682016

Angelcare AC215 Manual

4
Zoom out
Zoom in
Previous page
1/25
Next page
15.16 Antenna - The antenna used for this transmitter must be installed
to provide a separation distance of at least 20 cm from all persons and
must not be collocated or operating in conjunction with any other antenna
or transmitter.
15.17 Power Lines - An outside antenna system should NOT be located
in the vicinity of overhead power lines or other electric light or power
circuit, or where it can fall into such power lines or circuits as contact
with them may be fatal.
15.18 Vibration Source - When the monitor is in use, DO NOT use
a bedside cot, cot mobile or other cot accessories that may produce
vibrations. Other sources of vibrations may include fans, washing
machines, loud music, etc. These sources of vibration may interfere
with the performance of your Angelcare
®
monitor and the alarm will not
sound if it continues to detect any movement other than your baby’s.
Be sure all vibration sources are eliminated before using the monitor.
You may experience false alarms for several reasons. The most
common reason is the Camera has not been turned OFF af t e r
you have removed your baby from the cot. Another reason is the
Sensor Pad has not been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm surface with the printed side facing
up. The sensitivity level may also need to be adjusted. Refer to Step 5.1.
Always be sure to immediately check on baby whenever an alarm sounds.
15.19 Sensor Pad - Your Sensor Pad can be used in any cot that is stationary.
If the cot has a spring or slat base, place a hard board between the cot base
and the Sensor Pad measuring at least 33 x 33 cm and 6 mm thick. Only
use your Angelcare
®
monitor in a stationary sleeping environment such
as a cot where the Sensor Pad can rest on a completely flat, firm surface.
The Sensor Pad is made of plastic and does not permit the air to circulate.
The refore, mild ew build u p could develo p undernea th the mat tress in th e Senso r
Pad area. We suggest rotating the mattress regularly to prevent any mildew.
16. IMPORTANT SAFETY INSTRUCTIONS
RELATED TO USE OF BATTERIES
16.1 Use ONLY the type and size of batteries specified in the owner’s manual.
There is a risk of explosion if batteries are replaced with an incorrect type.
16.2 Charge the battery for 9 hours prior to first use. Be sure to have the
monitor in the OFF position during this period. ONLY use the adapters
included with your monitor.
16.3 DO NOT use these adapters with any other equipments.
16.4 When unplugging the adapter from the Camera, be sure it is switched
to the OFF position. If it isn’t, the unit will revert to battery mode if
batteries are installed.
16.5 DO NOT dispose batteries in fire. They may explode. Check with local
regulations for possible special disposal instructions.
16.6 Exercise care in handling batteries in order not to short out the
batteries with conducting materials such as rings, bracelets and keys.
Overcharging, short circuiting, reverse charging, mutilation, or incineration
of batteries must be avoided to prevent one or more of the following
occurrences: release of toxic materials, release of hydrogen and/or oxygen,
gas and rise in surface temperature.
16.7 DO NOT attempt to recharge batteries provided with or identified for
use with this product that are not intended to be charged. The batteries
may leak corrosive electrolyte or explode.
16.8 DO NOT attempt to rejuvenate the batteries provided with or identified
for use with this product by heating them. Sudden release of battery
electrolyte may occur, causing burns or irritation to eyes or skin.
16.9 If and when necessary, the batteries must be replaced with identical
new ones or equivalent (volts and size). If a battery to be replaced is
connected with other batteries in series, replace the other batteries at the
same time as well. DO NOT mix old and new batteries.
16.10 Reverse polarity installation of the batteries in the end product must
be avoided. Reverse insertion of batteries can cause charging, and that
may result in leakage or explosion.
16.11 Remove batteries from both units if you store the product over 30
days because the batteries could leak and damage the product.
16.12 Discard ‘dead’ batteries as soon as possible since ‘dead’ batteries
are more likely to leak in a product. If a battery has leaked or vented, it
should be replaced immediately using protective gloves.
16.13 DO NOT store this product, or the batteries provided with or identified
for use with this product, in high-temperature areas.
3
E
N
01CFO2A_Manuel_AC215_EN_UK_12647.indd 3 17-12-19 07:51
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Angelcare AC215 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Angelcare AC215 in the language / languages: English as an attachment in your email.

The manual is 7,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info