Manual Alecto BC-12 (page 1 of 2) (English, German)

552916

Zoom out

Zoom in

1/2

BC-12

FOREHEAD THERMOMETER

INTRODUCTION

Thank you for purchasing this Fore-

head thermometer. This thermo-

meter is designed with advance

infrared and ambient temperature

compensation technology for accu-

rate and fast temperature measure-

ments. It also has a wide range

mode to scan temperature real time.

ON / OFF

Power on:

Press the “ON/MEN” button.

Power off:

Device will automatically power off

if left idle for more than 1 minute to

extend battery life. In next power on,

it will get back to the default setting

of “HEAD” temperature function

MODE SELECTION

FOREHEAD Mode:

The preset mode

of the thermometer

is forehead. The

thermometer is

ready for use after

the “Head” icon

stops ﬂ ashing and two beeps are

sounded.

SCAN Mode:

While the unit is

ON, hold dow

n the

“ON/MEN” button,

and press the

“Meas.” button,

then the icon

will replace the “HEAD” icon in the

LCD display.

Fever Alarm:

If the thermometer detects a tempe-

rature >37.5°C (or 99.5°F) under

forehead mode, a long beeping

sound followed by three short beep-

ing sounds to warn the user for

potential fever.

Measuring temperature under SCAN

mode:

When you press the “Meas” button,

you will get the temperature

immediately about 0.6 sec. If you

hold down the scan button, the

reading of measurement will be

continuous updated.

(This mode shows the

actual, unadjusted

temperatures, which is

different with the forehead mode.)

ATTENTION: the BC-12 is NOT

waterproof. The measuring of, for

example, the bath-water must be

done by pointing the thermometer

to the surface of the bath-water and

press the MEAS button.

Memory Function:

Press the “ON/MEN”

button to see the

temperature stored.

This thermometer provides 25 sets

memory for the last measurements.

** Please be noted that only the

“HEAD” function’s reading will be

recorded. (When the thermometer

is turned off, the las

t measurement

data is saved into memory.)

CHANGE °C / °F

To change the LCD from °C to °F:

When the unit is OFF, hold down the

“Meas.” button, then press and hold

the “ON/MEN” button until the LCD

shows ‘°F’, then release the “Meas.”

button. Use the same process to

change the LCD display from °F to

°C.

CLEANING AND STORAGE

The Probe is the most delicate part

of the thermometer. Use with care

when cleaning the probe to avoid

damage.

a. Allow the lens to fully dry for at

least 30 minutes.

b. Keep the unit dry and away from

any liquids and direct sunlight.

c. Please use the alcohol swab or

the soft cotton moistened with the

95% alcohol to clean the probe

lens.

d. Clean the probe and probe lens

after each use to ensure an

accurate reading and avoid cross

contamination.

IMPORTANT NOTES

1. Make sure the Probe is clean and

avoid the smothered with Rubber

boat (Protector).

2. Before the measurement, please

stay in a stable environment for

5 mins and avoid the exercise,

bath for 30mins.

3. Remember to keep the temple

area clean and away from sweat,

cosmetics and scar while taking

temperature.

4. During the measurement, please

away from the direct sunshine and

wind.

5. The BC-12 is NOT waterproof. Do

not plunge into any liquid.

CHANGING THE BATTERY

It is supplied with one lithium cell

(CR2032x1pcs).

1. Open the battery compartment

by turning the cover 45° clockwise

2. Remove the battery safety strip

with a sharp-pointed object.

3. Insert a new battery under the

metal hook and press down until

you hear a click sound

4. Close the battery cover.

ENVIRONMENT

Exhausted batteries may

never be disposed of in

household waste but must

be handed in at your local

depot for chemical waste.

At the end of the product

lifecycle, you should not

throw this product into the

normal household garbage

but bring the product to a

collection point for the recycling of

electrical and electronic equipments.

DISPLAY READOUT

Device can not be powered

on to the ready stage.

Change with a new battery.

Battery is low and no more

measurements are possible.

Replace the battery.

Device stabilization in

process. Wait until ‘HEAD’

stops ﬂ ashing.

error-1: Measurement before

device stabilization. Wait until

‘HEAD’ stops ﬂ ashing.

error-2: The device showing a

rapid ambient temperature

change.

error-3: The ambient

temperature is not within the

range between 10°C and

40°C (50°F~104°F).

error-4 ~ error-9:

The system is not

functioning

properly. Unload the battery, wait for 1

minute and repower it. If the message

reappears, contact the retailer for service.

Temperature

taken is higher

than 42.2°C

(108.0°F) for forehead mode or 80°C

(176°F) for scan mode.

Temperature

taken is lower

than 34°C

(93.2°F) for forehead mode or –20°C

(-4°F) for scan mode.

SPECIFICATIONS

Range:

34°C ~ 42,2°C (forehead)

-20°C ~ 80°C (scan)

Accuracy:

0,3°C (forehead)

4% (scan)

Operating Range: 10~40°C

Storage conditions: -20°C ~ 50°C

Battery: CR2032, 3V, lithium

Lifetime battery: measure 40 hours

continuously

DECLARATION OF CONFORMITY

The declaration

of conformity is

available on the website:

GUARANTEE

You have a guarantee of 12 MONTHS after

the date of purchase of this Thermometer. We

guarantee during this period the free repair of

defects caused by material- and construction

faults. This at the importers discretion. It is only

possible to claim to the guarantee when you

enclose your purchase ticket with the BC-12.

HOW TO ACT: If you notice a defect, consult

the manual ﬁ rst. If this manual gives you no

deﬁ nite answer, consult the Alecto Helpline on

telephonenumber +31 (0)73 6411 355.

THE GUARANTEE EXPIRES: When used

inexpert, leaking and faulty placed batteries, use

of unoriginal parts or accessories, negligence

and defects caused by ﬁ re, ﬂ ood, stroke of

lightning and natural disasters. With unqualiﬁ ed

modiﬁ cations or repairs by third persons. With

incorrect transport without a suitable packing. If

the device is not handed in with the correct ﬁ lled in

guarantee card and the purchase ticket.

NOT UNDER THIS GUARANTEE:

batteries.

All further responsibilities, in particular subsequent

damages, are excluded.

USERS MANUAL

HOW TO USE

Measuring the FOREHEAD tempe-

rature:

Always make sure the probe lens is

clean without any damage, and the

forehead is clean.

Pres the “SCAN” button

and gently scan around

the temple area, you can

select the left side of the

left temples or the right side of the

right temples.

Measurement has been completed

after a long beep is heard. (The

time of measurement might be

between 5~8sec (up to 30sec). That

depend on when the thermometer

get the highest temperature of the

forehead.)

Note: Forehead temperature is

displayed in Oral Mode. This mode

converts the forehead temperature

to display its “Oral equivalent.”

Service

Help

+31 (0) 73 6411 355

ver 1.2

display

press

to measure

the

temperature

On/Off

button

Provission

for a strap

BC-12 set to

forehead-mode

BC-12 set to

scan-mode

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Alecto BC-12 in the language / languages: English, German as an attachment in your email.

The manual is 0,26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alecto BC-12

Alecto BC-12 User Manual - Dutch, French - 2 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Alecto BC-12 Manual

Product: