469754
8
Zoom out
Zoom in
Previous page
1/8
Next page
a
:
2 1 w
:
2 1 w
:
2 1 w
:
2 1 w
:
2 1 w
w
:
2 1 w
ÿ :
:
:
2 1
:
2 1 w
2ü c 4ü c
2
ä
:]
1
a
a
,
§ ³Å
§ É
a
§
³µ a
a
a 1
§
´
© ³¯
a
# a
4ü
2ü c 4
11
What to do if...
ʑ
Water is leaking out Attach/replace the drainage hose correctly.
Tighten the screw connection of the supply hose.
ʑ
No water supply.
Detergent not dispensed.
inicio (Start/Reload) not selected?
Tap not turned on?
Filter blocked? Clean the filter apage 10.
Supply hose kinked or trapped?
ʑ
The appliance door will not
open.
Safety function active. Programme stopped? apage 4.
(without final spin) selected? apage 3, 4.
Can be opened by emergency release only? apage 9.
Door locked after the washing machine is switched off: Switch on the washing
machine and wait for 5 seconds.
ʑ
The selected programme does
not start.
inicio (Start/Reload)or b (h) (Ready in) time selected?
Washing machine door closed?
Childproof lock active? Deactivate apage 5.
ʑ
Detergent solution is not
drained.
(without final spin) selected? apage 3, 4.
Clean the detergent solution pump apage 10.
Clean the waste pipe and/or drainage hose.
ʑ
No water can be seen in the
drum.
Not a fault. Water remains inside below the visible area.
ʑ
Spin result not satisfactory.
Laundry wet/too damp.
Not a fault. Spin control system has stopped the spin cycle. Uneven distribution of
laundry.
Distribute large and small items of laundry evenly in the drum.
menos S(Reduced Ironing) selected? apage 5.
Selected speed too low? apage 5.
ʑ
Programme duration changes
suddenly during operation.
Not a fault. The program time can vary according to the distribution of laundry, with
it therefore being possible for the display panel to show adjustments in the
duration.
ʑ
Spin cycle performed several
times.
Not a fault. The balance control system has detected an imbalance and is
attempting to redress this by repeating the spin.
ʑ
Residual water in the
compartment for care products.
Not a fault: the action of the care product is not affected.
Clean the compartment if necessary apage 9.
ʑ
Odour formation in the washing
machine.
Run programme algod. (Cottons)90 °C without laundry. Use standard detergent.
ʑ
Status display 1 flashing.
Appliance has detected a
detergent overload.
Too much detergent used?
If foam is escaping from the detergent drawer: mix 1 tablespoon of fabric softener
with ½ litre of water and pour into compartment II (not with outdoor or down
fabrics).
Reduce the detergent dosage for the next wash cycle.
ʑ
Intense noise formation,
vibrations and "wandering"
during the spin cycle.
Are the appliance feet fixed?
Secure the appliance feet aInstallation instructions.
Transportation safety devices removed?
Remove transportation safety devices aInstallation instructions.
ʑ
Display panel/indicator lamps
remain turned off while the
machine is working.
Energy-saving mode apage 5.
Power cut?
Fuses triggered? Reset/change the fuse.
If the fault occurs repeatedly, call customer services.
ʑ
Programme sequence longer
than usual.
Not a fault. Unbalanced load detection system adjusts imbalance by repeatedly
distributing the laundry.
Not a fault: foam detection system active; adds an additional rinse cycle.
ʑ
Detergent residues on the
laundry.
Occasionally, phosphate-free detergents contain water-insoluble residues.
Select 2
ü(Rinse)/c(Spin) or brush out the laundry after washing.
If you cannot correct a fault yourself or if a repair is necessary:
Turn the programme selector to o (stop) and remove the mains plug from the socket.
Turn off the water supply and call customer services aInstallation instructions.
Instructions for use
en
Washing
Machine
Observe the safety instructions on
page 8!
Read these instructions and the separate
installation instructions before operating
the washing machine.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Balay 3TS883 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Balay 3TS883 in the language / languages: English as an attachment in your email.

The manual is 3,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info