Make sure that your detergent is suitable for cold wash
temperatures.
•Not selectable for Cotton 70 - 95°C.
“Rapid” button
•Enables quicker washing by shortening the programme duration.
•Recommendable for small loads or only lightly soiled laundry.
SAVE YOUR FAVOURITE PROGRAMMES
If there is a programme setting which you use frequently, the
appliance offers the possibility to save one setting for each
programme so that it can be used again by just pushing one button.
•Select the desired programme, temperature, spin speed and
option(s), push and hold the “Favourites” button for at least
3 seconds. The lamp next to “Favourites” shortly flashes
and then lights up - the programme settings is saved.
Next time you want to use your individual programme settings,
select the programme, push the “Favourites” button and start
by pushing “Start”.
If you want to replace the saved programme setting by
another one:
•Select programme temperature, spin speed and options as
desired and then press and hold the “Favourites” button for
at least 3 seconds.The previously saved programme setting
will be replaced by the new one.
FINISH ON TIME
With this function you can postpone your programme to
complete at a later time: press the button to select in how many
hours the programme shall be finished. Thus, it allows you to
have your laundry ready at a particular time and to profit from
more favourable energy rates during the night, for example.
•Do not use liquid detergent when activating this function.
•The time until the cycle end can be selected in full hour time
segments (1 to 24 h). When you press the button, the shortest
possible time will be displayed; keep on pressing the button to
loop through all the available times. To remove it again, keep
on pressing the button until you see the value “0:00”.
•When you have selected the desired time until the cycle end,
press “Start” - the countdown will begin.
•During the countdown, you can still modify the programme
setting (select or deselect options, change spin speed etc.).
If the modifications prolong the programme duration so that
it overruns the originally set time until the cycle end, the
programme will start immediately.
•Sometimes the programme may finish before the selected
time until the cycle end has expired (e.g. for small loads).
In this case, the washing machine will tumble the laundry
regularly to keep it fresh, until the selected cycle end time
has expired. During tumbling, the display will show an
animation. The tumbling phase can be stopped at any time
either by pressing any button or by rotating the programme
selector; the animation will stop and the door will unlock in
about 1 minute as indicated on the display.
ECO MONITOR
The “Eco monitor” gives you a rough feedback about the power
consumption of the programme setting you selected. As soon as
you turn the programme selector to any programme, the “Eco
monitor” is on.
The indicator on the left is to show that the “Eco monitor”
is active. The four indicators next to it show the degree of
consumption: the less power your programme setting is
forecasted to consume, the less indicators will light up. This
depends on the programme, temperature and options selected,
and also on the size of the wash load. For that reason, the
forecasted degree of power consumption may adapt when the
washing machine detects the wash load.
PROGRAMME START
Open the tap and press the “Start” button. The indication
lamp next to the “Start” button lights up. The display shows
the remaining programme time. Due to variations in load
1.
ADD DETERGENTS, CLOSE THE LID AND
SELECT THE PROGRAMME
Add detergent as indicated an the front page and as described
in the chapter “Detergent and Additives” in your Instructions
for Use.
2. Turn the programme selector to the desired programme.
3. The temperature and spin speed indicated on the display can be
altered by pressing the “Temperature” button or the “Spin”
button. The light next to the “Start” button blinks. If you
do not start the programme soon after having made your
choice, the washing machine will switch off automatically
after about a quarter of an hour. Switch on the washing
machine again by turning the programme selector back to
„Off/O“ and then to the desired programme.
SELECT ANY DESIRED OPTION
When the combination of programme and additional option(s)
is not possible, the indication lights switch off automatically.
Unsuitable combinations of options are deselected automatically.
“Prewash” button
•Only for heavily soiled loads (for example sand, granular dirt).
Increases the cycle time by approximately 15 min.
•Do not use liquid detergent for the main wash when activating
the Prewash option.
“Intensive rinse” button
•More water is added and rinse cycle is prolonged.
•This option is particularly suitable for areas with very soft
water, washing baby linen and helping people with allergies.
“Soil level” button
•Adapts the programme duration to the soil level of your
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Bauknecht WAT 4560 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Bauknecht WAT 4560 in the language / languages: English as an attachment in your email.
The manual is 0,8 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
