703646
2
Zoom out
Zoom in
Previous page
1/2
Next page
* Available only on certain models
TROUBLESHOOTING
What to do if... Possible reasons Solutions
The control panel is
switched o, the appliance
does not work.
There may be an appliance power supply
problem.
Check that:
there is not a power outage;
the plug is properly inserted in the socket and any bipolar power
switch is in the correct position (this enables the power supply to
the appliance);
the household electrical system protection devices are ecient;
the power cable is not damaged.
The appliance could be in On/stand by
mode.
Turn the appliance on by briey pressing the
button (see On/Stand-
by function).
The inside light does not
work.
The light may need to be replace.
Malfunction of a technical component.
Disconnect the appliance from the power supply and contact the
Technical Assistance Service if you need a replacement.
The inside light ashes. Door alarm active.
It is activated when the refrigerator
compartment door remains open for a
prolonged period of time.
To stop the alarm, close the refrigerator door.
On reopening the door, check the light works.
The temperature inside the
compartments is not low
enough.
There could be various causes (see
“Solutions”).
Check that:
the door closes properly;
the appliance is not installed near a heat source;
the set temperature is adequate;
the circulation of air through the vents at the bottom of the
appliance is not obstructed (see installation section).
There is water on the
bottom of the refrigerator
compartment.
The defrost water drain is blocked. Clean the defrosting water drain (see section “Cleaning and
Maintenance").
Excessive amount of frost in
the freezer compartment.
The door to the freezer compartment is
not closed properly.
Check that there is nothing preventing the door from closing properly.
Defrost the freezer compartment.
Make sure the appliance has been correctly installed.
The front edge of the
appliance that the door
gaskets seal against is hot.
This is not a defect. It prevents
condensation from forming.
No solution is necessary.
One or more green symbols
are ashing continuously
and it is not possible to
change the temperature
set.
Malfunction alarm.
The alarm indicates a fault in a technical
component.
Contact Technical Assistance Service.
The temperature of the
refrigerator compartment is
too cold.
The set temperature is too cold.
A large amount of fresh food may
have been placed in the freezer
compartment.
Try to set a less cold temperature.
If fresh food has been placed in the freezer compartment, wait
until it has fully frozen.
Turn o the fan (if present) following the procedure described in
the paragraph “FAN.
400011423818
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
Visiting our website docs . bauknecht . eu
Using QR Code
Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product's identication plate.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht KVIE2128 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht KVIE2128 in the language / languages: English as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht KVIE2128

Bauknecht KVIE2128 User Manual - German - 2 pages

Bauknecht KVIE2128 User Manual - Dutch - 7 pages

Bauknecht KVIE2128 User Manual - French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info