67
Water outlet hose connection
The end of the drain hose can be connected in the following ways:
1. To the sink outlet siphon, securing it if necessary with a clip.
2. Hooked over the edge of the sink using the special curved plastic guide provided.
3. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm.
The waste connection must be at a height of between 30 cm (minimum) and 100 cm
(maximum) from the bottom of the dishwasher.
The drain hose can face either to the right or left of the dishwasher
Ensure the hose is not bent or squashed as this could prevent or slow down the
discharge of water.
Extension hoses
The necessary extension hoses can be obtained from specialist shops or from our
technical assistance centres.
The extension hose must be no longer than 2 metres and its internal diameter must
be no smaller than the diameter of the hose provided.
Likewise the internal diameter of the couplings used for connection to the waste
outlet must be no smaller than the diameter of the drain hose.
Arrange the extension hose
horizontally along the floor and
allow it to rise only where it is
to be connected to the drain.
The sink plug must not be in
place when the machine is
draining as this could cause the
water to siphon back into the
machine.
