1/ Power light
2/ Volume knob
3/ Frequency regulator knob
4/ Phase control knob
5/ High level inputs
6/ Line out
7/ Line in
8/ Power switch on/auto
9/ High level outputs
10/ Information on fuse replacement
11/ Power cable outlet (AC240V/50/60 Hz)
TO THE CUSTOMER:
Thank you very much for purchasing this
Argon audio subwoofer.
We have designed this product to be extremely easy
to operate but do read the instructions carefully to
maximize your long term enjoyment. Be sure not to
overload the speakers which can easily happen if the
volume is set too high. If you notice distortion please
turn the volume down quickly as permanent and
expensive damage can be caused by overloading
which is not covered by warranty. You can check this
out by going to our web page www.argonaudio.com.
Although your subwoofer comes with high level inputs
and outputs these are ideally only used for older amplifiers
or receivers which do not have the sub-out facility. If you
do have this facility then connect the subwoofer from sub-
out on the amp/receiver to either of the line inputs. In some
circumstances you will notice an improvement in the
subwoofers performance if you use a single line out to a
double line in from the amp/receiver to the subwoofer.
These connections are readily available from all hi-fi shops
of any note. The line output allows you to connect a second
subwoofer should you desire to do so. Simply run another
wire from the line outputs to the line input or line outputs of
the second subwoofer. If using a second subwoofer it is
recommended you have one either side of the room roughly
in line with the tower speakers and at least one metre clear
of a CRT television receiver.
Please note although this subwoofer is fitted with a
phase control it is highly unlikely you will need to adjust it.
Try with only the subwoofer operating rotating the knob
and settle on the setting which gives you more bass IE in
phase. The factory setting is correct in 99% of all cases.
Do avoid playing too long especially for extended periods
of time as this can cause damage to the amplifier and or the
speaker drive units or both.
Should you have any further queries please either contact
the retailer you purchased this unit from or us on
info@argonaudio.com
Once again thank you for purchasing a Argon audio
product and we trust you will have many years of trouble
free service.
FUNCTION
Output power 100w
Sensitivity 76db
Input sensitivity 440mv
Frequency response 40Hz-180Hz + - 3db
Power supply AC240V/50/60 Hz
HANDY HINTS
50/60Hz
AC240V/50/60Hz
