Diameter: 16mm
Length (including drip tip): 59.5mm
T
1. Unscrew the top hardware and remove it from the
tank;
2.
filling bottle through the filling hole;
3. Put the top hardware back on top of the tank then
screw to secure it.
Mod Specifications
Optional output voltage: 3.0V
Supported resistance range: 0.8-3.0Ω
Continuous firing time: 10 seconds
Firmware update: N/A
Battery type: Built-in LiPo
Battery capacity: 900mAh
Dimensions: 26.5*75*17mm
Instructions
• Power on/off
Pressing the fire button 5 times within 2 seconds will
turn the device on or off. The indicator light will flash
white 3 times to indicate on or off.
• V
When the device is on, press the fire button, the
indicator light will indicate your device's current
charge. When its current charge is above 3.8 volts
(60-100%), the indicator light will be green. When the
charge is between 3.5 and 3.8 volts (30-60%), the light
will be blue. When the charge drops below 3.5 volts
(0-30%), the light will then turn red to remind you that
it is time to charge the device.
• Set the output voltage
Press the mode button to adjust the output voltage.
The voltage display will turn on for 3 seconds to
indicate the value of the corresponding output voltage:
3.0V
Protection Features
• Automatic cutoff: The preset continuous fire time is 10
seconds, after 10 seconds of continuous firing, the
indicator light will flash pink 10 times and the device
will stop firing.
• Short circuit protection: When the device detects a
short, it will stop firing, and the indicator light will flash
pink 3 times.
• Low voltage protection: When the battery level drops
below 3.0V
indicator light will flash red 15 times to remind you to
charge the device.
• Overcharge protection: When the device is fully
charged, it will stop charging to prevent overcharging
of your battery
• Over heat protection: When the temperature of the
chip is above 75 °C/167 °F
yellow for 3 seconds and the device will cut off.
Charging Instructions
• Charging the device via Micro USB charging port, the
maximum current can reach up to 1A, and the
recommended charging voltage is 5.0V
• When the USB cable is attached, the indicator light will
flash red 3 times. While charging, the indicator light
will indicate the device’s current charge status: 3.5
volts or less (0-30%) = red light; 3.5 to 3.8 volts
(30-60%) = blue light; 3.8 volts and above(60-100%) =
green light. When the device is fully charged, the
indicator light will flash green 20 times then remain off.
When unplug the USB cable, the indicator light will
flash green 3 times.
IMPORT
NICOTINE CONT
Before using nicotine containing e-liquids the user
should read the following information carefully
NICOTINE CONT
Do not use if you are allergic to nicotine or any of the
other ingredients contained within the e-liquid (see
manufacturer’s label for full details).
WARNINGS AND PRECAUTIONS
Nicotine containing e-liquids are not recommended for:
• Non-smokers
• Y
• Pregnant or breast feeding women; as nicotine is
known to cross the placenta and to be excreted in
breast milk;
• Those experiencing general ill health; such as heart
disease, stomach and duodenal ulcers, liver or kidney
problems, long term throat disease or difficulty
breathing due to bronchitis, emphysema or asthma;
• Those who have an overactive thyroid gland or have a
phaeochromocytoma (a tumour of the adrenal gland
that can affect high blood pressure);
• Those who have diabetes, as nicotine may affect your
blood sugar levels.
• Those taking the following medication;
• Theophylline (to treat breathing problems)
• Ropinirole (to treat restless leg syndrome)
• Clozapine (to treat schizophrenia)
POSSIBLE SIDE EFFECTS
If you inhale too much nicotine or use the product too
much you may experience one or more of the following
effects:
• Feeling faint;
• Nausea (feeling sick)
• Headache
• Coughing
• Irritation of the mouth or throat
• Dizziness
• Stomach discomfort
• Hiccups
• Nasal congestion
• V
• Heart palpitations
• Abnormal heart rate
If you experience any of these side effects; including
any possible side effects not listed in this leaflet,
discontinue using the product, if the effect(s) continue
after you stop use, consult your doctor or healthcare
professional and bring this leaflet to their attention.
Coil Installation
1. Invert the tank, push down the base hardware and
unscrew to disengage it;
2. Push and unscrew to remove the used coil and also
push and screw to install a new one;
3. Push down and screw in to relocate the base
hardware.
Note: The pressing and twisting operations in each step
are performed simultaneously
• When installing a new coil, let the tank stand for 5
minutes after filling so the cotton can be saturated
with e-liquid before use.
• Do not let the tank become completely empty
the tank to avoid dry burning or damage to the coil.
Micro USB
Charging Port
Drip Tip
T
Coil
Glass Tube
Airflow
Control Ring
Fire Button
Indicator Light
V
Mode Button
SAFETY INFORMA
For a safe and effective use of this product and its
accessories, we advise you to read the following
instructions in full, and to strictly observe the operating
procedures indicated in this manual and refer to the
leaflet contained in the packaging of the individual
products / accessories.
This product is intended for adult smokers. This product
is not recommended for non-smokers, young people
under the legal age, pregnant or breast feeding women
and those experiencing general ill health.
Keep the product out of reach of children and minors at
all times
WARNINGS FOR TRANSPORT
Do not keep your device in your pocket while switched
on to avoid inadvertently activating the vaporization
device, causing irreparable damage.
COMPONENTS OF THE PRODUCT
This product is a high-tech product and its components
such as the battery
part have been specifically made for this product. We
recommend the exclusive use of components and
accessories indicated. Use of components and / or
accessories not specifically produced for this device
may lead to a malfunction and / or damage to the
product and to the cancellation of the guarantee.
WARNINGS BEFORE USE
Products with an internal battery leave the factory
already fully charged. Do not recharge it until the
remaining charge indicator gives the low battery signal.
(See Instructions). The use of an empty
tank/pod can cause immediate damage to the internal
resistance and the consequent cancellation of the
guarantee.
WARNINGS WHILE DRIVING
While driving, be sure to strictly observe the laws and
regulations of the country where you are located; stay
focused on driving and pay attention to traffic
conditions. Do not use this product while driving a
vehicle and keep it separate from other objects in order
to avoid damage from bumps.
GENERAL W
• Do not bring your vape device into contact with water
or other liquids.
or too low temperatures (-5 °C / 50 °C).
the product in overheated or excessively damp
environments. Keep the product and its accessories
away from heat sources. Use only
spare parts and accessories.
battery completely before recharging. Carefully read
the composition of the e-liquid before use, and do not
use the product if you are allergic to any of the
components of the e-liquid. Do not use the product if
you suffer from respiratory and / or cardiovascular
system disorders. Do not use the product during
pregnancy or lactation.
• Do not ingest or swallow any part of the product or its
accessories and do not try to open or tamper with the
components of the product or its accessories. The
device does not need any flame to light it. T
performance losses, disconnect the battery from the
USB charger when fully recharged, and in the case of
anomalies, smell of burnt or abnormal deformation of
one of the components of the device or its
accessories, stop using it immediately and contact
Customer Care.
• Avoid direct contact of the e-liquid with the mouth
which could happen if you inhale too strong and too
frequently or if the tank is too full.
• Avoid any unauthorized operations that may damage
the product. For an optimal performance of your vape
device, it would be advisable to spend at least 30
seconds between one inhalation and the next. We
recommend only to use the
supplied to charge this device and not attempt to
recharge the device with any other type of charger
We don’t recommend using the product while
charging.
• Keep the product and its accessories out of reach of
children, and dispose of the product components at
dedicated collection/disposal points. Do not discard
this product in the environment.
Pack Contents:
1* K Lite mod
1* K Lite tank
2* Nichrome coils (1.6Ω & 1.8Ω preinstalled)
1* USB cable
1* Warranty card
1* User manual
T
Easy top fill
Child lock mechanism
2ml capacity
Adjustable airflow
Leak-free refill system
Coil resistance:
1.6Ω (3.0-4.2V) (6-1
1.8Ω (4.2-5.0V) (9-13W)
Coil material: Nichrome
T
Spryte coils
1 2 3 4 5 6 7
K Lite Kit
User Manual
Safety note:
T
switch off your device when it is not in use.
Especially when carrying your device in your
pocket, bag or purse.
To learn more about your products and how to use,
please visit:
www.aspirecig.com
Building 3, Xinhongtai Industrial Park, 14 Jian'an Rd,
Tangwei, Fuyong Town, Bao'an District, Shenzhen, China
Tel: +86-755-81499783 Email: service@aspirecig.com
Shenzhen Eigate Technology Co., Ltd.
Manufactured By Eigate MADE IN CHINA
*Diameter of the tank refill hole.
3.2
mm
