331427

Bauknecht tge 5400 sw Manual

9
Zoom out
Zoom in
Previous page
1/9
Next page
21
Installation
ADJUSTMENT TO
DIFFERENT TYPES OF
GAS
If a different type of gas to the
type shown on the rating plate
and on the orange sticker
affixed to the top of the
cooktop is used, the cooktop
must be converted to work
with the new gas type. Remove
the orange sticker and affix it
to the instructions booklet,
which must be retained for the
lifetime of the appliance.
Use pressure regulators
suitable for the gas
pressures indicated in the
separate Product
Description Sheet.
1.
The gas nozzles must be
changed by After Sales
Service or a qualified
technician. Nozzles not
supplied with the
appliance must be ordered
from After Sales Service.
2.
Connect the cooktop to
the gas shut-off valve by
means of a pipe suitable
for the type of gas used, in
compliance with current
local regulations.
3.
Adjust the minimum
setting of the taps.
Note
: when liquid petroleum
gas is used (G30/G31), the
minimum gas setting screws
must be tightened as far as
they will go.
Replacing the injectors
(see table in the enclosed
Product Description Sheet)
1.
Remove grids
(A)
.
2.
Extract burners
(B)
.
3.
Using a socket spanner of
the appropriate size,
(C),
unscrew the injector to be
replaced.
4.
Replace it with the injector
suitable for the new type
of gas.
5.
Re-assemble the injector
in
(D)
.
6.
For models equipped with
a triple crown burner,
proceed as shown in figure.
•
Remove the two screws
(F)
followed by the cap
(G)
then replace both
injectors
(D)
as
previously described.
Replace the cap
(G),
ensuring the seal is
properly positioned
before attempting to
use the cooktop.
Before installing the cooktop,
remember to affix the gas
calibration plate supplied
with the injectors in such a
way that it covers the existing
information relating to gas
calibration.
Adjusting minimum
gas setting of taps
1.
To ensure that the
minimum setting is correctly
adjusted, remove knob
(E)
and proceed as follows:
•
tighten (-) to reduce the
height of the flame;
•
loosen (+) to increase the
height of the flame;
The adjustment must be
performed with the tap in
minimum gas setting position
(small flame) .
Upon completion of
adjustment, reseal using sealing
wax or an equivalent material.
2.
The primary air of the
burners does not need to
be adjusted.
3.
After the adjustment of
the minimum gas setting,
light up the burners and
turn the knobs from max.
position to min.
position to check the
stability of the flame.
4gb61591b.fm5 Page 21 Friday, April 11, 2003 12:50 PM
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht tge 5400 sw at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht tge 5400 sw in the language / languages: English as an attachment in your email.

The manual is 0,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht tge 5400 sw

Bauknecht tge 5400 sw User Manual - German - 9 pages

Bauknecht tge 5400 sw User Manual - Dutch - 9 pages

Bauknecht tge 5400 sw User Manual - French - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info