309039
34
Zoom out
Zoom in
Previous page
1/36
Next page
Page 16
ELECTRICAL CONNECTIONSELECTRICAL CONNECTIONS
The machine is delivered ready-fitted with a plug and is
intended for connection to an ASKO Dryer, which is
equipped with a matching receptacle. The plug supplied
with the washer can only be used with an ASKO Dryer. If
the washer is used separately or with another dryer, it
must be on a separate 220 V single-phase circuit.
If the machine is to be used in a wet area, the supply
must be protected by a residual current device.
As supplied: 230 V, 60 Hz
2000 W heating element
15 A fuse required
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of
malfunction or breakdown, grounding will reduce the
risk of electric shock by providing a path of least
resistance for electric current. This appliance is
equipped with a cord having an equipment-grounding
conductor and a grounding plug. The plug must be
plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
WARNING! Improper connection of the
equipment-grounding conductor can result in a
risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as to
whether the appliance is properly grounded.
Do not modify the plug provided with the appliance.
If it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
DRAIN OUTLET CONNECTIONDRAIN OUTLET CONNECTION
The machine is supplied with the outlet hose already
attached. The hose should be extended over a suitable
sink edge or drain pipe at a height of 24” to 36” (600
mm to 900 mm) above the floor. (The lower height is
preferable.) Make sure that the hose is not kinked.
If the hose is extended, the internal diameter of
the coupling must not be less than 1/2”.
NOTE:
WARNING!
Do not extend the drain hose higher
than 36” (900 mm).
WARNING!
Connection to a permanently wired
supply point must be made only by a
qualified electrician.
FREESTFREESTANDING INSTANDING INSTALLAALLATIONTION
The washer can be placed next to the dryer.
It is essential that the machine is leveled and the
locknuts are tight to prevent excessive vibration during
the spin cycles. Also be sure to leave a minimum of
1/2 inch (12.5 mm) of space between the washer and
the dryer.
ASKO washers can be installed beneath a cabinet or
worktop with a height of 34”. There must be a gap of
about 1/4” (.64 mm) all around the machine, including
between the rear edge of the machine top panel and
the back wall. The opening width must be at least 24”
(600 mm).
Space must also be available for the inlet and drain
hoses. See the diagram below for measurements and
positions.
BBUILUILTT-IN INST-IN INSTALLAALLATIONTION
NOTE: The height adjustment for the washer is
33-1/2” to 34-1/2” (850 mm to 876 mm).
Do not raise it higher than 34-1/2”.
STSTAACKED INSTCKED INSTALLAALLATIONTION
ASKO washers should never be stacked on a counter
or a dryer. You can, however, stack an ASKO dryer on an
ASKO washer. Refer to your Dryer Use and Care Guide
for instructions on how to do this.
If the drain outlet is higher than
24”, you will need to recess the
connections.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Asko w 620 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Asko w 620 in the language / languages: English as an attachment in your email.

The manual is 1,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Asko w 620

Asko w 620 User Manual - English - 2 pages

Asko w 620 User Manual - English - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info