507731
4
Zoom out
Zoom in
Previous page
1/37
Next page
Installation instructions S-HR series page 4
1 Introduction
These instructions describe the functioning, installation,
use and primary maintenance of ATAG central heating
units for United Kingdom and Ireland. Where necessary
different regulations of each country are separately
described.
These instructions are intended for the use of Corgi
registerd installers or registered Bord Gais installers in
connection with the installation and putting into operation
of ATAG units. It is advisable to read these instructions
thoroughly, well in advance of installation. Separate
instructions for use are supplied with the unit for users of
ATAG central heating units. ATAG is not liable for the
consequences of mistakes or shortcomings which have
found their way into the installation instructions or user’s
manual. Further, ATAG reserves the right to alter its
products without prior notification.
When delivering the unit, give the customer
clear instructions concerning its use; present
the customer with the user’s manual and card.
Each unit is fitted with an identification plate. Consult the
details on this plate to verify whether the unit is
compliant with its intended location, e.g.: gas type,
power source and exhaust classification.
On completion of the installation the installer or
commissioning engineer must fill out and complete the
Benchmark commission section of the boiler log book and
hand to customer or end user for future record keeping.
The Benchmark log book must also be filled out and
completed by the service agent following each service call,
and returned to the customer. A copy of the Benchmark
commissioning certificate must be returned to ATAG
Heating UK Ltd along with the warranty registration card to
register the appliance for the standard warranty benefits.
2 Regulations
The following regulations apply to installation of ATAG
central heating units:
Legislation and Regulations.
Gas Safety (Installation and Use). All gas appliances must
by law, be installed by a competent person, eg. Members
of CORGI and in accordance with the current Gas Safety
Regulation. Failure to install appliance correctly could lead
to prosecution.
In addition to the above regulations this appliance must be
installed in compliance with the current IEE Regulations, the
Building Standards (Scotland Consolidation) Regulations.
Regulations and bye laws of the Local Water Authority and
the Current Health and Safety Regulation.
Ireland:
- Irish standard 813
- Domestic gas installations
The current, Electricity at Work Regulation must be
complied with and also be in accordance with the
relevant and current editions of the British Standards.
The ATAG Blauwe Engel boiler is a certified appliance
and must not be modified or installed in any way contrary
to this Installation Manual.
Manufactures instructions must not be taken in any way
as overriding statutory obligations.
The ATAG Blauwe Engel is a central heating unit with an
optional integrated hot water function. These units must
be connected according to these instructions and all
installation norms in respect of the part of the unit to be
connected.
Observe the following rules of safety:
- All work on the unit must take place in a dry
environment.
- ATAG units may never be in operation without their
housing, except in connection with maintenance or
adjustments (see Chapter 13 and 14).
- Never allow electrical or electronic components to
come into contact with water.
Carry out the following tasks in connection with
maintenance, etc. to an already-installed unit:
- Shut down all programmes
- Close the gas tap
- Remove the plug from the wall socket
- Close the stop cock of the unit’s intake connection
Take note of the following when maintenance or
adjustments are needed:
- The unit must be able to function during these
activities; for this reason, the unit’s supply voltage,
gas pressure and water pressure must be
maintained. Ensure that these are not a source of
potential danger during these activities.
Following maintenance or other activities;
always check the installation of all parts
through which gas flows (using leak-search
spray).
Following maintenance or other activities,
always replace the housing and secure it with
the screw behind the door at the front of the
casing.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG Blauwe Engel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG Blauwe Engel in the language / languages: English as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG Blauwe Engel

ATAG Blauwe Engel Manual - Dutch - 2 pages

ATAG Blauwe Engel Installation Guide - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info