471389
35
Zoom out
Zoom in
Previous page
1/37
Next page
33-EN
Full Speed Connector
Control iPhone/iPod signals.
Connect this to an iPhone/iPod by using FULL SPEED Connection
Cable (KCE-433iV) (sold separately for CDE-111R/CDE-111RM/
CDE-113BT) or to an external device (such as a portable player) by
using conversion cable (KCE-237B) for building up the AUX IN (sold
separately).
Note
Refer to “Setting the AUX+ SETUP Mode” on page 19.
AUX+ ON :
When the external device is connected.
AUX+ OFF :
When an iPhone/iPod is connected.
You can also connect this to an optional BLUETOOTH INTERFACE
(KCE-400BT) (CDE-111R/CDE-111RM/CDE-112Ri only). To use a
hands-free mobile phone, an optional BLUETOOTH INTERFACE
(KCE-400BT) connection is required. For details on connection, refer
to the Owners Manual of the BLUETOOTH INTERFACE (KCE-400BT).
Antenna Receptacle
Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a cellular phone
which provides ground shorting when a call is received.
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your amplifier or
signal processor.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse box or
another unused power source which provides (+) 12V only when the
ignition is turned on or in the accessory position.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure
the connection is made to bare metal and is securely fastened using
the sheet metal screw provided.
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if
applicable.
Note
This lead should be used only for controlling the vehicles power
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
Dimmer Lead (Orange) (CDE-112Ri/CDE-113BT/ CDE-114BTi
only)
This lead may be connected to the vehicle’s instrument cluster
illumination lead. This will enable the vehicles dimmer control to dim
the backlighting of the unit.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s battery.
ISO Power Supply Connector
ISO Connector (Speaker Output)
Left Rear (+) Speaker Output Lead (Green)
Left Rear (−) Speaker Output Lead (Green/Black)
Left Front (+) Speaker Output Lead (White)
Left Front (−) Speaker Output Lead (White/Black)
Right Front (−) Speaker Output Lead (Grey/Black)
Right Front (+) Speaker Output Lead (Grey)
Right Rear (−) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
Steering Remote Control Interface Connector
To steering remote control interface box.
You can operate this unit from the vehicle’s control unit when an
Alpine Steering Remote Control Interface Box (optional) is
connected. For details, contact your Alpine dealer.
MIC Input Connector (CDE-113BT/CDE-114BTi only)
To M icrophone.
Fuse Holder (10A)
Front Output RCA Connectors (CDE-112Ri/CDE-113BT/
CDE-114BTi only)
RED is right and WHITE is left.
Rear/Subwoofer Output RCA Connectors (CDE-112Ri/
CDE-113BT/CDE-114BTi only)
Front/Subwoofer Output RCA Connectors (CDE-111R/CDE-111RM
only)
RED is right and WHITE is left.
Power Supply Connector
RCA Extension Cable (sold separately)
FULL SPEED Connection Cable (KCE-433iV) (sold separately
for CDE-111R/CDE-111RM/CDE-113BT)
KCE-400BT Connection Cable (Included with KCE-400BT)
ISO/JASO Antenna Adaptor (sold separately)
An ISO/JASO antenna adapter may be required, depending on the
vehicle.
Front AUX Input Terminal (CDE-112Ri/CDE-113BT/
CDE-114BTi only)
This terminal allows for input of audio from an external device (such
as a portable player), using a commercially-available converter cable.
USB Terminal
Connect this to a USB Memory (sold separately).
To prevent external noise from entering the audio system.
Locate the unit and route the leads at least 10 cm away from the
car harness.
Keep the battery power leads as far away from other leads as
possible.
Connect the ground lead securely to a bare metal spot (remove
any paint, dirt or grease if necessary) of the car chassis.
If you add an optional noise suppressor, connect it as far away
from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
Your Alpine dealer knows best about noise prevention
measures so consult your dealer for further information.
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine CDE-114BTi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine CDE-114BTi in the language / languages: English as an attachment in your email.

The manual is 2,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alpine CDE-114BTi

Alpine CDE-114BTi User Manual - German - 41 pages

Alpine CDE-114BTi User Manual - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info