469756

Balay 3TS70105T Manual

2
Zoom out
Zoom in
Previous page
1/8
Next page
7
Overview of programmes a refer to the table of consumption values on page 8 and notes on page 6.
Programmes °C max.
Type of laundry
Additional functions; information
resistentes/algod.
(cottons)
frio (cold),
40, 60, 90 °C
7 kg
Hard-wearing fabrics, heat-resistant fabrics made of cot-
ton or linen
]centrif., flot (no spin)
resistentes/algod. extra
(cottons extra)
60 °C
resistentes/algod. + prelav.
(cottons + prewash)
sintéticos (easy-care)
frio (cold),
40, 60 °C
3 kg
Easy-care fabrics made of cotton, linen, synthetic fibres
or blended fabrics
]centrif., flot (no spin)
delicado (delicates) frio (cold)
2 kg
For delicate, washable fabrics, e.g. made of silk, satin,
synthetic fibres or blended fabrics (e.g. curtains)
]centrif., flot (no spin);
No spin between rinse cycles
ÿ lana/lã (wool) frio (cold), 30 °C
Handä or machine-washable fabrics made of wool or con-
taining wool
Particularly gentle wash programme to prevent
shrinkage of laundry. Longer programme breaks (fab-
rics rest in the detergent solution)
Additional programmes 5 plus (rinse), (spin), 4 plus (empty)
Programmes without prewash - add detergent to compartment II, programmes with prewash - distribute the detergent between compartments I and II
(
depending on model).
0311 / 9000658854
*658854*
3TS70121A ...
Balay Electrogeräte GmbH
CarläWery Str. 34
81739 Munich / Alemania
8
Safety instructions
– Read the instruction manual and installation instructions and all other information enclosed
with the washing machine and act accordingly.
– Retain the documents for subsequent use.
Risk of electric shock – Never pull the cable to disconnect the mains plug.
– Never insert/disconnect the mains plug with damp hands.
Danger to life For worn-out appliances:
– Disconnect the mains plug.
– Sever the mains cable and discard along with the plug.
– Destroy the lock on the washing machine door. This will prevent
children from locking themselves in and risking their lives.
Danger of suffocation – Keep packaging, film and packaging parts out of the reach of
children.
Risk of poisoning – Keep detergents and care products out of the reach of children.
Risk of explosion – Items of laundry pretreated with cleaning agents containing
solvents, e.g. stain remover/cleaning solvent may cause an
explosion after being loaded into the washing machine.
Rinse items of laundry thoroughly by hand beforehand.
Risk of injury – The washing machine door can become very hot.
– Be careful when draining hot detergent solution.
– Do not climb onto the washing machine.
– Do not lean on the open washing machine door.
– Do not reach into the drum if it is still rotating.
– Be careful when opening the detergent drawer while the machine
is in operation.
Consumption values depending on model
Programme Load Electricity*** Water***
Programme
duration
***
resistentes/algod. (cottons) 40 °C* 7 kg 0,85 kWh 65 l 02:25 h
resistentes/algod. (cottons) 60 °C* 7 kg 1,40 kWh 65 l 02:40 h
resistentes/algod. (cottons) 90 °C 7 kg 2,10 kWh 70 l 02:40 h
sintéticos (easy-care) 40 °C* 3 kg 0,55 kWh 48 l 01:15 h
delicado (delicates) frío (cold) 2 kg 0,28 kWh 48 l 00:44 h
ÿ lana/lã (wool) 30 °C 2 kg 0,20 kWh 32 l 00:53 h
* Programme setting for testing in accordance with valid standard EN60456.
Note on comparative tests: For testing the test programmes, wash the specified load using the maximum spin speed
(
depending on model).
Programme Load
Annual energy
consumption
Annual water
consumption
resistentes/algod. (cottons) 40 °C** /
resistentes/algod. extra (cottons extra) 60 °C**
7/3kg 219 kWh 10900 l
** Programme setting for testing and energy labelling in accordance with EU directive 2010/30/EU with cold water (15 ºC).
*** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient tem-
perature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected additional
functions.
9
Care
Before washing for the first time
Do not load any laundry into the machine. Turn on the tap. Add the following to
compartment II:
– approx. 1 litre water
– detergent (dosage according to the manufacturer's instructions for light soiling and the
appropriate degree of water hardness)
Set the programme selector to sintéticos (easy-care) 60 °C and select inicio (start). At
the end of the programme, turn the programme selector to stop (off).
Machine housing, control panel
– Wipe with a soft, damp cloth.
– Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners).
– Remove detergent and cleaning agent residue immediately.
– Do not clean with a jet of water.
Cleaning the detergent drawer...
...if it contains detergent or fabric softener residues.
1. Pull out, press insert down, remove draw completely.
2. To remove the insert: press the insert upwards from below with your
finger.
3. Clean the detergent dispenser tray and insert with water and a brush and
dry it.
4. Attach the insert and engage (connect the cylinder to the guide pin).
5. Push in the detergent drawer.
Leave the detergent drawer open so that any residual water can
evaporate.
Drum
Leave the washing machine door open so that the drum can dry out.
Rust stains - use chlorine-free cleaning agent, not steel wool.
Descaling Ensure there is no laundry in the machine
Descale the appliance according to the descaler manufacturer's instructions. This should not
be necessary if the correct dosage of detergent is used.
Information to indicator lights
Indicator lights for status displays and/or buttons flash:
Indicator lights
c(rinse) and
þü(wash) flash
Close the washing machine door properly; laundry may be caught.
Indicator lights
c(spin) and
þü(wash) flash
Open the tap completely, supply hose kinked or trapped;
Clean the filter a page 10, Water pressure too low.
Indicator lights
c(spin) and
c(rinse) flash
Detergent solution pump blocked; Clean the detergent solution pump
a page 10.
Drainage hose/waste pipe blocked; Clean the drainage hose at the
siphon a page 10.
Indicator light
c(rinse) flashes
Motor fault. Call the after-sales service.
All indicator lights flash Turn off the tap and call the after-sales service.
– Risk of electric shock. Disconnect the mains plug.
– Risk of explosion. No solvents.
10
Maintenance
Detergent solution pump
Turn the programme selector to stop (off) and disconnect the mains plug.
1. Open and remove the service flap.
2. For models with a drainage hose: Remove the drainage hose from the retainer and pull it
from the housing. Remove the container.
Remove the sealing cap, allow the detergent solution to flow out.
Replace the sealing cap and place the drainage hose in the retainer.
2* For models without a drainage hose: Carefully unscrew the pump cover until the
detergent solution begins to flow out. When the service flap is half full, close the pump cover
and empty the service flap. Repeat the above steps until all the detergent solution has
completely drained out.
3. Carefully unscrew the pump cover (residual water).
4. Clean the interior, pump cover thread and pump housing (the impeller in the detergent
solution pump must rotate).
5. Replace the pump cover and screw it in place tightly.
6. Place the service flap back on and close.
To prevent unused detergent from flowing straight into the drain during the next wash: Pour 1 litre of water into
compartment II and start the 4 plus (empty) programme.
Drainage hose at the siphon
Turn the programme selector to stop (off) and disconnect the mains plug.
1. Loosen the hose clamp, carefully remove the drainage hose (residual water).
2. Clean the drainage hose and siphon connecting piece.
3. Reattach the drainage hose and secure the connection with the hose clamp.
Filter in the water supply
Reduce the water pressure in the supply hose:
1. Turn off the tap.
2. Select any programme (except for (spin), 4 plus (empty)).
3. Select inicio (start). Let the programme run for approximately 40 seconds.
4. Turn the programme selector to stop (off). Disconnect the mains plug.
Clean the filter:
1. Depending on model:
Disconnect the hose from the tap.
Clean the filter using a small brush.
and/or for Standard and Aqua-Secure models:
Remove the hose on the rear of the appliance,
Remove the filter with pliers and clean.
2. Connect the hose and check for leaks.
– Risk of scalding.
Allow the detergent solution to cool down.
– Turn off the tap.
11
What to do if...
ʑ
Water is leaking out. – Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
ʑ
No water supply.
Detergent not dispensed.
– inicio (start) not selected?
– Tap not turned on?
– Filter blocked? Clean the filter a page 10.
– Supply hose kinked or trapped?
ʑ
Washing machine door cannot
be opened.
– Safety function active. Wait approx. 2 minutes.
– flot (no spin) (without final spin) selected? a page 3, 4.
ʑ
Programme does not start. – inicio (start) selected?
– Washing machine door closed?
ʑ
Detergent solution is not
drained.
– flot (no spin) (without final spin) selected? a page 3, 4.
– Clean the detergent solution pump a page 10.
– Clean the waste pipe and/or drainage hose.
ʑ
Water not visible in the drum. – Not a fault - water below the visible area.
ʑ
Unsatisfactory spin result.
Laundry wet/too damp.
– Not a fault - the unbalanced-load detection system has cancelled the spin cycle
because of uneven distribution of the laundry.
Distribute small and large items of laundry evenly inside the drum.
– Too low a speed selected? a page 5.
ʑ
Spin cycle performed several
times.
– Not a fault - unbalanced load detection system adjusts the imbalance.
ʑ
Residual water in the
compartment for care
products.
– Not a fault - the action of the care product is not affected.
– Clean the insert if necessary a page 9.
ʑ
Odour formation in the washing
machine.
– Run programme resistentes/algod. (cottons) 90 °C without laundry. Use
standard detergent.
ʑ
Foam escaping from the
detergent drawer.
– Too much detergent used?
If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
compartment I
I (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
ʑ
Intense noise formation,
vibrations and “walking” during
the spin cycle.
– Are the appliance feet fixed?
Secure the appliance feet a Installation instructions.
– Transportation safety devices removed?
Remove the transportation safety devices a Installation instructions.
ʑ
Noises during spin and drain
cycles.
– Clean detergent-solution pump a page 10
ʑ
The indicator lights do not
function during operation.
– Power cut?
– Fuses tripped? Reset/change the fuse.
– If the fault occurs repeatedly, call the after-sales service.
ʑ
Programme sequence longer
than usual.
– Not a fault - unbalanced load detection system adjusts imbalance by repeatedly
distributing the laundry.
– Not a fault - foam detection system active - adds an additional rinse cycle.
ʑ
Detergent residues on the
laundry.
– Occasionally, phosphate-free detergents contain water-insoluble residues.
– Select 5 plus (rinse) or brush out the laundry after washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to stop (off) and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service a Installation instructions.
Instruction manual
en
Washing
machine
Observe the safety instructions on page 8!
Read these instructions and the separate
installation instructions before operating
the washing machine.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Balay 3TS70105T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Balay 3TS70105T in the language / languages: English as an attachment in your email.

The manual is 1,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info