Manual Alecto FR-10 (page 4 of 4) (English, German, Dutch, French)

708499

Zoom out

Zoom in

1/4

INTRODUCTION

The Alecto FR-10 is a PMR-446 Radiophone. This

radiophone allows for free-of-charge communication

back and forth, as well as communication with other

(Alecto) radiophones as long as these meet the PMR-

446 standard.

The Alecto FR-10 is in accordance with the essential

requirements and provisions as described in the Euro-

pean Directive 1999/5/EC. The declaration of confor-

mity is available on the website www.alecto.nl

POWER SOURCE

The FR-10 works on 3 REGULAR AAA penlite bat-

teries.

1. First, remove the belt clip by pressing the lock tab

back and pushing the belt clip upwards and out of

the radiophone.

2. Open the battery compartment and install the

batteries as indicated. Pay attention to the correct

polarities (+ and -).

3. Close the battery compartment and put the belt clip

back on the radiophone.

TECHNICAL SPECIFICATIONS

Transmitting frequency: 446MHz

Transmitting power: 0.5Watt

Channel separation: 12.5KHz

Power supply radiophone: 4,5V (3x 1.5V battery)

Range: up to 7 Km

Period of use: transmitting: 3 hours

stand-by: 6 days

(based on usage)

Weight radiophone: 77 gr. (excl. batteries)

Dimensions: 92(146) x 50 x 39mm

Conform EN 300 296-2 V1.3.1

EN 301 489-5 V1.3.1

EN 60950-1:+A12:2011

DISPLAY FUNCTIONS

: shows the selected channel

: battery capacity indication

= batterij OK

ashing = battery almost empty

: turns on when the SCAN function is activated

TX: turns on while sending

RX: turns on while receiving

FM: turns on when the radio is turned on

: shows the volume level

: switches on when the key lock is activated

USE

Attention: always set both radiophones to the

same channel

Attention: Don’t forget that other people with a

radiophone can receive your signal also, even

when it’s of a different model or brand.

You can also receive signals from other radiophones.

In this case, you can try and select a different channel.

Power on/off:

Press and hold the button for 2 seconds to switch

the FR-10 on or off.

Transmitting:

Press the PTT button to sending.

(PTT = Push To Talk )

Hold the radiophone approximately 5cm from your

mouth and speak into the microphone.

Receiving:

Release the PTT button to receive.

Call tone:

Press the button to transmit a call tone.

Switching channels:

Press the button and then use ▲ or ▼ to select

the correct channel.

Press the PTT button to conrm the selected chan-

nel.

Volume control:

Use the button▲ or ▼ to change the volume.

Roger beep:

When you release the PTT button, the FR-10 will

send a tone to inform the other party he or she can

talk back.

This tone is always on and cannot be switched off.

Channel scan:

Simultaneously press and hold and ▲, after 1

second the display will show SC and the FR-10 will

then scan all channels.

Received signals will be shown and the scan will

then continue.

Press the PTT button to stop the scan.

Monitoring:

Simultaneously press and hold ▼ and ▲, after 1

second the display will show RX, the noise reduction

will be switched off and you can also hear the wea-

ker transmissions on the current channel.

Simultaneously hold ▲ and ▼ again for 1 second to

cancel this function.

Key lock:

Press and hold the button, after 1 second the

display will show . Changing channels or the

volume level will now no longer function, but you can

still receive and transmit.

Press and hold the button again for 1 second to

cancel the key lock function.

USER TIPS

GENERAL:

• The FR-10 is a transmitter/receiver working with

radio waves on the 446 MHz band. Its signal trans-

mission can be affected by external inuences such

as other radiophones, transmitters, wireless phones,

etc. When your radiophone is being interfered with

or causes interference, simply changing the channel

usually solves this problem.

• The use of this radiophone is permitted in all the

countries of the EU. If you want to bring the FR-10

to countries outside the EU, you should consult the

local restrictions on the use of PMR446 equipment.

• Don’t forget that the signal of the FR-10 can also be

heard by radiophones or receivers other than yours.

• It is in no way allowed to make any changes to the

electronics or the antenna of the FR-10. Service

must be performed by qualied service personnel

only.

• Never use the FR-10 outdoors during thunder-

storms.

MAINTENANCE:

• Only clean the FR-10 with a moist cloth.

• Never place the radiophone in direct sunlight or

humid environments.

• Prevent water and/or sand from penetrating the

FR-10.

• In case of any problems, always check rst whether

the FR-10 does work correctly on a different location.

RADIO CONNECTION:

• The FR-10 has an effective range from up to 7km.

This range can be affected by local conditions such

as high buildings, high voltage posts and overhead

wires. An optimal range is achieved when the radiop-

hone has a clear sight of the receiver.

ENVIRONMENT:

• When discarding your radiophone, please return it

to your dealer. They can guarantee environment-

friendly disposal.

• You can return exhausted batteries to the dealer

of these radiophones or to your local collection

point for small chemical waste.

• Never dispose of empty or exhausted batteries as

normal domestic waste.

WARRANTY CARD

This ALECTO FR-10 is covered by a warranty of 24

months commencing on the day of your purchase.

During this period we guarantee that any defects

caused by errors in materials or construction will be

repaired free of charge. The importer decides upon

these conditions.

WHAT TO DO ?

If you note any anomalies, rst read the user’s manual.

If you cannot nd any solution to your problem, please

contact Alecto customer service on the phone number

073 6411 355 (Netherlands) or 03 238 5666 (Belgium)

or via internet at www.alecto.nl

WARRANTY COVERAGE TERMINATES :

In the event of misuse, improper connection, battery

leakage or incorrect placement of batteries. It does not

cover the use of parts or accessories not delivered with

this device, neglect or any failure caused by humi-

dity, re, ood, lightning or any natural disaster. The

warranty does not cover alteration or modications of

the product by unauthorized qualied service perso-

nal. The warranty terminates in the event of incorrect

transportation of the equipment without appropriate

packaging or if the equipment is not accompanied by

this warranty card and the receipt of purchase.

Cables, jacks and batteries are not covered by the

warranty.

Alecto will not be held responsible for indirect, conse-

quential or special damages.

V1.2

FR-10 GB

Antenna

Display

PTT talk-button

Speaker

Microphone

Call button

▲ and ▼buttons

Power push-button

Program button

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Alecto FR-10 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,75 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Alecto FR-10 Manual

Product: