724566
4
Zoom out
Zoom in
Previous page
1/15
Next page
4
HOW TO INSTALL BATTERIES
l Remove trhe lid in the rear part of the remote control
unit and check the settings of the dipswitch as shown
below:
USING THE REMOTE CONTROL UNIT
OPERATION WITH THE REMOTE CONTROL UNIT
When using the remote control unit, always point the
remote control unit directly at the air conditioner receiver.
HOW TO TURN ON OR OFF THE AIR CONDITIONER
Press the ON/OFF button on the remote control unit to
turn the air conditioner on or off. The operation lamp will
light up, indicating the unit is in operation and vice versa.
l
Insert two AAA alkaline batteries of 1,5 V-DC making
sure that point in the direction marked in the battery
compartment.The displayed time flashes.
Press the ST button and set time.
Remote controller is now ready for operation.
l
The batteries last about six months. Depending on how
much you use the remote control unit.
Remove the batteries if you do not use the remote
control unit for more than one month.
Replace the batteries when the remote control unit
lamp fails to light, or when the air conditioner does not
receive the remote control unit signals.
l
The batteries of the remote control contain polluted
substances exhausted batteries must be disposed
according to the laws in force.
HOW TO REMOVE BATTERIES
l Remove the lid.
l Press the battery
toward the
negative end
and lift it out by
its positive end
(as shown in the
figure).
l Remove the other
battery in the same
way.
SWITCHES
TEMPERATURE SENSOR SELECTOR
l
Under normal conditions the room temperature is
detected and checked by the temperature sensor placed
in the remote controller (I FEEL icon displayed ).This
function is designed to provide a comfortable room
temperature by transmitting the temperature control
command from the location next to you. When using this
function, the remote, control should always be pointed
at the air conditioner, therefore it should be placed in
a position in which it is visible by the indoor unit (for
example, do not put it in a drawer).
l
It is possible to disable the remote controller room
sensor pressing the I FEEL button. In this case the I
FEEL icon on the remote controller display lights off and
only the sensor placed in the air conditioner becomes
active.
The remote control unit transmits signals to the
indoor unit each time you press a key and at any
temperature change detected by the IFEEL sensor. In
case of troubles (low batteries, remote control placed
in a position not visible by the indoor unit,...) room
temperature control is automatically switched to the
sensor of the indoor unit. In this case, the temperature
around the remote control unit may differ from the
temperature detected in the air conditioner position.
NOTE
TRANSMITTER
REMOTE
CONTROL UNIT
UNIT
RECEIVER
The air conditioner still operates for 30 seconds after
receiving the switch off signal.
NOTE
EN
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo DD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo DD in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo DD

Argo DD Installation Guide - English - 16 pages

Argo DD Installation Guide - German - 16 pages

Argo DD User Manual - German - 16 pages

Argo DD Installation Guide - French - 16 pages

Argo DD User Manual - French - 16 pages

Argo DD User Manual - Italian - 16 pages

Argo DD Installation Guide - Italian - 16 pages

Argo DD User Manual - Portuguese - 16 pages

Argo DD Installation Guide - Portuguese - 16 pages

Argo DD User Manual - Spanish - 16 pages

Argo DD Installation Guide - Spanish - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info