48847
14
Zoom out
Zoom in
Previous page
1/16
Next page
14
En
Care and maintenance
Occasional care and maintenance of the unit and the software
are needed to optimize the performance of your unit.
To clean the cabinet
Use a soft and dry cloth. If the unit surfaces are extremely
dirty, use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as alcohol, benzine
or thinner.
Care of CDs
When a CD becomes dirty, wipe it from the center out with a
cleaning cloth. After playing a CD, store it in its case. Do not
keep it in hot or humid places.
Troubleshooting
If your unit fails to perform properly, check the following guide
and the relevant sections of the Operating Instructions.
There is no sound
Are the speakers and AC power cord connected properly?
The unit shut off suddenly
Possibly a short circuit in the speaker terminals. Disconnect
the AC power cord from the AC outlet and reconnect the
speaker cords correctly.
REFERENCE
Erroneous display
•Reset the unit. (See "Resetting the unit".)
Poor radio reception
Check antenna connection. Adjust the antenna to find the
best reception.
Move the unit and antenna away from other electric
appliances and cords.
The CD player works poorly
Is the disc correctly loaded?
Is the disc dirty?
Is the lens affected by condensation? If so, wait
approximately one hour and try again.
Condensation
Moisture may form on the CD pickup lens when:
The unit is moved from a cold spot to a warm spot
The heating system has just been turned on
The unit is used in a very humid room
The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function
normally. Should this occur, leave the unit for a few hours,
then try to operate again.
Resetting the unit
If an unusual condition occurs in the display window, reset
the unit as follows:
1Press POWER to turn off the power.
If the power cannot be turned off, disconnect the AC power
cord, then plug it in again.
2 Hold down s and press POWER on the main unit.
Everything stored in memory after purchase is cleared.
When transporting the unit with packing materials
When transporting the unit using the packing materials, for
example, when asking for repair, be sure to re-attach the
protective tag, which was attached when you purchased the
unit, before packing the unit. Re-attach the protective tag as
described below.
1 Reset the unit while the unit is turned off. (See "Resetting
the unit".)
2Press CD2 zOPEN/CLOSE to open the disc tray.
3 Disconnect the AC power cord from the AC outlet.
4 Attach the protective tag as illustrated.
5 Connect the AC power cord to an AC outlet.
6Press
AUX to turn on the power.
7Press POWER to turn off the power.
Disc tray 2
01_10_15_XREC10_UC_En 02.3.15, 7:11 PM14
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aiwa XR-EC12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aiwa XR-EC12 in the language / languages: English as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info