GB10
After unpacking the appliance, check for any damage caused during transport. In case of problems, contact the dealer of the After-Sales Service. To avoid any
damage, it is advisable to remove the appliance from the polystyrene base only prior to installation.
PREPARATION FOR INSTALLATION
very heavy product; hood handling and installation must be carried out by at least two persons.
The minimum distance between the support surface of the cooking device and the lowest part of the hood must be at least 100 cm, regardless of the type of
cooker (electric, glass ceramic, induction or gas).
Before installation, check the distances specified in the hob manual.
If the cooking device installation instructions specify a greater distance, this distance must be taken into account.
ELECTRICAL CONNECTION
Make sure the voltage specified on the product rating plate matches the mains voltage. It is located inside the hood, visible on removing the grease filter.
Power cable (H05 VV-F type) replacement (whenever necessary) must only be carried out by qualified personnel. Contact an Authorized Service Center.
If provided with a plug, connect the appliance to a socket located in an accessible area and complying with the current regulations. If it does not have a plug
(direct connection to the power supply) or if the socket is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from
the power supply in category III overvoltage conditions, complying with the installation rules.
GENERAL RECOMMENDATIONS
Before use
Remove cardboard protection pieces, transparent film and adhesive labels from accessories.
Make sure the appliance has not been damaged during transport.
During use
Do not expose the appliance to atmospheric agents.
ATTENTION:
INSTALLATION
