665477
74
Zoom out
Zoom in
Previous page
1/76
Next page
50
REMOTE CONTROLLER: HOW TO CHANGE FROM INFRARED TO WIRED •
TELECOMANDO: TRASFORMAZIONE
DA INFRAROSSI A FILO
• TELECOMMANDE: TRANSFORMATION DE INFRAROUGE A FIL •
FERNBEDIENUNG:
WANDEL VOM INFRAROT ZU KABEL
• MANDO A DISTANCIA: CAMBIO DE INFRARROJOS A CABLE •
UNIDADE
DE CONTROLE REMOTO: MUDANCA DE INFRAVERMELHO A FIO
TTHHLLEECCEEIIRRIISSTTHHRRIIOO
: °È· ÙËÓ ÂÓÙÔÏ‹ ª∂
∫∞§ø¢π√
PREPARE THE REMOTE CONTROLLER
l Detach the plastic cover of the remote controller terminal block.
l Open the batteries compartment, remove the batteries and set microswitches 5 and 6 in OFF position.
l Close the compartment without replacing the batteries (remote controller will be powered by wire).
CONNECTION
Use a tripolar electric shielded wire 0,5mm
2
, max. length 15m. The wires have not to be lighter than Mod. H05VVC4V5-
K (according to CEI 20-20 CENELEC HD21).
CONNECTING THE REMOTE CONTROLLER TO THE 5 POLES TERMINAL BLOCK INSIDE THE ELECTRICAL
PANEL, AS FOLLOWS:
l Remove the “bridge” wire between the terminals 2 and 4.
l Connect the terminal 1 to the bottom terminal of remote control terminal block (+ pole).
l Connect the terminal 2 to the medium terminal of remote control terminal block (IR).
l Connect the terminal 3 to the upper terminal of remote control terminal block (- pole).
PREPARAZIONE DEL TELECOMANDO
l Staccare il coperchietto in plastica della morsettiera del telecomando.
l Aprire il vano batterie, rimuovere le batterie e settare i microinterruttori 5 e 6 in posizione OFF.
l Chiudere il vano batterie senza rimettere le batterie (il telecomando sarà alimentato da filo).
COLLEGAMENTO
Utilizzare un cavo elettrico tripolare schermato 0,5mm
2
, lunghezza max. 15m. Il cavo non deve essere più leggero del
tipo H05VVC4V5-K (secondo CEI 20-20 CENELEC HD21).
COLLEGARE IL TELECOMANDO ALLA MORSETTIERA 5 POLI ALL’INTERNO DEL QUADRO ELETTRICO, COME
SEGUE:
l Rimuovere il cavo ponte tra i morsetti 2 e 4.
l Connettere il morsetto 1 con il terminale inferiore della morsettiera sul telecomando (polo +).
l Connettere il morsetto 2 con il terminale centrale della morsettiera sul telecomando (IR).
l
Connettere il morsetto 3 con il terminale superiore della morsettiera sul telecomando (polo -).
I
EG
74


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo SDIAS8DC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo SDIAS8DC in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 5,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo SDIAS8DC

Argo SDIAS8DC User Manual - English - 15 pages

Argo SDIAS8DC User Manual - German - 15 pages

Argo SDIAS8DC User Manual - French - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info