541348

Allen-Heath GL2200 Manual

24
Zoom out
Zoom in
Previous page
1/28
Next page
GL2200 USER GUIDE
24
REAR PANEL LAYOUT
SPECIFICATIONS
0 dBu = 0.775 Volts rms 0 dBV = 1 Volt rms
HEADROOM:.............................................................. +21dB
MAX OUTPUT: .............. ……XLR +25dBu 2kohm max load
............................................JACK +21dBu 2kohm max load
METERS: L, R……………….peak reading 12 bar LED
Groups 1-4……….peak reading 4 segment LED
Channels…………peak reading 4 segment LED
PEAK LEDs: .............................Turn on 5dB before clipping
FREQUENCY RESPONSE referred to 1kHz @ +4dBu:
Any input to any output .....................20Hz to 30kHz +0/-1dB
DISTORTION: THD+Noise @ +14dBu 1kHz
Mic in to L-R output, 40dB gain .................................0.010%
Line in to L-R output, 0dB gain ..................................0.008%
CMRR
Mic in, 40dB gain @ 1kHz .......................................... >88dB
CROSSTALK: Referred to driven channel @ 1kHz
Adjacent channel ……………………………………... < -90dB
Channel fader off.......................................................< -90dB
Channel mute on .......................................................< -90dB
Channel Pan pot isolation .........................................< -80dB
NOISE: Measured rms, 22kHz bandwidth
Mic input EIN (150 ohm source)..............................< -128dB
Line preamp, 0dB gain ............................................< -83dBu
L-R output residual noise .....................< -92dBu (96dB S/N)
L-R faders ‘0’, nothing routed ...............< -88dBu (92dB S/N)
L-R mix noise (16 channels routed) .....< -83dBu (87dB S/N)
Group, faders ‘0’, nothing routed..........< -91dBu (95dB S/N)
Group mix noise (16 channels routed).< -83dBu (87dB S/N)
POWER SUPPLY: ....................100 to 240V AC @ 47/63Hz
....................................Internal, autosensing AC mains input
Power consumption:............................................... 60W max
Mains Fuse rating 100-240VAC: ............... T1A 250V 20mm
CONNECTIONS
INPUTS:
Mic in.............................. XLR......................... pin 2 hot, 3 cold, balanced .................... >2k Ohm..........variable -60 to -20dBu
Line in ............................ XLR......................... pin 2 hot, 3 cold, balanced .................... >10k Ohm ........variable -30 to +10dBu
or TRS jack ................. tip hot, ring cold, balanced .................... >10k Ohm........variable -30 to +10dBu
Stereo Ch Line in ........... TRS jack ................. tip hot, unbalanced ................................ >8k Ohm .........-20dBu min
Stereo Return ................ TRS jack ................. tip hot, unbalanced ................................ >6k Ohm ..........-10dBV min
2-Track Return............... RCA PHONO.......... unbalanced............................................ >10k Ohm........-10dBV min
Insert Return .................. TRS jack ................. tip send, ring return, unbalanced........... >6k Ohm .......... 0dBu (chan), -2dBu (out)
OUTPUTS:
L-R, Group out ............... XLR......................... pin 2 hot, 3 cold, balanced .................... <75 Ohm..........+4dBu, +27dBu max
Direct out ....................... TRS jack ................. tip hot, impedance balanced ................. <75 Ohm..........0dBu
2-Track sends ................ RCA PHONO .......... unbalanced ............................................ <75 Ohm..........variable +21dBu max
Aux out.......................... TRS jack ................. tip hot, impedance balanced ................. <75 Ohm.......... variable +21dBu max
Mono out........................ XLR......................... pin 2 hot, 3 cold, balanced .................... <75 Ohm.......... +4dBu, +27dBu max
Insert send ..................... TRS jack ................. tip send, ring return, unbalanced........... <75 Ohm.......... 0dBu (chan), -2dBu (out)
Monitor out..................... TRS jack ................. tip left, ring right, unbalanced ................ <75 Ohm.......... variable +21dBu max
Phones out..................... TRS jack ................. tip left, ring right..................................... for stereo headphones 30 to 600 Ohms
REVERSE
GRP/AUX
5
AUX
R
6
OUT
M
OUT
SEND
L
OUT
4
OUT
2
OUT
13
OUT OUT
L
MONITOR
AUX
6
RINSERT
RING R
TIP L
12
AUX AUX
4
AUX
3
AUXAUX
5
INSERTINSERT INSERT INSERT INSERT
GRP
19
RETURN
2-TRACK
RETURN
R
20
STEREO
RETURN
STEREO
RL/MONO
18
L/MONO
17
DO NOT OBSTR UCT VENTILATION OPEN INGS
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR.
SEE INSTALL ATION INSTRUCTIONS BE FORE CONNECTING TO THE S UPPLY
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE
T1A 250V 20mm
WARNING - THIS APPARATUS MUST BE EARTHED.
EXTERNAL SUPPLY INTERNAL SUPPLY
ACTIVE ACTIVE
100 - 240V~
100 - 240V.AC
47-63Hz ~ 60W MAX
SUPPLY VOLTAGE RANGE:
NO USER SERVICEABLE PARTS INSIDE
WARNING: DISCONNECT SUPPLY BEFORE CHANGING FUSE.
ATTENTION: COUPER L'ALIMENTATION AVANT DE CHANGER LE FUSIBLE.
CAUTION : FOR CONTINUED PROTE CTION AGAINST RISK OF FIRE REPLACE FUSE
ATTENTION: REMPLACER LE FUSIBLE AVEC UN DES MEMES CARACTERISTIQUES.
WITH SAME TYPE AND RATING.
TALKBACK
SYS-LINK
OUT
DIRECT
10
OUT
DIRECTDIRECT
9
OUT
8
OUT
DIRECTDIRECT
7
OUT
6
OUT
CAUTION
DIRECTDIRECT
5
OUT
4
OUT
DIRECTDIRECT
3
OUT
2
OUT
DIRECT
1
OUT
INSERTINSERTINSERTINSERTINSERT
SYS-LINK
1416
12
MIC
R
IN
11
MIC
R
MIC/LINE
STEREO
IN
IN
15
L/MONO
STEREO
IN
LINE
IN
13
L/MONO
10
ININ
MIC/LINE MIC/LINE
ININ
MIC/LINE MIC/LINE
LINE
IN
LINE
IN
98
LINE
IN
LINE
IN
76
INSERTINSERTINSERTINSERTINSERT
ININ
MIC/LINE MIC/LINE
ININ
MIC/LINE MIC/LINE
LINE
IN
LINE
IN
54
LINE
IN
LINE
IN
32
IN
MIC/LINE
LINE
IN
1
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Allen-Heath GL2200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Allen-Heath GL2200 in the language / languages: English as an attachment in your email.

The manual is 3,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info