165834
8
Zoom out
Zoom in
Previous page
1/10
Next page
8
ENGLISH
TECHNICAL DATA
POWER SUPPLY 11 ÷ 15 VDC
IDLING CURRENT 1 A
MAX CONSUMPTION (Nominal Pwr) 24 A
MAX DYNAMIC POWER (2 Ch x 4 Ohms) 135 W
MAX DYNAMIC POWER (1 Ch x 4 Ohms) Bridge 405 W
CONT. NOMINAL POWER (Tol. +10%; -5%)
2 Ch x 4 Ohms; 0.3% THD; 12 VDC 95 W (RMS)
CONT. OUT POWER (2 Ch x 4 Ohms; 13.8 VDC) 100 W (RMS)
CONT. OUT POWER (2 Ch x 2 Ohms; 13.8 VDC) 150 W (RMS)
MONO OUT POWER (1 Ch x 4 Ohms; 13.8 VDC) Bridge 300 W (RMS)
DISTORTION THD (1 KHz; 90% Nominal Pwr) 0.07 %
BANDWIDTH (-3 dB; Nominal Pwr) 4 Hz ÷ 100 KHz
DAMPING FACTOR (4 Ohms) 150
RISE TIME 4.5 µS
SIGNAL / NOISE RATIO 98 dBA
INPUT SENSITIVITY 0.3 V ÷ 4 VRMS
INPUT IMPEDANCE 15 KOhms
LOAD IMPEDANCE Stereo 8 - 4 - 2 Ohms
LOAD IMPEDANCE Mono 8 - 4 Ohms
REMOTE IN 7 ÷ 15 VDC
DIMENSIONS (WxHxD) 175 x 50 x 330 mm (6.88 x 1.96 x 12.99 inch)
ITALIANO
DATI TECNICI
ALIMENTAZIONE 11 ÷ 15 VDC
ASSORBIMENTO A VUOTO 1 A
ASSORBIMENTO MAX (Pot. Nominale) 24 A
MAX DYNAMIC POWER (2 Ch x 4 Ohm) 135 W
MAX DYNAMIC POWER (1 Ch x 4 Ohm) Bridge 405 W
POTENZA NOMINALE CONT. (Toll. +10 %; -5 %)
2 Ch x 4 Ohm; 0,3 % THD; 12 VDC 95 W (RMS)
POTENZA OUT CONTINUA (2 Ch x 4 Ohm; 13,8 VDC) 100 W (RMS)
POTENZA OUT CONTINUA (2 Ch x 2 Ohm; 13,8 VDC) 150 W (RMS)
POTENZA OUT MONO (1 Ch x 4 Ohm; 13,8 VDC) Bridge 300 W (RMS)
DISTORSIONE THD (1 KHz; 90% Pot. Nominale) 0,07 %
BANDA PASSANTE (-3 dB; Pot. Nominale) 4 Hz ÷ 100 KHz
FATTORE DI SMORZAMENTO (4 Ohm) 150
TEMPO DI SALITA 4,5 µS
RAPPORTO SEGNALE RUMORE 98 dBA
SENSIBILITA' D'INGRESSO 0,3 V ÷ 4 VRMS
IMPEDENZA D'INGRESSO 15 KOhm
IMPEDENZA DI CARICO Stereo 8 - 4 - 2 Ohm
IMPEDENZA DI CARICO Mono 8 - 4 Ohm
REMOTE IN 7 ÷ 15 VDC
DIMENSIONI (BxAxL) 175 x 50 x 330 mm
FONCTIONS ET RÉGLAGES
ON
Il indique que l'amplificateur est activé.
INDICATEURS LUMINEUX
ENTRÉES
CHOIX DE LA
FONCTION
RÉGLAGE
DE NIVEAU
PRE IN
Entrées Left et Right de
l'ampli. Elles peuvent
être utilisées pour
amplifier la sortie PRE
d'une source de signal
(radio,CD) ou celle d'un
filtre actif électronique
ou d'un quelconque
modèle de signal à
étage préamplifié.
LEVELS
Réglage de
niveau de la
sortie de
l'ampli. La
sensibilité
varie de 300
mV à 4V.
L/R
Sorties de puissance pour les canaux
Left et Right de l'ampli. Connecter les
hautparleurs selon les polarités
indiquées.
MONO
Sorties pour la configuration mono
en pont. A utiliser quand l'ampli est
positionné sur MONO IN R au
moyen du sélecteur situé sur le
cadran antérieur de l'ampli.
BORNES DE SORTIE
REMOTE
BORNES
D'ALIMENTATION
POWER
Borne d'entrée pour
l'alimentation de
l'amplificateur. Connecter le
positif et le négatif de la
batterie avec les polarités
indiquées. Le voltage doit être
entre 11 et 15 VDC.
IN
Réglage d'activation pour
l'amplificateur provenant de
l'autoradio (ou de toute autre
source avec une sortie pour le
remote des amplificateurs).
Le voltage appliqué doit être
entre 7 et 15 VDC.
13
SAFE
Il indique l'intervention des protections
en cas de surchauffe (max 80° C) ou
anomalies de sortie (présence d'un
courant continu, courtcircuit ou
impédance de charge très basse).
L'intervention des protections rend
l'amplificateur inopérant. Mettre
l'amplificateur en position OFF, éliminer
le problème et remettre en position ON.
MODE
STÉRÉO:
Il sélectionne
l'ampli pour un
fonctionnement
stereo.
MONO:
Il sélectionne
l'ampli pour un
foctionnement
mono. Entrée
utilisée: Right.
DISPOSITION DES BORNES DE CONNECTION
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audison power 2 millennium at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audison power 2 millennium in the language / languages: German, Dutch, French, Italian as an attachment in your email.

The manual is 1,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info