572375
2
Zoom out
Zoom in
Previous page
1/15
Next page
5019 496 96016
GB
Quick Reference Guide
Before using the dishwasher, read the user instructions!
(We reserve the right to make technical modifications)
GSI 5599 G IX
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
Antebacterial rinse (Sani-Rinse option)
This function executes an antibacterial rinse at the
end of the wash cycle, thereby further reducing
bacteria levels. The lamp will light up when the
function is activated. If the temperature is not
maintained during the antibacterial cycle
(e.g. if the door is opened or a power failure
occurs), the lamps will start blinking to indicate
that the antibacterial action is not guaranteed.
Half load function
Recommended when the dishwasher is not full to
save water and electricity. Press the button to
wash the top rack. Press the button to wash the
bottom rack. Press the button again to deactivate
the function. The indicator light and display show
that only one rack is selected.
WARNING:
This function remains selected until
switched off.
“Delayed start” button
The wash cycle can be programmed to start after
1-12 hours. Then press the Start button. After a
prewash the set delay will start.
Display
The display shows all the information relating to
the selected functions and the indication about all
functional failures (see table on the “Instructions
for Use” manual).
1) Reference programme for energy label in compliance with
EN 50242;
2) Programme data obtained in conformity with European standard
EN 50242. Values may vary in relation to usage, e.g.: different loads,
water temperatures - above or below 15° C - as well as water
hardness and power supply voltage, etc.
Programme ON/OFF selector knob
First press and release the selector knob to access it,
and then turn it to select the desired programme;
the dishwasher switches on.
To switch off the dishwasher when the programme
has finished, turn the selector knob to off.
Start button
Press to start the wash cycle and keep pressed until
an acoustic signal confirms the start of the wash
cycle. The display shows the approximate duration
of the wash cycle.
Note:
the light above the start button blinks during
the wash cycle.
The light stops blinking and remains alight to indicate
the cycle has ended (“End” on the display) or has
been interrupted due to a fault (“E1, E2....” on the
display).
Indicators
Options
Programme chart
Detergent
Consumption
2)
Programmes Loading instructions
A B Litres kWh Minutes
P1
Pre-Rinse cold
Crockery to be washed later. - - 6.0 0.02 15
P2
Rapid 30 min 45°C
Lightly soiled crockery with no dried-on
food.
X - 13.0 0.80 45
P3
Eco
1)
55°C
Normally soiled crockery. X - 14.0 1.05 180
P4
Normal 65°C
Normally or heavily soiled crockery. X - 17.0 1.28 90
P5
Intensive 70°C
Recommended programme for heavily
soiled crockery, especially suitable for pans
and saucepans.
X X 20.0 1.60 110
4GB96016.fm Page 1 Wednesday, September 15, 2004 5:16 PM
Black process 45.0° 100.0 LPI
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht GSI 5599-1 G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht GSI 5599-1 G in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht GSI 5599-1 G

Bauknecht GSI 5599-1 G User Manual - German - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info