Green Intelligence Pro Fresh.
Can be used to quickly achieve optimal storage conditions in terms of the temperature
and humidity inside the appliance. The fan must also be active for it to work properly.
What to do if... Possible causes: Cures:
The control panel is switched off, the appliance does not work.
There may be an appliance power supply problem.
The appliance could be in off mode.
Make sure:
- there is not a power outage
- the plug is properly inserted in the power socket and the mains double-pole switch (if present) is in the correct position
(i.e. allows the appliance to be powered)
- the household electrical system protection devices are efficient
- the power cable is not broken.
Activate the appliance with the On/Off button
The inside light does not work. The light may need replacing.
Models with lamp: disconnect the appliance from the power supply, check the lamp and, if necessary, replace it with a
new one (see the section "Lamp or LED replacement").
Models with LED lights: contact the authorised Service Centre.
The temperature inside the compartments is not low enough. There could be various causes (see "Cures")
Make sure:
- the doors close properly
- the appliance is not installed near a heat source
- the set temperature is adequate
- the circulation of air through the vents at the bottom of the appliance is not obstructed
There is water on the bottom of the refrigerator compartment. The defrost water drain is blocked. Clean the defrost water drain hole (see the section "Appliance Maintenance and Cleaning")
The front edge of the appliance, at the door striker seal, is hot This is not a defect It prevents condensate from forming. No cure is necessary.
One or more green lights flash continuously.
Malfunction alarm
The alarm indicates a fault in a technical component.
Call the authorised Service Centre.
IGB FINDKNSGRPENLFD
Refrigerator Compartment
A. Fan and antibacterial and antiodour filter (if available)
B. Lamp or LED light (depending on the model)
C. Shelves
D. LED lights (depending on the model)
E. Special Compartment cover ("Meat & Fish" or "Zero
Degrees") (if available)
F. Special Compartment ("Meat & Fish" or "Zero
Degrees") (if available)
G. Crisper cover
H. Crisper(s)
I. Rating plate (located at side of crisper)
L. Control panel
P. Dairy compartment
Q. Door trays
R. Bottle holder (if provided)
S. Bottle shelf
Least cold zone
Intermediate zone
Coldest zone
Fruit&veg zone
Freezer Compartment
M. Top drawer or door (freezing zone)
N. Middle and bottom drawers (frozen and deep-frozen
food storage zone)
O. Ice cube tray (if provided)
Note: All shelves, door trays and racks are removable.
The ideal food storage temperatures are already factory-
set.
Before using the appliance, also carefully read the
instructions provided with it.
The characteristics, technical data and images may
vary according to the model.
5019 408 01025
Printed in Italy 12/11 - Bauknecht
®
Registered trademark/TM Trademark of Whirlpool group of companies. - © Copyright Whirlpool Europe s.r.l. 2011. All rights reserved - http://www.bauknecht.eu
Super Cooling
Press the "Super cooling temp." button for 3 seconds
before putting large amounts of fresh food in the
refrigerator compartment.
When the function is active, the yellow light is on and
the three green lights are off.
This function is automatically deactivated after 6
hours, or manually by pressing the button again for 3
seconds.
When the function is not active, the yellow light is off
and the indication of the set temperature is shown by
the green lights.
On/Off
Press to activate/deactivate the appliance.
Note: This operation does not disconnect the
appliance from the power supply
Fan (if available)
The fan is preset as ACTIVE.
The fan can be deactivated by pressing the button on the base (as
shown in the figure). If the room temperature exceeds 27°C, the
fan must be on in order to guarantee the correct preservation of
food. Deactivation of the fan enables energy consumption to be
optimised.
Refrigerator compartment temperature
The three green lights indicate the set refrigerator
compartment temperature.
A different temperature can be set using the "Super
cooling temp." button.
The following adjustments are possible:
LED's on Set temperature
High (least cold)
Medium-high
Intermediate
Medium-low
Low (coldest)
QUICK GUIDE
GB
