108403
24
Zoom out
Zoom in
Previous page
1/25
Next page
GB 9
faults
what should I do if…
fault
Lighting is not on.
Extractor hood makes a
noise.
No extraction.
cause
Light bulb defective.
attention:
Use only the same light
bulbs with the wattage
stated.
Discharge too long or too
many bends in the duct.
Motor defective.
Motor or controls defective.
Connection cable defective.
solution
Pull the inner ring
downwards with a
screwdriver (see
illustration).
Take care: The glass is
loose!
Pull the halogen bulb out
of the fitting and replace it
with a new 20 W halogen
bulb. Use a clean cloth to
hold the new bulb.
Change the discharge
ducting (see installation
guide).
Phone the service
department.
Phone the service
department.
Phone the service
department.
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not work.
attention:
Disconnect the appliance from the mains before starting the repair, preferably by
removing the plug from the socket or setting the main switch to zero.
GB 8
maintenance
cleaning
The filters can also be cleaned by hand. Clean the filters in
soapy water made with washing-up liquid and rinse them.
Allow the filters to drain well (through the slits at the side).
The underside of the extractor hood can be cleaned with a
mild cleaning agent and a damp cloth. Dry with kitchen paper
or a dry cloth.
replacing
The filters belonging to the wall hoods can only be put back
in place in one way. Be careful about the correct position of
the filters. Hold the filter so that the covered part on the
underside is at the centre rear. This can be recognised on the
outside by the pattern with the smaller holes.
For the island hoods, you do not have to be careful about the
position of the filters, as long as you put them back
lengthways.
1 Push the rear of the filter into the holder.
2 Push the front upwards until it will not go any further.
3 Let the filter slide forwards.
The filter is again in its correct position.
replacing the carbon filter
Replace the carbon filter twice a year. This only applies to
recirculation hoods.
Put the carbon filter in the space intended for it above the
filters.
be careful about the
correct position of
the filter.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG EM 411 M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG EM 411 M in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info