803291
4
Zoom out
Zoom in
Previous page
1/8
Next page
SETTING THE DAY AND NIGHT TIME
The day and night time is already set at the factory.
The daytime starts at 6.00 hrs.
The night time starts at 18.00 hrs.
With the MODE button you can choose between daytime
, night time and current time .
DAYTIME NIGHT TIME CURRENT TIME
SETTING THE CLOCK
Make sure that the current time is shown on the display
( ).
Then press and hold the SET button for 3 seconds.
The hours will now begin to ash.
Press the + and - buttons to set the desired hours.
Press the SET button.
The minutes will now begin to ash.
Press the + and - buttons to set the desired minutes.
Finally, press the SET button to conrm the entered hours
and minutes.
SLEEP TRAINER CLOCK and
ALARM CLOCK NIGHT LIGHT
-2-
-5-
-3-
-6-
-4-
-7-
CHARGING THE BUILT-IN BATTERY
With the included cable, the built-in battery of the
sleeptrainer can be charged. You can place the
sleeptrainers cable in a USB port on a computer, laptop or
adapter with a USB port to charge it.
Make sure the BC110 SIMON and cable are out of reach
of children during charging.
The battery is fully charged after approximately 1.5 hours.
This depends on the adapter or power supply used.
During charging, the light on the back of the sleeptrainer
will light up red as an indication.
When the battery is full, the indicator light will turn green.
When the battery is empty, the icon will appear on the
display.
Later on the backlight will go out. The digital time will
continue to run for a while.
Recharge the sleeping trainer battery.
The battery will last for an average of 18 days, depending
on the set display brightness.
Display lighting high: ± 4 days
Display lighting medium: ± 18 days
Display lighting o󰀨: ± 7 months
STANDBY
It is possible to put the sleep trainer on standby.
The display will then turn o󰀨. You can do this by pressing
the ON/OFF button once. When the alarm goes o󰀨, the
display will automatically turn on again.
RESET
It is possible to reset all settings to the default setting
(except the current clock)
Press and hold the [MODE], [SET] and [ON/OFF] buttons
simultaneously until “CLr” appears on the display.
SETTING THE DAYTIME (start of the day-orange light)
Make sure that the daytime is shown on the display.
Then press and hold the SET button for 3 seconds.
The hours will now begin to ash.
Press the + and - buttons to set the desired hours.
Press the SET button.
The minutes will now begin to ash.
Press the + and - buttons to set the desired minutes.
Finally, press the SET button to conrm the entered hours
and minutes.
Note: The daytime can be set between 04.00 - 14.59
hours.
SETTING THE ALARM TIME (alarm clock)
While setting the daytime, the alarm clock can be
activated.
While the hours or minutes are ashing, press the MODE
button.
The icon appears in the upper right corner of the
screen.
The alarm is now activated. When the alarm goes o󰀨, it
can be deactivated by pressing one of the control buttons.
The alarm will go o󰀨 for a maximum of 1 minute, then it will
stop automatically.
Note: If the key lock is on, the alarm can still be
deactivated by pressing any key.
SETTING THE NIGHT TIME (start of the night-blue
light)
Make sure that the night time is shown on the display.
Then press and hold the SET button for 3 seconds.
The hours will now begin to ash.
Press the + and - buttons to set the desired hours.
Press the SET button.
The minutes will now begin to ash.
Press the + and - buttons to set the desired minutes.
Finally, press the SET button to conrm the entered hours
and minutes.
Note: The night time can be set between 15.00 - 03.59
hours.
SETTING THE KEYPAD LOCK
The control keys can be locked so that they can no longer
be used.
To lock the control keys, press and hold the + and - keys
for at least 5 seconds.
The icon appears in the upper right corner of the
screen.
Press and hold the + and - keys again for 5 seconds to
release the key lock.
SETTING THE BACKLIGHT
The backlight will turn orange or blue depending on the
daytime or night time.
It is possible to adjust the intensity of the backlight.
Make sure that the current time is displayed ( ).
Press the + and - buttons to adjust the brightness of the
display. In total there are 7 modes and o󰀨.
WARNING
This is not a toy!
TWHEN NOT USED FOR A LONG PERIOD OF TIME
When not using the product for a long period of time, we
advise you to turn o󰀨 the sleep trainer completely using
the ON/OFF button or main switch/reset button.
In order to maintain the battery life, we recommend that
the battery of the BC110 SIMON is fully charged every
3 months during long periods of non-use.
SPECIFICATIONS
Power supply: Built-in rechargeable lithium battery
500 mAh.
Important:
- Replacement of the battery is not possible, please
contact our service department in case of problems with
the battery.
- Disposing of the product in re, hot oven, or mechanical
crushing or cutting may damage the supplied battery and
cause an explosion.
- Leaving the product with the supplied battery in an
environment with extremely high temperatures may cause
an explosion or leakage of ammable liquid or gas.
- Exposing the product with the supplied battery to
extremely low air pressure may cause an explosion or
leakage of ammable liquid or gas.
Commaxx B.V.
Wiebachstraat 37
6466NG Kerkrade
The Netherlands
www.alectobaby.com
EN
ON/OFF
Press the ON/OFF button on
the backside to turn on the
product.
v1.2
BC110BE SIMON
BC110GN SIMON
2
3
4
BC110GN SIMON PD: ADDMY
Commaxx B.V., Wiebachstraat 37
6466NG Kerkrade, NL
1
GENERAL
The BC110 SIMON is suitable to improve your child’s
sleep rhythm. The sleep time and daytime can be
programmed. E.g. 18.30 hours to bed (sleeping time) and
06.30 hours to get up (wake-up time), possibly with an
alarm signal. The display shows a blue night light during
sleep time and an orange light during daytime. The
product is suitable for children who can read the clock as
well as for children who can’t read the clock yet.
By pressing the SET button you can switch between the
di󰀨erent views.
There are 3 ways to display the time on the display:
Moon, blue nightlight and evening time means, stay in
bed and sleep.
Sun, orange night light and day time means, I can get
up.
FUNCTIONAL
1. Display with blue or orange backlight.
Visible by day with orange light
Visible at night with blue light
Visible when setting the alarm time
Visible when setting the night time
Visible when the battery is low
Visible when the alarm is activated
Visible when the buttons are locked
Visible when the current time mode is displayed
24-hour notation
2. Keys
3. Charging indicator light
4. DC Jack connection for charging
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto BC110 Simon at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto BC110 Simon in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 5.74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info