471428
34
Zoom out
Zoom in
Previous page
1/36
Next page
32-EN
No picture is produced.
Monitor's mode is not switched to the mode you want to see.
- Switch to the mode you want to see.
Monitor's parking brake cord is not connected.
- Connect the monitor's parking brake cord and set the parking
brake. (For details, refer to the monitor's instructions.)
Monitor's parking brake is not set.
- Connect the monitor's parking brake cord and set the parking
brake. (For details, refer to the monitor's instructions.)
Playback does not start.
Disc is loaded upside-down.
- Check the disc and load it with the labeled side facing
upward.
The disc is dirty.
- Clean the disc.
A disc not able to playback with this unit is loaded.
- Check if the disc is able to be played back.
Parental lock is set.
- Cancel the parental lock or change the rating level.
Setup menu is displayed.
- Press SETUP to turn the menu off.
Picture is unclear or noisy.
Disc is being fast-forwarded or fast-reversed.
- The picture may be unclear, but this is normal.
Vehicle's battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
Monitor's uorescent tube is worn out.
- Replace the monitor's uorescent tube.
Image stops sometimes.
Disc is scratched.
- Replace with a non-scratched disc.
No picture display.
Brightness control is set for minimum brightness control.
- Adjust the brightness.
Incorrect setting of the mode.
- Switch to the correct mode.
- Check the connection to the source unit.
- Check the power of the source unit.
Incorrect or open connection with the Monitor, AV interface
unit.
- Check the connection and remedy.
Picture color is poor.
Brightness/Color/Tint/Contrast/Sharpness control are not set to
the proper positions.
- Check each control.
Spots or dotted lines/stripes appear.
Caused by neon signs, high-voltage power lines, CB
transmitter, other vehicle’s ignition plugs, etc.
- Change the location of your vehicle.
Unit does not operate.
Monitor’s power is not turned on.
- Turn on the monitor’s power.
Due to continuous product improvement, speci cations and
design are subject to change without notice.
In Case of Dif culty
If you encounter a problem, please turn the power off, then on
again. If the unit is still not functioning normally, please review the
items in the following checklist. This guide will help you isolate the
problem if the unit is at fault. Otherwise, make sure the rest of your
system is properly connected or consult your authorized Alpine
dealer.
No function or display.
Vehicle's ignition is off.
- If connected following the instructions, the unit will not
operate with the vehicles ignition off.
Improper power lead connections.
- Check power lead connections.
No fuse or blown fuse.
- Replace the fuse on the battery lead of the unit with the
proper value.
Vehicle’s battery is weak.
- Check the voltage of vehicle’s battery.
Disc playback sound is wavering.
Moisture condensation in the disc unit.
- Allow enough time for the condensation to evaporate (about
1 hour).
Disc insertion not possible.
A disc is already in the DVD player.
- Eject the disc and remove it.
The disc is being improperly inserted.
- Re-insert the disc following the instructions in the "Loading
and Unloading Discs" section.
Unable to fast forward or reverse the disc.
The disc has been damaged.
- Eject the disc and discard it; using a damaged disc in your
unit can cause damage to the mechanism.
Disc playback sound skips due to vibration.
Improper mounting of the unit.
- Securely re-mount the unit.
The disc is very dirty.
- Clean the disc.
The disc has scratches.
- Change the disc.
The pick-up lens is dirty.
- Do not use a commercial available lens cleaner disc.
Consult your nearest ALPINE dealer.
Disc playback sound skips without vibration.
Dirty or scratched disc.
- Clean the disc; damaged disc should be replaced.
CD-R/CD-RW playback not possible.
Close session ( nalization) has not been performed.
- Perform nalization and attempt playback again.
Error displays
Mechanical error
- Press . After the error indication disappears, insert the disc
again. If the above-mentioned solution does not solve the
problem, consult your nearest ALPINE dealer.
Unit does not operate.
Monitor's power is not turned on.
- Turn on the monitor's power.
Condensation
- Wait a while (about 1 hour) for the condensation to dry.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine PKG-2100P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine PKG-2100P in the language / languages: English as an attachment in your email.

The manual is 3,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alpine PKG-2100P

Alpine PKG-2100P User Manual - German - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info