• Playtime: 2.5-10 hours (varies by volume level and content)
• Battery charge time: 5-6 hours
• Dimensions: 372*193.3*166mm
• Weight: 3.7 kgs
• Keep the speaker and its accessories away from the reach
of kids as they might cause a choking hazard.
• Keep the speaker away from fire, water, liquids, extreme
heat, and strong magnetic fields.
• Do NOT use this speaker at high volume for extended
periods, as this may cause permanent hearing damage or
loss.
• Do NOT drop or knock the speaker on hard surfaces.
• Do NOT use chemicals or detergents to clean the speaker.
• Do NOT scrape the surface with sharp objects.
• Do NOT make unauthorized alterations to this product.
Listening music from external audio source
1.Power on the speaker.
2.Using the AUX Cable (φ3.5mm), connect your external
device to AUX-in port on speaker.
3.It will automatically turn to AUX-in mode, the LED
Indicator turns solid green.
Overvivew of Speaker
Charging
Battery Status
Music Control
BIuetooth connection
• 1 x Speaker
• 1 x Type-C charging Cable
• 1 x AUX Cable (Ф3.5mm)
• 1 x User Manual
Previous Song
Next Song
Light Mode
Play
Modes
Power on/off
Bluetooth LED Indicator
Battery LED Indicator
Pause/Play
Package Includes
2nd white light flashes
3rd white light flashes
Fully charged
Low battery (<20%)
Caution
Troubleshooting
Cannot connect with the device
Note: Under AUX-IN mode, skip songs are not workable.
Sound mode
Mode Change Button : Outdoor/Indoor
1.Before first time use, fully charge the built-in battery.
2.Connect the Type-C Cable (included) between
the Charging port on the speaker, and
a USB port on a computer or USB AC Adapter.
• Please check the following:
• The Bluetooth device supports A2DP profile
• The Speaker is within 10m from the device.
• The Speaker is in pairing mode, the LED indicator
blinking blue.
Note:
• When power on, the speaker automatically
reconnects to the last mobile device it was connected
to. (The speaker can memorize maximum of 8 paired
devices ).
• The speaker will automatically shut down after 10
minutes in pairing mode if no devices are paired for
power saving.
Make sure that the speaker is within 10 meters from
your mobile device,
1. Press button until hear a rising tone and the
Bluetooth LED Indicator fast blinking blue.
2. Go to the Bluetooth settings on your mobile
device, search and select “AIWA SB-X350P” from the list.
3. Once paired, the LED indicator turns blue.
Note: When the battery charge <5%, the speaker will
power off automatically.
Power On
Press button until hear a rising tone and the Bluetooth
LED Indicator light on.
Power Off
Press button until hear a descending tone and
the Bluetooth LED Indicator light off.Bluetooth Disconnection
TWS (True Wireless Stereo) Function
The TWS technology enables you to use two speakers
pairing via Bluetooth to create a wireless dual-channel
system to deliver true stereo sound effect.
TWS connection operation
1. Place the two speakers near each other (the distance
should not be over 10 meters).
2. Power on the two speakers, double click the
button
on one speaker as MASTER speaker (playback left
channel ), the LED indicator fast blinking Blue and gree
then the two speaker will pair to each other
automatically ( The other speaker will be as SLAVE
speaker and playback right channel )
3. Once paired, Master and slave speaker LED indicator
turn solid blue
Disconnect the TWS connection
No Sound
Poor sound quality
• Make sure the music volume is at audible level on both
your device and speaker.
• Make sure your device is successfully paired with the
speaker, the LED indicator turn solid blue.
Move the device closer to this Speaker or remove any
obstacle between them.
Just simple insert your TF card into the port, the speaker
can automatically turn to TF card reader mode, and play
the MP3 music store in the card.
TF card reader(micro SD card)
Battey LED Indicator
Double click “ ” mode button to change the sound
mode. The LED indicator slowly flash blue in outdoor
mode, and the LED indicator keep solid blue in indoor
mode.
Remark: This speaker's default mode is indoor.under the
USB disk and TF card mod, LED is green.
Volume Down/Volume Up
Charging port
USB card readerTF card reader
AUX input
Reset key
Press“ M ” mode button on one of the speaker until LED
Indicator fast blinking Blue to disconnect the TWS
connection.
Reset the speaker: lf the function buttons without
working, disconnect the charging cable, place a small
pin (<3mm) into the reset key and hold it for 2 seconds
until the LED light off.
Click ‘ ’ button to change the LED Lights modes.
1: Musical Pulse (Pulse from bottom to top)
2: Half-circle rotation (rotate with the rhythm of the music)
3: Full-Cyclic rotation (rotation speed is automatically
adjusted with the size of the music)
4: Flash rhythm (brightness flashes with the beats of the
music)
5: Musical Pulse (from the middle to the upper and lower
pulse)
6: Turn off the lights
LED lights Mode
Blinking Red (Sound
Prompts 3 times at 20%,
10%, and power off)
30% charged 1st white light flashes
30%-70% charged
70%-99% charged
3 solid white lights
56789
Press " M " button until the Bluetooth LED Indicator fast
blinking blue to disconnect the current connected device,
and go into new Bluetooth-paring mode.
Volume UP
Play/Pause
Next track
Previous track
Switch Bluetooth mode/Aux-in mode…………Click M
Click
Rotate the knob Clockwise
click
click
Volume DownRotate the knob Counterclockwise
Need help? Post your question in this forum.
Report abuse
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Aiwa SB-X350P at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Aiwa SB-X350P in the language / languages: English as an attachment in your email.
The manual is 1.09 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
