520601

AKO FW 550 S Manual

3
Zoom out
Zoom in
Previous page
1/12
Next page
EN
3
Installation and Operating Instructions
Frostguard FW 550 S
1. Important Information
Keep these instructions in a safe place and pass them on to
possible future owners.
• Use device for room heating within enclosed rooms only.
• Repairs and corrective measures must only be carried out
by a qualified technician.
• Disconnect the power supply in the event of a fault (pull out
the device plug or switch off the fuse).
• Do not use this device next to the bathtub, shower,
washbasin or swimming pool.
• Do not cover the heating device with any objects;
fire hazard!
The device carries the symbol shown on the right,
which indicates that the heating device must
under no circumstances be covered with any objects.
• Observe the minimum clearances.
• Caution! The outer surfaces of the device, and in particular
the air outlet grid, become hot during operation.
• Children or persons who are not capable of operating the
device safely must not operate the heating device. Ensure
that children do not play with the unit.
• Caution! Potential dangers can arise when the device
switches on automatically, e.g. devices which have been
covered or blocked by objects since they were last used can
cause fire.
• Do not operate the heating device in rooms where highly
inflammable substances are used (e.g. solvents, etc.).
• Do not lay the connecting cable across the device when hot.
• The heat consumption required to protect against frost must
be met by the heat output of the device and should be
determined by a technician.
2. Wall Mounting
The device plug must be accessible after installation. The
heating device must be aligned horizontally and installed on a
vertical wall (see illustration).
Make sure that the inflow and outflow of air at the top and
bottom of the device are unimpeded
.
In addition, a minimum clearance of 500 mm between
inflammable objects e.g. curtains, towels or heat-sensitive
plastics and the front of the unit must be maintained.
Installation below a wall socket is not permissible.
Minimum clearances must be observed.
Install the device in such a manner that the controls cannot be
touched by a person in the bathtub or under the shower.
It is not permissible to install the device in protection zones as
defined in VDE 0100 part 701.
Mounting Instructions
Use the original wall bracket supplied!
- Drill the mounting holes and insert dowels.
- Screw the wall bracket into place.
- Hang the heating device in place.
- Screw the heating device into place on both sides of the wall
bracket.
3. Electrical Connection
The voltage specified on the type plate must match the present
mains voltage.
If the power line of this device is damaged, it must be replaced
by the manufacturer or after-sales service, or else by a similarly
qualified person, in order to prevent risks.
The device plug must always be accessible.
To prevent danger by accidental resetting of the thermal
tripping unit, this device must not be supplied via external
switching devices (e.g. timers) or connected to a circuit that is
regularly switched on and off by the utility company.
200
300
100
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AKO FW 550 S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AKO FW 550 S in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info