665616
7
Zoom out
Zoom in
Previous page
1/8
Next page
V 09/16
15
Choose a suitable place to position the radiator, considering the general safety warnings given in the first part of this
manual. Only use this radiator in an upright position.
Insert the plug into the electrical socket, ensuring that voltage is compliant with that specified on the convector data plate.
Select the desired temperature using the thermostat, turning
this knob clockwise: min. corresponds to minimum
temperature and max. to maximum level. The convector will
start operating only if the thermostat is above the minimum
temperature.
Then choose the power level desired through the
power selector.
Room thermostat
min = (min. temperature)
max = (max. temperature)
Power selector
0 = OFF
I = 800 W (min.) (9) – 1000 W (11)
II = 1200 W (med.)(9) - 1500 W (11)
III = 2000 W (max.)(9) - 2500 W (11)
Room temperature can be regulated by rotating the thermostat clockwise to increase or anticlockwise to
decrease temperature.
When turning the panel on, we recommend turning the thermostat knob to maximum: then, when a pleasant room
temperature has been obtained, turn the thermostat dial anticlockwise until the light of the active switch goes out. This
way the panel will maintain that room temperature constant.
To turn the convector off completely turn the power selector back to 0 and then rotate the thermostat dial anticlockwise
until it clicks off. Unplug the appliance if it will not be used for a while.
OVERHEATING SAFETY DEVICE
In the event of overheating, an additional fitted safety thermostat protects the heater against overheating and switches it
off automatically.
If the device switches itself off, disconnect the main plug from the socket.
The heater is ready for use after a short cooling-off phase (approx. 15 minutes). Plug the mains back into the socket.
If this repeats, first check that the thermostat switch is set correctly or if an object hinders the heating operation.
HOW TO CLEAN THE RADIATOR
Always unplug and leave the radiator to cool before cleaning.
Use a damp cloth to clean the radiator exterior and remove dust. Leave the casing to dry before using the convector
again.
Do not allow water to enter the radiator.
Do not use benzene, solvents or abrasive compounds to clean the radiator, as these may damage the casing.
Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
Ensure that the radiator is dry before inserting the plug.
Do not use metal tools to clean the convector radiator. Any metal fragments that may detach may come into contact
with the panel’s electrical components and cause a short-circuit.
In the event of malfunctions or damages, always contact an authorised service centre.
STORAGE OF RADIATOR
If the radiator is not used for prolonged periods, it must be stored together with this manual in its original packaging, in a
cool and dry place. Never put the appliance away when still hot. Always wait for it to cool down.
HOW TO USE THE RADIATOR
1 2
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo Silence 11 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo Silence 11 in the language / languages: English as an attachment in your email.

The manual is 0,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo Silence 11

Argo Silence 11 User Manual - German - 8 pages

Argo Silence 11 User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info