583955

Audiovox PRO-9056TW Pursuit Series Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
128-8856
2 of 2
2
© 2010 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-8856
REMOTE STARTING THE VEHICLE
This will not start the vehicle if any one of the following situations exists:
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1) To start the vehicle, press and release the transmitter button two times within
2 seconds. The vehicle will start and remain running for the
pre-programmed time up to a 60 minute run cycle. As a
visual indication, the parking lights will flash or remain on
depending on the setting by your installation center. Addi-
tionally if the two way transceiver shown on the right is used,
the transceiver will play a melody when the vehicle is started,
and the Orange LED surrounding the transceiver button will
flash every ten seconds while the vehicle is running.
2) When you arrive at the vehicle, turn the ignition key to the
ON position (not the spring loaded start position), then step
on the brake pedal to disengage the remote starter. The
vehicle will continue to run, but now on its own power.
NOTE: The engine will stop running before the pre-programmed
run cycle has expired if you perform any one of the following
functions:
-Press the button on the keychain transmitter two times within 2 seconds
-Depress the brake pedal
-Open the vehicle's hood
-Move the safety control switch to the Off position.
PUSH-BUTTON LED RECEIVER VALET/OVERRIDE/SAFETY CONTROL SWITCH
The Push-Button LED switch located in the receiver allows you to temporarily disable the remote
starting function of the system. This recommended whenever the vehicle is being serviced. To place
the system in the service mode:
1) With the system disarmed/unlocked, and the ignition switch off, Press and Hold the Push-Button
switch found on the windshield receiver, in.
2) Turn the ignition switch on, off, on, off, on, off.
3) The Orange LED begins to flash two short flashes followed by one long flash and continues this
pattern until the unit is returned to the normal mode of operation.
The above action puts the unit into the Remote Start Override/Service mode and will not start from
the RF transmittor or any other input, Posse or otherwise.
To Exit Remote Start Override Mode
1) With the system disarmed, Press and Hold the Push-Button switch found on the windshield
receiver, in.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED turns off indicating that the Remote Start unit is fully functional once again.
UNLOCKING THE VEHICLE:
If you have electric door lock, and the Optional Unlock feature was added, with the vehicle running
under command of the remote start unit, press and hold the transmitter button for 3 seconds until
the doors unlock.
TELEMATIC UPGRADE:
This system has the ability to have a telematic upgrade module connected to it. This is an upgrade that
can give you control of certain functions of your vehicle from a Telephone, or in some cases a
computer interface. Please check with your installation center for most recent Telematic Upgrades. If
you had a Telematic Upgrade installed, the manual supplied with the upgrade unit will provide a
operator's manual advising of the features of the system and means available to control these
features of your vehicle.
.
FUNCTION SETTING CHART
To be completed by installer
Run Time 5 Min 10 Min 15 Min 20 Min
Lights Pulse Steady
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audiovox PRO-9056TW Pursuit Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audiovox PRO-9056TW Pursuit Series in the language / languages: English as an attachment in your email.

The manual is 0,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info