665478
75
Zoom out
Zoom in
Previous page
1/76
Next page
51
PREPARATION DE LA TELECOMMANDE
l Retirez le couvercle en plastique de la borne de la télécommande.
l Ouvrez le compartiment des piles, retirer les piles et régler les interrupteurs 5 et 6 en la position OFF.
l Fermez le compartiment des piles sans mettre les piles (la télécommande sera alimentée par le câble).
LIAISON
Utilisez un câble électrique tripolaire blindé 0,5mm
2
, longueur max.15m. Le câble doit être de type H05VVC4V5-K
minimum (selon CEI 20-20 CENELEC HD21).
RELIER LA TELECOMMANDE A LA BORNE 5 POLES A L’INTERIEUR DU TABLEAU ELECTRIQUE, COMME
SUIT:
l Retirez le câble "pont" entre les terminals 2 et 4.
l Connecter le terminal 1 avec la borne inférieure de la plaque à bornes de la télécommande (pole +).
l Connecter le terminal 2 avec la borne centrale de la plaque à bornes de la télécommande (IR).
l Connecter le terminal 3 avec la borne supérieure de la plaque à bornes de la télécommande (polo -).
VORBEREITUNG DER FERNBEDIENUNG
l Entfernen Sie die Plastikabdeckung vom Terminal der Fernbedienung.
l Öffnen Sie das Batteriefach, entfernen Sie die Batterien und die Schalter 5 und 6 in die Position OFF stellen.
l Schließen Sie das Batteriefach ohne die Batterien wiederzusetzen (die Fernbedienung wird mit dem Kabel
angeschlossen).
ANSCHLUSS
Verwenden Sie ein elektrisches dreipoliges Aschirmkabel 0,5mm
2
, Länge max.15m. Das Kabel soll nicht leichter als
H05VVC4V5-K-Typ sein (gemäß CEI 20-20 CENELEC HD21).
SCHLIESSEN SIE DIE FERNBEDIENUNG AN DEN KLEMMENBLOCK 5P IM SCHALTSCHRANK, WIE FOLGT:
l Entfernen Sie das „Brücke“ Kabel zwischen Terminal 2 und 4.
l Schließen Sie das Terminal 1 mit dem unteren Anschluss der Klemme auf der Fernbedienung (positive).
l Schließen Sie das Terminal 2 mit dem zentralen Anschluss der Klemme auf der Fernbedienung(IR).
l Schließen Sie das Terminal 3 mit dem oberen Anschluss der Klemme auf der Fernbedienung (negativen).
PREPARACIÓN DEL MANDO A DISTANCIA
l Quitar la tapa de plástico del terminal del mando a distancia.
l Abrir el compartimiento de las pilas, extraer las pilas y ajustar los interruptores 5 y 6 en la posición OFF.
l Cerrar el compartimiento de las pilas sin poner las pilas (el mando a distancia sera alimentado por el cable).
CONEXIÓN
Utilizar un cable eléctrico tripolar blindado de 0,5 mm
2
, longitud max.15m. El cable no debe ser más ligero del tipo
H05VVC4V5-K (según CEI 20-20 CENELEC HD21).
CONECTAR EL MANDO A DISTANCIA AL TERMINAL 5P DEL PANEL ELÉCTRICO, COMO SIGUE:
l Retirar el cable puente entre los terminales 2 y 4.
l Conectar el terminal 1 con el terminal inferior del bloque de terminales del mando a distancia (positivo).
l Conectar el terminal 2 con el terminal central del bloque de terminales del mando a distancia (IR).
l Conectar el terminal 3 con el terminal superior del bloque de terminales del mando a distancia (negativo).
PREPARAÇÃO DO CONTROLO REMOTO
l Remover a tampa de plástico da placa de terminais do controlo remoto.
l Abrir o compartimento das pilhas, remover as pilhas e colocar os microinterruptores 5 e 6 em posição OFF.
l Fechar o compartimento das pilhas sem voltar a colocar as pilhas (o controlo remoto será alimentado por um fio).
LIGAÇÃO
Utilizar um fio elétrico tripolar blindado 0,5mm
2
, comprimento máx. 15m. O fio não deve ser mais ligeiro que o tipo
H05VVC4V5-K (de acordo com CEI 20-20 CENELEC HD21).
LIGAR O CONTROLO REMOTO À PLACA DE TERMINAIS DE 5 PÓLOS NO INTERIOR DO QUADRO ELÉTRICO,
DO SEGUINTE MODO:
l Remover o fio “jumper” entre os terminais 2 e 4.
l Conectar o terminal 1 ao terminal inferior da placa de terminais no controlo remoto (pólo +).
l Conectar o terminal 2 ao terminal central da placa de terminais no controlo remoto (IR).
l Conectar o terminal 3 ao terminal inferior da placa de terminais no controlo remoto (pólo -).
¶ƒ√∂Δ√πª∞™π∞ Δ∏™ ™À™∫∂À∏™ Δ∏§∂Ã∂πƒπ™ª√À
l ∞Ê·ÈÚ¤ÛÙ ÙÔ ÌÈÎÚfi Ï·ÛÙÈÎfi Î¿Ï˘ÌÌ· Ù˘ ϷΤٷ˜ ·ÎÚÔ‰ÂÎÙÒÓ Ù˘ Û˘Û΢‹˜ ÙËϯÂÈÚÈÛÌÔ‡.
l ∞ÓÔ›ÍÙ ÙË ı‹ÎË ÙˆÓ Ì·Ù·ÚÈÒÓ, ·Ê·ÈÚ¤ÛÙ ÙȘ Ì·Ù·Ú›Â˜ Î·È Ú˘ıÌ›ÛÙ ÙÔ˘˜ ÌÈÎÚԉȷÎfiÙ˜ 5 Î·È 6 ÛÙË ı¤ÛË
OFF.
l ∫Ï›ÛÙ ÙË ı‹ÎË ÙˆÓ Ì·Ù·ÚÈÒÓ ¯ˆÚ›˜ Â·Ó·ÙÔÔıÂÙ‹ÛÂÙ ÙȘ Ì·Ù·Ú›Â˜ (Ë Û˘Û΢‹ ÙËϯÂÈÚÈÛÌÔ‡ ı·
ÙÚÔÊÔ‰ÔÙËı› ·fi ÙÔ Î·ÏÒ‰ÈÔ).
™À¡¢∂™∏
ÃÚËÛÈÌÔÔÈ‹ÛÙ ¤Ó· ÙÚÈÒÓ fiÏˆÓ ËÏÂÎÙÚÈÎfi ıˆÚ·ÎÈṲ̂ÓÔ Î·ÏÒ‰ÈÔ 0,5mm
2
, ̤ÁÈÛÙÔ Ì‹ÎÔ˜ 15m. ΔÔ Î·ÏÒ‰ÈÔ ‰ÂÓ Ú¤ÂÈ
Ó· Â›Ó·È ÈÔ ÂÏ·ÊÚ‡ ·fi ÙÔÓ Ù‡Ô H05VVC4V5-K (Û‡Ìʈӷ Ì CEI 20-20 CENELEC HD21)..
™À¡¢∂™Δ∂ Δ∏ ™À™∫∂À∏ Δ∏§∂Ã∂πƒπ™ª√À ™Δ∏¡ ¶§∞∫∂Δ∞ ∞∫ƒ√¢∂∫Δø¡ 5 ¶√§ø¡ ™Δ√ ∂™øΔ∂ƒπ∫√ Δ√À
∏§∂∫Δƒπ∫√À ¶π¡∞∫∞, ø™ ∂•∏™:
l ∞Ê·ÈÚ¤ÛÙ ÙÔ Î·ÏÒ‰ÈÔ Ù˘ Á¤Ê˘Ú·˜ (2-4).
l ™˘Ó‰¤ÛÙ ÙÔÓ ÙÂÚÌ·ÙÈÎfi 1 Ì ÙÔ Î¿Ùˆ ÙÂÚÌ·ÙÈÎfi Ù˘ ϷΤٷ˜ ·ÎÚÔ‰ÂÎÙÒÓ ÛÙË Û˘Û΢‹ ÙËϯÂÈÚÈÛÌÔ‡ (fiÏÔ˜ +).
l ™˘Ó‰¤ÛÙ ÙÔÓ ÙÂÚÌ·ÙÈÎfi 2 Ì ÙÔ ÎÂÓÙÚÈÎfi ÙÂÚÌ·ÙÈÎfi Ù˘ ϷΤٷ˜ ·ÎÚÔ‰ÂÎÙÒÓ ÛÙË Û˘Û΢‹ ÙËϯÂÈÚÈÛÌÔ‡ (IR).
l ™˘Ó‰¤ÛÙ ÙÔÓ ÙÂÚÌ·ÙÈÎfi 3 Ì ÙÔ Â¿Óˆ ÙÂÚÌ·ÙÈÎfi Ù˘ ϷΤٷ˜ ·ÎÚÔ‰ÂÎÙÒÓ ÛÙË Û˘Û΢‹ ÙËϯÂÈÚÈÛÌÔ‡ (fiÏÔ˜ -).
F
D
E
P
GR
75


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo SDIBS9DC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo SDIBS9DC in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 5,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo SDIBS9DC

Argo SDIBS9DC User Manual - English - 15 pages

Argo SDIBS9DC User Manual - German - 15 pages

Argo SDIBS9DC User Manual - French - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info