No faults detected
Fault in brake system
Coolant temperature too
high/coolant level too low
Engine oil pressure too low
If one of the red symbols lights
up while you are driving, stop
the car, switch off the engine
and refer to the Owner’s Manual.
/Brake light faulty
1)
Bulb failure: dipped head-
lights or rear lights
1)
Brake pads worn
1)
Washer fluid level low
Fault in power steering
Fuel level low
Battery voltage too high
or too low
1)
Check engine oil level
Engine oil sensor faulty
1)
Speed warning 1 or 2
(km/h or mph)
Door or tailgate not shut
Page 2
Filling the tank
11
Rev counter
22
Warning and indicator
lamps
Electronic power control
(for engine)
1)
or
Glow plugs (on diesel
models)
1)
Economy mode
or
Trailer turn signals
Side lights/headlights
Traction control system
(ASR)
or
Electronic stability
program (ESP)
Electronic immobilizer
Main beam headlights
Turn signals, hazard warning
lights
KKuurrzzaannlleeiittuunngg AAuuddii AA22 eenngglliisscchh 55..0022 223311..556622..664444..2200
Releasing the tank flap
Press the switch (with the filler
pump symbol) on the driver’s
door pillar to release the fuel
filler flap. Then unscrew the tank
cap and hook it onto the flap.
Stickers for:
11
Fuel grade
22
Tyre pressures
11
Angle of backrest
Lean forwards and turn adjuster
wheel.
22
Seat backwards or forwards
Lift the handle and move the
seat.
33
Seat height
The seat height is adjusted by
pulling or pushing the lever.
Adjusting belt height
Move the top belt guide up or
down as required. Tug the belt to
check that
the catch
is engaged
properly.
1)
If one of these warning symbols lights up while you are driving, please
take the vehicle to an Audi workshop straightaway.
Adjusting front seats
Instruments and warning/indicator lamps
Press the button briefly with
the ignition on and the vehicle
stationary.
• To check the auto-check
control display
Press the button twice with the
ignition on.
• To call up driver information
Press the button if one of the red
symbols flashes.
• To activate mileage recorder
display and clock
Press the button when the igni-
tion is off.
• To set speed warning
Press the button briefly when
the desired speed is indicated
on the speedometer. To clear the
speed limit, press the button for
at least 1 second.
• To set the time/date
Keep pulling the button briefly
until the desired display ap-
pears. Turn the button to alter
the time/date.
88
Display:
• Warning symbols and auto-
check control
Fault in engine management
system
1)
Airbag system
1)
Anti-lock brake system
1)
Handbrake engaged
Alternator
1)
Seat belt reminder
33
Coolant temperature
gauge
44
Fuel gauge
55
Speedometer
66
Clock/Date
77
Control button:
• To check distance to next
service
• On-board computer
Instantaneous fuel
consumption
Fuel range
Driving time
Average fuel consumption
Average speed
• Outside temperature
• Radio/telephone information
• Navigation/telematics
information
• Selector lever positions on
vehicles with automated
manual gearbox
• Service indicator
Shortly before a service is due,
the display will briefly show the
word
SSeerrvviiccee
, together with the
number of miles/km until the
service is due.
99
Reset button for trip
recorder
1100
Mileage recorder
Top display: trip recorder
Bottom display: total mileage
Rear seats
The luggage area can be exten-
ded when extra space is re-
quired; there are several alter-
natives:
Changing angle of rear backrest
Pull up the handle
11
and push
the backrest forwards until the
handle
11
clicks back into place.
Folding down rear backrests
Pull up the handle
11
and fold
down the backrest.
Folding down rear seat
Open the rear doors. Pull up the
handle
11
and fold down the
backrest. Press the top of the
backrest
22
down firmly in the
direction indicated (arrow). Pull
the release handle
33
and tip the
seat forwards.
Pull out the rod
44
located
under the seat and insert in the
retainer
55
.
Removing rear seats
Open the rear doors. Pull up
the handle
11
and fold down the
backrest. Press the top of the
backrest
22
down firmly in the
direction indicated (arrow). Pull
the release handle
33
in the
direction indicated (arrow) and
lift up the seat
66
. Now push the
seat towards the rear and lift it
out of the car.
Installing rear seats
Engage the retainers on the
seat
77
in the front mountings
88
.
Then press the seat into the rear
mountings
99
so that it engages
securely.
Setting up rear seats and back-
rests
Fold back the seat and backrest
until they engage securely. Make
sure that the outer rear seat
belts are located in the belt
guides, so that they are not
trapped in the backrest catch.
