627561

Bauknecht WA 8389W Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
Prewash cycle increases programme duration by approximately 15 min. Consumption values were measured in
normalized conditions in compliance with Standard IEC 60 456. The data on the “Energy Label” refer to programme
“Coloured Cotton 60 °C”. Consumption data in the home may vary with respect to the values in the table in relation to
the water supply pressure and temperature, the load and the type of wash.
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account
the household conditions applicable at that time.
** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the
pump drains the water out.
ADD DETERGENT, CLOSE THE DOOR AND SELECT THE PROGRAMME
Add the detergent as described in the chapter “Detergent and Additives” in the booklet.
1. Turn the
programme selector knob
to the desired programme.
• The remaining time display shows the duration of the chosen programme (in hours and minutes)
and the pilot lamp of the
“Start/Pause”
button is flashing.
2. The programme sequence and the predefined spin speed indication corresponding to the
selected programme lights up.
3. The recommended temperature (see the indicator) can be altered by pressing “
+
” or “
-
” button.
PRESS ANY DESIRED OPTION BUTTON(S). The pilot lamp lights up.
An audible tone sounds if the combination of programme, additional options and temperature
is not possible. Unsuitable combinations of options are deselected automatically.
“Eco Wash” button
• The duration of the wash is extended and the temperature reduced to save up to 40% of energy
maintaining good washing results.
“Rapid Wash” button
• For quick, economical washes. Ideal for minimum loads of lightly-soiled articles.
“Prewash” button
• Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases
by approximately 15 min.
“Intensive Rinse” button
• A further rinse cycle is added.
• This option is particularly suitable for areas with very soft water washing baby linen and helps
people with allergies.
“Rinse Hold” button
• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid
creasing and prevent colours from changing.
• This option is particularly recommended for the programme “Synthetics” or “Delicates”.
• This function is particularly useful if you want to postpone spinning to a later time.
Note:
The programme stops to “Rinse Hold” at the time the “Rinse Hold” button light flashes.
Terminate the “Rinse Hold” option:
• Press the “Rinse Hold” button again; the programme will terminate automatically with the final
spin cycle for the present wash programme.
• If you do not wish to spin the clothes, turn the programme selector knob to the drain programme
and press the
“Start/Pause”
button again.
“Spin Speed Reduction” button
• Every programme has an automatic predefined maximum spin speed.
• Press the button to set another spin speed.
• If the spin speed “
0
” is selected, the final spinning is cancelled. The water is drained out only.
START DELAY
The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when
electricity is cheaper.
• Press the “Start Delay” button to select the delay time by 1 to 19 hours;
• Press the
“Start/Pause”
button. The “Start Delay” light flashes until the programme starts.
• The time delay indication disappears when the programme starts and it’s replaced by the
remainng time.
• The number of hours preselected can later be reduced pressing again the “Start Delay” button.
To cancel the “Start Delay”.
• Turn the programme selector to the
“ ”
position.
• Reselect the desired programme and options and press the
“Start/Pause”
button.
PROGRAMME START
Open the tap and press the
“Start/Pause”
button. The pilot lamp of the
“Start/Pause”
button lights
up. The indicator lamps show the sequence reached in the programme. After starting the programme,
the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the
programme is finished the corresponding lamp goes out.
DOOR LOCK
During the first 15 minutes of the cotton and synthetics programmes the door can be opened for adding
further laundry. This is not possible if “Rapid Wash” is selected.
The door can be opened when the “Door Free” indication is shining.
PROGRAMME END
• The remaining time is on “0:00” and all the lights of the programme sequence indication are off.
A short audible tone sounds three times.
1. Turn the programme selector to the
“ ”
position.
2. Turn the water supply tap off.
3. Open the door and unload the machine.
CHANGE THE PROGRAMME, TEMPERATURE, OPTIONS AFTER
PROGRAMME START
1. Press the
“Start/Pause”
button to pause the programme. The light flashes.
2. Select the new programme (with temperature), any options and another spin speed if you want it.
3. Press the
“Start/Pause”
button again. The new programme continues at the same position where
the previous programme was interrupted. Do not add detergent for this programme.
TO CANCEL A PROGRAMME BEFORE THE END
1. Press the
“Start/Pause”
button to pause the programme. The light flashes.
2. Set the programme selector to “Drain”. The spin indicators show
“0”
and the remaining time
shows 2 minutes.
3. Press the
“Start/Pause”
button to start the drain programme.
Programme
Temperature
(°C)
Max. Load
(kg)
Water
(l)
Energy
(kWh)
Programme Duration*
approx.
(hour : minutes)
Cotton
95 5.0 44
**
1.60 1 : 55
Coloured Cotton
60 5.0 39 0.95 2 : 00
Coloured Cotton
40 5.0 39 0.55 1 : 45
Coloured Cotton + Rapid
30 3.0 32 0.40 0 : 50
Synthetics
60 2.5 55 0.70 1 : 30
Synthetics
40 2.5 50 0.50 1 : 15
Programme
30 3.0 35 0.40
0 : 30
Delicates
30 1.5 50 0.50 0 : 45
Wool
40 1.0 50 0.50 0 : 40
Handwash
30 1.0 35 0.40 0 : 35
Overview of consumption data
GB
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht WA 8389W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht WA 8389W in the language / languages: English as an attachment in your email.

The manual is 0,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht WA 8389W

Bauknecht WA 8389W User Manual - English - 18 pages

Bauknecht WA 8389W Quick start guide - German - 2 pages

Bauknecht WA 8389W User Manual - German - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info