541733
5
Zoom out
Zoom in
Previous page
1/11
Next page
3. CONTROL ELEMENTS
SPOTLIGHT
6
7
LIMITER SWITCH
Set the switch at "ON" position, if a very high level signal is driven into the amplifier,
the clip begins, thus keeping consistent output level for protecting apparatus.
If the switch is set at "OFF" position, this clip function doesn't work.
8
OUTPUT CONNECTOR
These connectors have two kinds: 1/4 TRS jack and Neutrik connector. You can
choose proper connectors according to practical need. For your safety, please
be careful when do connecting work.
9
10
BALANCED INPUT CONNECTOR
These connectors are used to connect the input signal of CH 1 and CH 2 separately.
3
AC INLET AND FUSE HOLDER
Connect the supplied main cord. Do not insert the power cord into the MISTRAL
400 amplifier and into the AC Outlet until voltage has been correctly set.
If the fuse blows, replaced with a fuse of the correct type only.
Rear panel
MODE SELECTOR
The MISTRAL 400 power amplifier presents two operating modes:
- Stereo Mode
In this mode, CH 1 and CH 2 operate independently (as a normal stereo amplifier).
The CH 1 input signal will be output from the CH 1 output connector, and CH 2
input signal will be output from the CH 2 output connector.
- Bridge Mode
In this mode, CH 1 input signal will be output from the bridge-mono output connector.
On the other hand, the output level control of CH 2 should be turned to the minimum.
10
9
8
7
6
CH2
INPUT
CH1
POWER
OUTPUTS
LIMITER
OFF
ON
TIP
SP
SP
TIP
SP
SP
MODE
BRIDGE
STEREO
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
CH1
1+ 1-
POS NEG
CH2
2+ 2-
POS NEG
BRIDGE
1+ 2+
POS NEG
CH2
1+ 1-
POS NEG
21
3
NEW TIDE
21
3
NEW TIDE
CH2 CH1
AC INPUT:110-120V 50-60Hz
FUSE: T3.15AL 250VAC
Rated Power Consumption 200W
REPLACE FUSE WITH CORRECT TYPE ONLY
Apparaten skall anslutas
ansluts till ett natverk
till jordat uttag nar den
Class
two wiring
Class
two
wiring
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alto Professional MISTRAL 400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alto Professional MISTRAL 400 in the language / languages: English as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info