794738
13
Zoom out
Zoom in
Previous page
1/16
Next page
13
OPERATION AND MAINTENANCE
Use control panel to control your cooker hood (Fig. 4)
When the control panel shows dot (without any
additional symbols), hood is in StandBy mode. To
activate sensor control panel, please move your
nger horizontal on the panel on all sensors from
left.
OPERATIONAL SAFETY
All safety instructions included in chapter IV must
be observed. Textile grease lters and carbon l-
ters should be replaced and aluminium lter should
be cleaned according to manufacturer’s instruc-
tions, or more frequently in periods of intensive use
(more than 4 hours a day). If a gas cooker is used it
is for- bidden to leave the ame uncovered. When
removing pots from gas burners set the ame to its
minimum level. Always make sure that ame does
not extend outside the pot. Such a situation causes
undesired energy losses and dangerous heat build-
ups. The hood should not be used for other pur-
poses than those for which it was designed.
OPERATION
2.1 Control Panel
The cooker hood can be controlled using a control
panel (Fig. 4)
- “-” and “+” touch sensors control cooker hood fan
speed in the range from 1 to 3,
- “+” touch sensor increases cooker hood fan speed
- “-” touch sensor reduces cooker hood fan speed
- Timer touch sensor activates fan timer (max 90
min.)
- This touch sensor is used to clear the ashing “F
“ or “C “, and also to set the child lock safety device
(details below),
- Lights “L” touch sensor switches cooker hood
lights on/off independently of fan operation. Press
for a short time to switch on/off lights.
Press and hold for approximately 2 seconds to re-
duce maximum light intensity by one level.
Sets the delay time remaining until the fan is
turned off
- This cooker hood has a timer function, which con-
trols fan operation. It can be programmed to auto-
matically switch off the fan after 10 to 90 minutes in
10 minutes intervals.
– In order to activate the timer function set the
cooker hood fan at a required speed by pressing
the “+” touch sensor and then touch the timer
(clock) touch sensor. The display will show a ash-
ing 0 to indicate that timer setup mode is activated.
Now select the delay time to switch off the cooker
hood fan by touching ‘’+‘’, keeping in mind that the
number displayed musts be multiplied by the 10
minute interval
(For example 1=10 min, 2=20 min,3=30 min, and
so on)
– Once the required delay time is set, conrm it by
touching the timer (clock) symbol again. The display
will stop ashing and indicate current fan speed. A
small ashing dot by the value corresponding to fan
speed indicates that timer is counting down.
To cancel the fan timer function, touch the timer
(clock) sensor while the countdown timer is run-
ning.
The cooker hood is equipped with an electronic
lter saturation indicator:
- Replace the charcoal lter – “C” is displayed (220
hours of operation),
- Clean the aluminium lter – “F” is displayed (100
hours of operation),
Neither of these indications affects cooker hood op-
eration, however when C or F is shown, fan speed
indication (0 to 3) is not displayed until the C or F
symbol is cleared.
Once the lter is replaced or cleaned the symbol
can be cleared by touching the timer (clock) sensor.
The cooker hood has a child lock safety device.
This function is also useful when cleaning the cook-
er hood control panel:
- in order to activate/deactivate the child lock safety
device, touch and hold for approximately 3 seconds
the timer (clock) sensor.
Note: The timer function must be acti-
vated within 20 seconds. If no action
is taken the cooker hood will switch to
normal operation mode. Electronics
protected with a 250V-1.6 A fuse / quick
acting (5x20 glass fuse-element).
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Amica OKC6726I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Amica OKC6726I in the language / languages: English as an attachment in your email.

The manual is 1.04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info