729420
3
Zoom out
Zoom in
Previous page
1/8
Next page
In the event of power failure your appliance will become
inoperative. When the power is restored it will
automatically restart.
NOTE: REMEMBER TO NOTE THE SETTING OF THE
GAS VALVE CONTROL KNOB 2 PRIOR TO
EXTINGUISHING THE BURNER.
Turn the gas valve control knob clockwise to the off
position (see fig. A).
Frost Precautions
In the event of the cooker being switched OFF for long
periods during very cold weather, the advice of the Local
Gas Region or Authorised Distributor should be obtained.
CAUTION: BEFORE LIGHTING: ENSURE THAT THE
GAS VALVE CONTROL KNOB 2 IS SET IN THE OFF
POSITION. (SEE FIG. A) AND THE ELECTRICAL
SUPPLY TO THE AGA IS SWITCHED ON.
1. Turn on gas supply to cooker and open gas cock 1 at
the base of the gas valve.
2. Turn the gas valve control knob 2 anti-clockwise to the
position ( ) (see fig. B). Press down firmly
and hold
the knob in this position while depressing the piezo
ignitor 3 several times until the pilot has lit. This can be
observed through the viewing window. 4.
3. When the pilot has lit continue to hold the gas valve
control knob down for approx. 30 seconds. If it goes
out, wait three minutes and repeat the procedure
holding for a little longer.
4. With the pilot flame established, release the gas valve
control knob 2 gradually and rotate anti-clockwise to its
low fire position. Where upon the main burner will
automatically light. Leave in the low fire position for at
least 30 minutes.
NOTE: ANY ATTEMPT TO ROTATE THE CONTROL
KNOB BEFORE RELEASE MAY RESULT IN
DAMAGE.
5. After 30 minutes rotate the control knob further anti-
clockwise to the mid position in the green band for
normal running. (see fig. D).
NOTE: AFTER SEVERAL HOURS THE HEAT
INDICATOR SHOULD BE ON OR ABOUT THE CENTRE
OF THE SILVER SECTION. IT MAY BE NECESSARY
TO ADJUST THE CONTROL KNOB SLIGHTLY IN THE
GREEN BAND TO ACHIEVE THIS.
When the cooker is lit from cold, moisture may form on the
enamel which should be wiped off to prevent staining.
IF THE FLAME HAS EXTINGUISHED FOR WHATEVER
REASON, WAIT THREE MINUTES (MINIMUM)
BEFORE RE-LIGHTING.
NOTE: IF MAIN BURNER EXTINGUISHES
For safety purposes a flue safety device is fitted.
This will only operate in adverse flue conditions, and
electrical power failures. If this problem persists contact
your local engineer to determine and rectify the cause.
TO LIGHT THE BURNER
3
Fig.2
POWER FAILURE
OFF ON
DESN 510252 ‘A
TO EXTINGUISH THE BURNER
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aga GC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aga GC in the language / languages: English as an attachment in your email.

The manual is 0,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info