707368

Alecto SA-66 Manual

7
Zoom out
Zoom in
Previous page
1/9
Next page
El SA-33 es un conjunto que consta de 3 detectores de humo capaz de detectar la emisión
de humo ya en fase temprana. Si el humo es detectado sonara un fuerte pitidde al menos 85
dB (A) de la misma, los detectores aclopados que se encuentren en el radio de emision comenzaran
tambien a sonar. Se recomienda probar la alarma de humo cada semana simplemente accionando el
Test de los detectores de humo. Guarde este manual en un lugar conveniente
LUGARES RECOMENDADO DE MONTAJE PARA EL SA-33:
• Instale el primer detector de humo cerca de su dormitorio. Asegurar que una vía de escape
permanece libre y planear una ruta de escape en caso de emergencia. Coloque el detector de
humo en un lugar adecuado, que por supuesto no bloquee rutas de escape.
• Utilice varios detectores de humo, por lo que la seguridad se incrementa (área más grande). Las
vías de evacuación deben estar libres.
• Colocar en cada piso de su casa al menos un detector de humo.
• Colocar en cada habitación, en la que se fume o que contengan materiales inflamables, por lo
menos un detector de humo.
• Humo, el calor y los productos de combustión suben por primera vez al techo. Después de eso,
se extenderán horizontalmente.
• Si monta el detector de humo en el techo, hay que mantener una distancia de 60 cm a 50 cm de
la pared y de la esquina. Productos humo, calor y combustión nunca se mueven a saber, en una
esquina.
EVITE LOS SIGUIENTES LUGARES PARA INSTALAR LA UNIDAD SA-33:
• En la cocina, el vapor producido por la cocción, puede conducir a una falsa alarma.
• En la ducha o en el baño, el vapor de agua puede conducir a una falsa alarma.
• En un garaje, por los gases de escape que puedan surgir durante la puesta en marcha del
automóvil .
ES
The unit will only be able to lock into the ceiling plate if both battery types are installed. Once smoke
is detected, the alarm will sound and the other detectors will be wirelessly triggered as well. One the
smoke disappears, the smoke alarm will stop automatically. For the wireless trigger on alarm, you
first have to register the smoke detectors. There is no limit to the amount of smoke detectors that can
be linked, although they do have limited range. Each smoke detector also extends the range.
Registering: For the registration process you have to assign one smoke detector to be a “Master”.
The rest of the smoke detectors will function as “Slave”. On the master unit, press the “LEARN” twice.
After the first press the LED will be red, after the second press it will be green. Now press “LEARN”
on each of the detectors you want to connect, but only once so the LED will be red. Once the first
detector stops the green light, the connection is complete. Test the connection by holding “TEST” on
any unit until the other detectors give an alarm as well. If the detectors will be placed more than a few
feet from each other, it is recommended to register these before installing them to the ceiling plate.
Test:
Hold the test key for at least 2 seconds. The operation is still correct if you hear 2 or three signal
tones. If you hold the test key longer, the registered smoke detectors will also give an alert.
Check the smoke detectors weekly. We recommend to check the link function monthly as well. Do
not use candles, open fire or cigarettes to test the smoke detector.
ATTENTION:
• If the cause of an alarm is unclear, assume it’s caused by fire. Immediately evacuate the building.
• Keep the smoke detectors out of range of children.
• Protect against dust during rennovations. Without protection the smoke detectors will
lose their functionality.
Maintenance: The smoke detector is maintenance-free. In very dusty rooms they may be cleaned by vacuum.
Plan an escape route:
• Make a map and mark all locations of doors and windows and a possible escape route. Note that
you may need an escape ladder on high floors.
• Ensure everyone in the house knows the sound the smoke alarms produce and regularly practice
use of the escape route.
• Leave the house immediately according to the plan when hearing the alarm. Every second
counts: so respond quickly. If you do not notice smoke or heat, check if everyone in the house is
in a secure location.
• Do not open any doors without feeling wether the door is warm or if there is smoke coming from
underneath the doors. If it is, do not open that door. If the door is cold, put your shoulder firmly
against the door and open it a small amount to check for any heat or smoke first.
• If there is much smoke, keep low and take shallow breaths, preferably through a moist towel. Call
the fire department as soon as you are safe outside.
1
2
Replacing the batteries: The detectors are supplied using a 9V block battery. Only use the recom-
mended types: Mustang 9V 6F22; GoldPeak 9V 1604A, 1604S; Pair Deer 9V 6F22, 6LR61. Under
normal conditions the battery will last at least one year. If it is about to need replacement, the smoke
detector will make a chirping sound every 45 seconds for at least 30 days. For the link function, the
AA batteries are used. If these must be replaced, the detector will give 2 or 3 chirp sounds every 60
seconds. Pay attention to the polarity when replacing batteries. Test the detector after every battery
replacement. If the smoke detector does not function, please contact your supplier.
Environment: Do not throw away used batteries, but recycle them using your local chemical depot.
Product may not be thrown out as normal waste, but must be recycled as electrical waste.
Declaration of conformity: Available to download from: www.alecto.nl
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto SA-66 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto SA-66 in the language / languages: German, Dutch, French, Spanish as an attachment in your email.

The manual is 2,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info