500990

Audioline Football Phone Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
1 General Information
Please read these operating instructions carefully. If
you should have any questions, please contact our
Service Department on the Hotline number 0180 5 00
13 88 (Telekom cost at the time of printing 12
cents/min). Under no circumstances open the unit
yourself and do not try to carry out your own repairs.
For any claims under the warranty, please refer to your
dealer.
Intended use - T his telephone has been designed for
use on an analogue telephone line (PSTN) within
Germany. However, no guarantee can be accepted for
trouble-free operation on all telecommunications
terminal equipment connections due to the differences
between the different telecommunications network
operators. The telephone requires a TAE socket with
F/N coding in common with other plug-in units such as
fax machines, answering machines or modems.
Connect the telephone cable to the phone socket
intended for the purpose only. Do not change the plug
on the connecting cable.
Private exchanges - The telephone can also be
connected to a private exchange. You can find out
from the dealer from whom the equipment was
purchased whether your telephone will work on your
private exchange without any problems. Due to the
large number of different private exchanges, it is not
possible to guarantee this function.
Position - Do not set up telephone in the immediate
vicinity of other electrical equipment such as
microwaves or hi-fi systems, as this may result in
mutual interference. The location has a decisive
influence on the trouble-free operation of the
telephone. Place the telephone on a flat and non-slip
surface. The feet of the telephone do not normally
leave any marks on the surface. However, due to the
large number of varnishes and surfaces in use, it may
not be possible to prevent marks occurring on the
surface due to the feet of the unit. Do not use the
telephone in areas where there is a risk of explosion.
Excessive exposure to smoke, dust, vibrations,
chemicals, moisture, heat or the direct rays of the sun
must be avoided.
Disposal - If your device has come to the end of its
service life, bring it to a collection point provided by
your local public waste authorities (e.g. recycling
center). The adjacent symbol indicates that the old
device must be disposed of separate from domestic
waste. According to laws on the disposal of electronic
and electrical devices, owners are obliged to dispose
of old electronic and electrical devices in a separate
waste container. Batteries must be disposed of at the
point of sale or at appropriate collection points
provided by the public waste authorities. Packaging
materials must be disposed of according to local
regulations.
Temperature and Ambient Conditions -The
telephone is designed for use in protected rooms with
a temperature range of 10 °C to 30 °C. The telephone
must not be installed in damp rooms such as a
bathroom or laundry room. Avoid proximity to sources
of heat such as radiators and do not expose the unit to
direct sunlight.
Cleaning and care - The surface of the case can be
cleaned with a soft, dry, lint-free cloth. Never use
cleaning agents, particularly aggressive solvents. No
attention is necessary apart from cleaning the case
occasionally. The rubber feet of the base station are
not resistant to all cleaning agents. The manufacturer
can therefore not accept any liability for possible
damage to furniture or the like.
2 Operating Elements
1. Disconnect button/receiver rest
2. Redial
3. Flash time selection 100/300ms
4. R signal button
5. Mute button
6. Connection to base unit
7. Visual call indicator
8. Ringer adjustment Normal - “Tor Tor Tor”
1
2
3
4
5
6
7
8
R
100 300
R
9. Fixing for wall mounting
10. Connection for telephone cable
11. Batterie compartment
12. Fixing for wall mounting
13. cable duct for wall mounting
14. connection for spiral receiver cable
DES DECKELS
VOR ÖFFNEN
TELEFONSTECKER ZIEHEN
9
10
11
12
13
14
Underside of base unit
3 Commissioning
3.1 Safety information
NOTE! Before commissioning, it is essential that you
read the general information at the beginning of this
manual.
3.2 Check conten ts o f p ack
The following items are supplied:
one telephone base one telephone receiver
one spiral cable one connection cable
one Operating Manual three AA batteries
3.3 Connecting the telephone receiver
After unpacking your telephone, you must first connect
the telephone receiver to the base unit. First take one
end of the spiral cable and plug it into the socket (6) at
the bottom of the receiver. Take the other end of the
spiral cable into the socket (14) at the telephone base.
3.4 Fitting the battery
Before connecting your new telephone to the
telephone network, the batteries should be fitted.
Please always use type AA alkaline batteries. The
batteries are required for the ”Tor Tor Tor” noise ringer.
Before installing or changing the batteries, make sure
that the telephone is not connected to the telephone
network.
1. Make sure that the telephone is not
connected to the telephone network.
2. The battery compartment is to be found
on the underside of your telephone.
3. Open the battery compartment with a
small screwdriver or a pointed object.
4. Insert the batteries, ensuring that the
polarity is correct.
5. Close the battery compartment.
The batteries should be changed when you don’t hear
the noise “Tor Tor Tor”.
3.5 Connecting the telephone
Connect the telephone cable supplied to the
telephone socket and the telephone jack (10) on the
underside of the telephone. Then feed the cable out of
the telephone housing either upwards or downwards
through the cable guide. Clip the cable firmly in the
cable channel. The telephone works using the tone
dialling system.
3.6 Wall mounting
Your telephone is also suitable for wall mounting. Use
two screws for fixing. Drill two holes vertically side by
side, 133 mm apart, and leave the screws protruding
from the wall by 5mm. Now place the telephone over
the screws and push it slightly downwards.
When the telephone is used on a table, the receiver
hanging hook must be in the flush position as shown
in diagram A (factory setting). When mounting on the
wall, the telephone receiver hanging hook is pulled out
and rotated. See diagram B.
If you are using the telephone fitted to the wall, you
can hang the receiver on the telephone without
hanging up. You will find a small hook for this purpose
at the upper end of the receiver rest.
4 Operation
4.1 Making a call
Your telephone can be used like any conventional
telephone. Lift the receiver and wait until you hear the
dialling tone. Now dial the required telephone number.
To end the call, replace the receiver on the rest. You
can end the current call by using the disconnect button
and you will immediately obtain a new dialling tone.
4.2 Receiving calls
When a call comes through, you will hear the ringing
tone and the Visual call indicator is flashing slowly.
The call can now be accepted using the receiver.
4.3 Redial facility
If a connection that you have dialled is engaged or you
were unable to get through to anybody, simply replace
the receiver. T he last number dialled remains stored in
the telephone automatically. To use the redial facility,
proceed as follows: Lift the receiver and press the
redial button å. The stored redial number will now
be dialled.
4.4 Adjustable ring tone
By means of the slide switch l
l
Tor!
on the receiver
you can choose the settings l (loud) or
l
(soft) to
match the volume of the ringing tone to your
requirements. If at any time you do want to use the
”Tor Tor Tor” noise ringer, use the
Tor!
setting..
4.5 Muting the microphone
You can switch off the microphone during a call using
the mute button, ç It is thus possible to speak without
the other party hearing you. The loudspeaker remains
switched on and you can continue to hear the other
party. To mute the microphone, press and hold the
mute button ç once while a call is being made. To
switch the microphone on again, release the mute
button ç and you will be able to continue your call
as normal.
5 Using T-NET / Private exchanges
5.1 “R” Button on private exchanges
If you have connected your telephone to a private
exchange, you can use all the facilities such as call
transfer, automatic recall, etc. The “R” signal button
gives you access to these facilities. The FLASH time
“100ms” will be required on a private exchange. For
this purpose, set the “R” switch to the “100ms” setting.
You can find out from the dealer from whom the
equipment was purchased whether your telephone will
work on your private exchange without any problems
and what further facilities you will receive from this.
5.2 “R” Button and th e DEUTSCHE TELEKOM
T-NET functions
Your telephone supports the most important
DEUTSCHE TELEKOM added value functions (e.g.
brokering, call waiting, three-way conference, etc.).
The T-NET works using the ”FLASH 300ms” setting.
For this purpose, set the “R” switch to the “300ms”
setting. Please contact DEUTSCHE TELEKOM to gain
access to the T-NET functions (some of which are
subject to charge).
5.3 Dialling telephone numbers when using on
private exchanges
The pause function between the code for the outside
line (usually 0 or 9) and the dialling tone described in
this chapter is only necessary on older private
exchanges. W ith some private exchanges, there is a
short pause between the code for the outside line
(usually 0 or 9) and the dialling tone. This pause can
be entered when dialling manually so that the
following numbers are not dialled too quickly.
Entering the pause when dialling manually
Press the redial button å once between the code for
the outside line and the actual telephone number.
After an outside line has been obtained, you
telephone will wait for 3 seconds before dialling the
actual telephone number.
6 Important Information
6.1 Fault finding
Remove all extra telephone equipment and connect
only the telephone directly to the telephone socket.
If the fault is still present, connect another telephone (if
available) to the telephone socket. The results will
show you whether the fault lies with the unit or with the
telephone line.
In the case of technical problems you can also contact
our Service Department on the Hotline number 0180 5
00 13 88 (Telekom cost at the time of printing 12
cents/min).
6.2 Replacing the telephone cable
If you have to replace your telephonecable, you can
locate the appropriate cable at your dealer’s with the
help of the following diagram.
4
5
6
1
2
F-Codierung - IMPORT Standard
TAE-F Rj11 6/2
6
5
4
3
2
1
6
5
4
3
2
1
3
6
5
43
21
6.3 Warranty
AUDIOLINE units are manufactured and tested in
accordance with the most up-to-date manufacturing
procedures. Selected materials and highly developed
technologies ensure trouble-free operation and long
life. The situation, where the cOffe of a malfunction of
the unit is due to the telephone network provider or
any private exchanges that may be connected in
between, is not covered by the warranty. The warranty
is not applicable to the batteries used in the various
products. The warranty period is 24 months calculated
from the day of purchase.
All defects, which are the result of material or
manufacturing faults, will be rectified free of charge
within the warranty period. Claims under the warranty
shall not be considered if the equipment has been
tampered with by the purchaser or third parties.
Damage, which results from improper handling or use,
incorrect positioning or storage, inappropriate
connection or Installation and through Act of G od or
other external influences are not covered by the
warranty. In the case of complaints, we reserve the
right to repair or to replace the defective parts or to
exchange the unit. Parts or units that have been
exchanged shall become our property. Claims for
damages shall not be entertained unless they relate to
intention or gross negligence on the part of the
manufacturer.
If, however, your unit should develop a fault within the
warranty period, please contact the shop where you
bought your AUDIOLINE unit, taking with you your
purchase receipt. In accordance with these conditions,
all claims under the warranty shall be made
exclusively to your dealer. Rights under the warranty
can no longer be enforced after the expiry of two years
from the purchase and handing over of our products.
6.4 Declaration o f Co nformity/CE mark
This unit fulfils the requirements of the EU Directive
1999/5/EC relating to Radio Equipment and
Telecommunications Terminal Equipment, and the
mutual recognition of conformity. Conformity with the
above-mentioned Directive is confirmed by the CE
mark on the unit.
For the complete Declaration of Conformity, please
use the free download from our web site
www.audioline.de.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Audioline Football Phone at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Audioline Football Phone in the language / languages: English, German as an attachment in your email.

The manual is 0,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info