635922
3
Zoom out
Zoom in
Previous page
1/3
Next page
Operating Instructions - ET 21 & 25
Click www.andrews-sykes.com or Call Us Free 0800 211 611
Problem Likely Cause Solution
Not working
Power plug incorrectly
connected
Connect plug correctly
Power button OFF Press POWER button to ON
Blown fuse in mains plug Replace fuse (MUST BE 13 amp)
Fuse (supply) blown Exchange fuse in board
Breaker on switch board
tripped
Check load capacity and reset
Ambient temp. too high Use only below 45˚C
(HSC-3500 : 40˚C)
Poor cooling
performance
Filter blocked with dust Clean filter
Dust in heat exchanger Clean heat exchanger
Obstacle against inlet
side
Remove and allow 50cm clearance
Ambient temp. too high Use only below 45˚C
(HSC-3500 : 40˚C)
E1 Exhaust fan is not
operating
Check the power supply or replace
the motor
Hot air being restricted
from leaving the
machine
Unblock or relocate exhaust hose
E2 Refrigerant is leaking.
Check with manifold
gauge
Supply optimum refrigerant and check
the leakage. (By authorised service
personnel only)
E3 Thermistor sensor wire
is cut
Change the thermistor sensor
AF (Freezing) Evaporator is frozen
(Ambient temp. is under
20˚C)
Operate continuesly until “AF”
disappears or operate in “FAN” mode
Insulation exhaust Duct
This new insulated exhaust duct reduces diameter from 17" (43cm) down to 12"
(30 cm) thereby making it easier to handle. Being 3 metres long, it can either
be ducted out of a window or vertically up into a ceiling void. The duct is also
insulated which improves the cooling efficiency because heat is not being put back
into the room / are. (Max. exhaust duct length 9mtr)
The open end (12" diam) has a velcro cuff and this enables easy and efficient fitting
of out 3 metre extension lengths which also have velcro cuffs. Loops are tted to
both reducer duct and extensions should support be necessary.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Andrews ET 21 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Andrews ET 21 in the language / languages: English as an attachment in your email.

The manual is 0,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info