702737
1
Zoom out
Zoom in
Previous page
1/2
Next page
- 1 -
GS218N
Glassbreak Detection Interface
Installation Manual
The GS218N is an interface unit that can
be used when you want to connect the
GS200 glass break detectors for balan-
ced DC loops to a control panel without
balanced loop connnection.
The GS218N can also be used if the
ballanced loop of the control panel has
a loop voltage lower than 6 V or if you
want to divide a large number of glass
break detectors into smaller zones
The detector should be connected to
terminals 3 and 4 (). Don’t forget the
6.8 kOhms End of Line resistor that is
supplied with the GS218N.
The GS218N normally has a latching
alarm relay. However, you can disable
this function by drilling a hole in the PCB
through the conductor trace, as shown
in the illustration n.
Technical data GS218N
Input power 10 V min - 15 V max; 12 V nom
Max. ripple at 12Vdc peak to peak 2 V
Current consumption
- Normal 5 mA at 12 V
- Alarm 17 mA at 12 V
End Of Line (EOL resistor) 6.8 Kohm
- Alarm output 120 mA at 15 V
- Tamper output 120 mA at 15 V
Number of detectors 20 max
Temperature limits -40
o
C min - +70
o
C max
Relative humidity 90 % max
Size (l x h x d) 82 x 24 x 24 mm
Weight 39 g
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aritech GS218N at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aritech GS218N in the language / languages: English as an attachment in your email.

The manual is 0,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info