165839
21
Zoom out
Zoom in
Previous page
1/22
Next page
VR 404 - VR 404 XR
CONNEXIONS ET FONCTIONS
MUTE
REMOTE
INDICATEURS
LUMINEUX
IN
Réglage d’activation
pour l’amplificateur
provenant de l’auto-
radio (ou de toute
autre source avec une
sortie pour le “remo-
te” des amplifica-
teurs).
Le voltage appliqué
doit être entre 3 et 15
VDC.
BORNES
D'ALIMENTATION
POWER
Borne d’entrée pour
l’alimentation de
l’amplificateur.
Connecter le positif
et le négatif de la
batterie avec les
polarités indiquées.
Le voltage doit être
entre 11 et 15 VDC.
ON
Il indique que
l’amplificateur est
activé.
IN
Réglage d’entrée provenant de
l’autoradio (ou toute autre source
avec une sortie pour le “mute”
de l’amplificateur).
Il est spécialement destiné à être
connecter à la sortie mute d’un
téléphone mobile.
L’amplificateur est mis “sous
silence” à l’arrivée d’un appel; à
la fin de l’appel l’appareil
réactive la reproduction musi-
cale.
Il peut être connecté à la sortie
MUTE OUT de l’amplificateur
précédent pour obtenir une mise
en silence simultanée de tous les
amplificateurs connectés en
cascade. Le voltage doit être
entre 3 et 15 VDC.
OUT
Sortie destinée aux autres
amplificateurs du système de
reproduction. Elle doit être
connectée au MUTE IN de
l’amplificateur suivant pour
permettre la mise en silence
simultanée de tous les
amplificateurs connectés en
cascade. Le voltage disponible
sur cette sortie est de 12 VDC
avec un courant de 5 mA.
Tableau Post
érieur
OUT
Sortie destinée aux
autres amplificateurs
du système de repro-
duction.
Elle doit être con-
nectée au REMOTE
IN de l’amplificateur
suivant pour permet-
tre l’activation si-
multanée de tout le
système.
Le voltage disponi-
ble sur cette sortie est
de 12 VDC avec un
courant de 250 mA.
SAFE
Il indique l’ inter-
vention des protec-
tions: surchauffe
(max 80 °C) ou ano-
malies de sortie (pré-
sence d’un courant
continu, court-cir-
cuit ou impédance de
charge très basse).
L’intervention des
protections rend
l’amplificateur
inopérant.
Mettre l’amplifica-
teur en position
OFF, éliminer le
problème et remet-
tre en position ON.
21
24
VR 404 XR
ITALIANO
DATI TECNICI
ALIMENTAZIONE 11 ÷ 15 VDC
ASSORBIMENTO A VUOTO 1 A
ASSORBIMENTO MAX (Pot. Nominale) 27 A
POTENZA NOMINALE CONT. (Toll. +10%; -5%)
4ch x 4 Ohm; 0,3% THD; 12 VDC 35 W (RMS)
POTENZA CONTINUA (4 ch x 4 Ohm; 13,8 VDC) 45 W (RMS)
POTENZA CONTINUA (4 ch x 2 Ohm; 13,8 VDC) 65 W (RMS)
POTENZA CONTINUA (2 ch x 4 Ohm; 13,8 VDC)Bridge 130 W (RMS)
DISTORSIONE THD (1 KHz; 90% Pot. Nominale) 0,04 %
FATTORE DI SMORZAMENTO (4 Ohm) 140
TEMPO DI SALITA 4 µS
RAPPORTO SEGNALE / RUMORE 102 dBA
SENSIBILITA' D'INGRESSO 0,15 V ÷ 1,5 VRMS
IMPEDENZA D'INGRESSO 15 KOhm
IMPEDENZA DI CARICO stereo 8; 4; 2 Ohm
mono 8; 4 Ohm
REMOTE IN 3 ÷ 15 VDC
REMOTE OUT 12 VDC
MUTE IN 3 ÷ 15 VDC
MUTE OUT 12 VDC
FREQUENZE DI CROSSOVER 1° BANDA 45 Hz ÷ 200 Hz
2° BANDA 160 Hz ÷ 800 Hz
PENDENZA DI TAGLIO 12 dB/Ott. Butterworth
GUADAGNO USCITE PREAMPLIFICATE HI-PASS 12 dB
GUADAGNO USCITE PREAMPLIFICATE BY-PASS 0 dB
CONTROLLO Q FILTRO LO-PASS 0,7 - 3
MIXED MONO LO-PASS (bridge) SELEZIONABILE (ON - OFF)
SINGOLO / DOPPIO INGRESSO STEREO SELEZIONABILE
AMBIENT EQUALIZER VARIABILE E SELEZIONABILE ON - OFF
DIMENSIONI (BxAxL) 257 x 57 x 260 mm
VR 404 XR
ENGLISH
TECHNICAL DATA
POWER SUPPLY 11 ÷ 15 VDC
IDLING CURRENT 1 A
MAX ABSORPTION (Nominal Pwr) 27 A
CONT. NOMINAL POWER (Tol. +10%; -5%)
4 ch x 4 Ohms; 0.3 % THD; 12 VDC 35 W (RMS)
CONT. POWER (4 ch x 4 Ohms; 13.8 VDC) 45 W (RMS)
CONT. POWER (4 ch x 2 Ohms; 13.8 VDC) 65 W (RMS)
CONT. POWER (2 ch x 4 Ohms; 13.8 VDC) Bridge 130 W (RMS)
THD DISTORTION (1 KHz; 90% Nominal Pwr) 0.04 %
DAMPING FACTOR (4 Ohms) 140
RISE TIME 4 µS
SIGNAL / NOISE RATIO 102 dBA
INPUT SENSITIVITY 0.15 V ÷ 1.5 VRMS
INPUT IMPEDANCE 15 KOhms
LOAD IMPEDANCE stereo 8; 4; 2 Ohms
mono 8; 4 Ohms
REMOTE IN 3 ÷ 15 VDC
REMOTE OUT 12 VDC
MUTE IN 3 ÷ 15 VDC
MUTE OUT 12 VDC
CROSSOVER FREQUENCIES 1
st
BAND 45 Hz - 200 Hz
2
nd
BAND 160 Hz - 800 Hz
FILTERS SLOPE 12 dB/Oct. Butterworth
PREAMPLIFIED HI-PASS OUTPUTS GAIN 12 dB
PREAMPLIFIED BY-PASS OUTPUTS GAIN 0 dB
Q FILTER LO-PASS CONTROL 0.7 - 3
MIXED MONO LO-PASS (bridge) SELECTABLE (ON - OFF)
SINGLE/DUBLE STEREO INPUT SELECTABLE
SELECTABLE AND ADJUSTABLE AMBIENT EQUALIZER ON - OFF
SIZE (WxHxD) 257 x 57 x 260 mm (10.12 x 2.24 x 10.24 inch)
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audison vr 404 xr at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audison vr 404 xr in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 1,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info