Manual Angelcare AC601-A (page 4 of 35) (English, French, Spanish)

681992

Zoom out

Zoom in

1/35

16.10 DO NOT attempt to rejuvenate the

batteries provided with or identified for

use with this product by heating them.

Sudden release of battery electrolyte may

occur, causing burns or irritation to eyes

or skin.

16.11 If and when necessary, the batteries

must be replaced with identical new ones

or equivalent (volts and size). If a battery

to be replaced is connected with other

batteries in series, replace the other

batteries at the same time as well. DO

NOT mix old and new batteries.

16.12 Reverse polarity installation of the

batteries in the end product must be

avoided. Reverse insertion of batteries

can cause charging, and that may result

in leakage or explosion.

16.13 Remove batteries from this product

if you store the product over 30 days

because the batteries could leak and

damage the product.

16.14 Discard ‘dead’ batteries as soon as

possible since ‘dead’ batteries are more

likely to leak in a product. If a battery has

leaked or vented, it should be replaced

immediately using protective gloves.

16.15 DO NOT store this product, or the

batteries provided with or identified for

use with this product, in high-temperature

areas.

WARNING

(North America Only)

17.1 Modifications not authorized by the

manufacturer may void users authority to

operate this device.

17.2 NOTE: This equipment has been tested

and found to comply with Part 15 of the

FCC Rules and the Industry Canada licence-

exempt RSS standard(s). These limits are

designed to provide reasonable protection

against harmful interference in a residential

installation. This equipment generates, uses

and can radiate radio frequency energy

and, if not installed and used in accordance

with the instructions, may cause harmful

interference to radio communications.

17.3 However, there is no guarantee that

interference will not occur in a particular

installation. If this equipment does cause

harmful interference to radio or television

reception, which can be determined by

turning the equipment OFF and ON, the

user is encouraged to try to correct the

interference by one or more of the following

measures:

• Reorient or relocate the receiving

antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.

17.4 This device complies with part 15 of the

FCC Rules and the Industry Canada licence-

exempt RSS standard(s). Operation is subject

to the folowing two conditions:

(1) This device may not cause harmful

interference, and

(2) This device must accept any interference

received, including interference that may

cause undesired operation.

IMPORTANT

Place the crib near a supporting wall and far from air

currents. Install the Nursery Unit on a flat, stable surface

facing the crib at a distance of at least 3 feet (0.9 meter).

Make sure to plug the adapter to the socket outlet nearest

to the equipment and that is easily accessible.

YOU MUST PREPARE:

One hardboard (not included)

Thickness: 1/4’’ (6 mm)

Minimum dimensions:

13” x 13” (33 x 33 cm)

Maximum dimensions:

equal to the mattress size

WHAT YOU WILL NEED (NOT INCLUDED):

Parent Unit

2 AC Adapters

Miniature Phillips

Screwdriver

3 Rechargeable AAA Batteries

for Parent Unit

4 Alkaline

AAA Batteries

for Nursery Unit

Nursery Unit

MOVEMENT SENSOR

WITH SOUND MONITOR

Model AC601-A

IMPORTANT

The hardboard must be larger than

the Sensor Pad surface area.

BABY’S ROOM:

SETUP REQUIREMENTS

2X 3X

INCLUDED:

32 1

1 Sensor Pad (AC601-A) with pre-installed cord covers

Hardboard

32 1

IMPORTANT

Keep

at least

1 m

apart

Sensor Pad

FCC AND IC REGULATIONS

RF radiation exposure statement

The Nursery Unit complies with FCC RF radiation exposure limits set forth for an uncontrolled

environment. Caution: To maintain the compliance with the FCC’s RF exposure guideline,

install the Nursery Unit at least 20 cm from ALL persons. The transmitter of this device must

not be co-located or operating in conjunction with any other antenna or transmitter.

Industry Canada

This product meets the applicable Industry Canada technical specifications.

CAN ICES-3 (B)/NMB-3 (B)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Angelcare AC601-A in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 7,04 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Angelcare AC601-A Manual

Product: