468276
25
Zoom out
Zoom in
Previous page
1/28
Next page
23
Installation of Indoor Unit
右后
4.
2.
3.
1.
1.
2.
Installation of Indoor Unit
The piping can be output from right, right rear, left
or left rear.
When routing the piping and wiring from the left
or right side of indoor unit, cut off the tailings
from the chassis when necessary(As shown in Fig.7)
Cut off tailing 1 when routing the wiring only;
Cut off tailing 1 and tailing 2 when routing
both the wiring and piping.
Take out the piping from body case; wrap the piping,
power cords, drain hose with the tape and then make
them pass through the piping hole. (As shown in Fig.8)
Hang the mounting slots of the indoor unit on the
upper hooks of the mounting plate and check if it is
firm enough. (As shown in Fig.9)
The installation site should be 250cm or more above
the floor.
Installation of Connection Pipe
Align the center of the pipe flare with the related valve.
Screw in the flare nut by hand and then tighten the
nut with spanner and torque wrench by referring to the
following:
NOTE: Connect the connection pipe to indoor unit at first and then to outdoor unit. Handle pi-
ping bending with care. Do not damage the connection
pipe. Ensure that the joint nut
is tightened firmly, otherwise, it may cause leakage.
Spanner
Torque
wrench
Piping
Taper nut
Indoor unit piping
Fig.9
Mounting
plate
Fixing hook
Mounting
plate
Right
Right rear
Fig.8
Left rear
Left
Fig.7
Tailing 1
Tailing 2
Finally wrap it
with tape
Gas side piping
insulation
Water drainage pipe
Liquid side
Piping insulation
Gas side piping
External connection
electric wire
Liquid side piping
(N·m)
Ф6
Ф 9.52
Ф 12
340
15~20
5~55
Ф 16 60~65
Ф 19 70~75
Hex nut diameter
Tightening torque
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Airlux GWH12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Airlux GWH12 in the language / languages: English as an attachment in your email.

The manual is 4,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info